-
1
-
2
Performance Properties of Cement–Glass Composite Bricks (CGCB) with Additively Manufactured (AM) Polymeric Scaffolding
Published 2023-02-01Subjects: Get full text
Article -
3
Mechanical Properties Analysis of Explosive Welded Sheet of AA2519-Ti6Al4V with Interlayer of AA1050 Subjected to Heat-Treatment
Published 2022-06-01“…A tensile test was carried out with accompanying strain analysis by the digital image correlation (DIC) method. Moreover, the residual stresses were determined which were measured by using two methods, the X-ray diffraction and the hole drilling. …”
Get full text
Article -
4
Research on the Properties and Low Cycle Fatigue of Sc-Modified AA2519-T62 FSW Joint
Published 2020-11-01“…The investigation has involved microstructure observations, microhardness distribution analysis, tensile test with digital image correlation technique, observations of the fracture surface, measurements of residual stresses, low cycle fatigue testing, and fractography. …”
Get full text
Article -
5
Selective Laser Melted M300 Maraging Steel—Material Behaviour during Ballistic Testing
Published 2021-05-01“…This manuscript also contains some data based on structural analysis and tensile testing with digital image correlation. Based on the conducted research, M300 maraging steel was found to be a helpful material for some armour solutions after pre- or post-processing activities. …”
Get full text
Article -
6
Bending Strength of Polyamide-Based Composites Obtained during the Fused Filament Fabrication (FFF) Process
Published 2022-07-01“…To extend the scope of the research, additional digital-image-correlation tests and fracture analyses were made. …”
Get full text
Article -
7
Regeneration of the Damaged Parts with the Use of Metal Additive Manufacturing—Case Study
Published 2023-05-01“…Additionally, the use of digital image correlation (DIC) technology enabled the identification of the area where the largest deformation occurred during the tensile test, which was out of the connection zone between the two materials.…”
Get full text
Article -
8
Comparison of Different Heat Treatment Processes of Selective Laser Melted 316L Steel Based on Analysis of Mechanical Properties
Published 2020-08-01“…Finally, tensile tests were conducted using a digital image correlation (DIC) test and fracture analysis. …”
Get full text
Article -
9
A Comparative Study on Laser Powder Bed Fusion of Differently Atomized 316L Stainless Steel
Published 2022-07-01“…Finally, the test campaign covered an analysis of mechanical properties, including tensile testing with Digital Image Correlation (DIC) and Charpy’s impact tests. …”
Get full text
Article