-
1
Testing of composite slab-beam systems at elevated temperatures
Published 2013Get full text
Get full text
Conference Paper -
2
Explosion and temperature resistance of underground structures by free hexagons
Published 2013“…The dynamical influences have to be also emerged if extreme raise of temperature and explosion are involved in this problem; formulation is briefly mentioned and the results from numerical simulations are presented. …”
Get full text
Get full text
Journal Article -
3
Effect of elevated temperature on concrete structures by boundary elements
Published 2013“…Extreme elevation of temperature principally threatens tunnel linings and may cause fatal disaster; the recovery of it may take a long time and significant traffic troubles. …”
Get full text
Get full text
Journal Article -
4
Material and structural behaviour of steel and concrete structures at elevated temperatures
Published 2009“…Measurements of internal forces, lateral deflections, axial displacements and temperatures are reported. Twenty steel column specimens were subjected to elevated temperatures. …”
Get full text
Research Report -
5
Effect of elevated temperature and cooling process on the tensile strength of rock
Published 2014“…The experimental results had shown that the tensile strength of specimens would decrease when temperature increases. But the strength would vary for different cooling methods under a specific temperature. …”
Get full text
Final Year Project (FYP) -
6
N2O accumulation from denitrification under different temperatures
Published 2015“…More N2O accumulation was observed during denitritation at the higher temperature as compared with full denitrification and low temperature tests. …”
Get full text
Get full text
Journal Article -
7
Experimental and analytical studies of reinforced concrete short beams at elevated temperatures
Published 2022“…This paper presents an experimental and analytical programme conducted on a total of seven reinforced concrete (RC) short beams, including one test at ambient temperature and six others at elevated temperatures. …”
Get full text
Journal Article -
8
-
9
Room temperature reduction of graphene oxide by formic acid catalyzed by platinum nanoparticles
Published 2014“…Graphene oxide (GO) was reduced by stirring the solution contaning GO sheets with platinum (Pt) nanoparticles and formic acid at room temperature for 72 h. The resulting reduced graphene oxide-Pt (RGO-Pt) nanocomposites were characterized, and it was found that the Pt nanoparticles of size 4–6 nm were anchored onto the RGO sheets. …”
Get full text
Get full text
Journal Article -
10
Effect of spatial distribution of polymer fibers on preventing spalling of UHPC at high temperatures
Published 2021Get full text
Journal Article -
11
Combined effects of cyclic load and temperature fluctuation on the mechanical behavior of porous sandstones
Published 2021“…Rocks in cold regions tend to experience exacerbated degradation under the combined effects of environmental and anthropogenic factors, which may arise from, for example, temperature fluctuation, mechanical excavation, and blasting. …”
Get full text
Journal Article -
12
The impact of temperature on the metabolism of volatile fatty acids by polyphosphate accumulating organisms (PAOs)
Published 2021Subjects: Get full text
Journal Article -
13
Curvature and temperature sensor based on anti-resonant effect combined with multimode interference
Published 2022Subjects: Get full text
Journal Article -
14
High-temperature reverse osmosis and molecular separation with robust polyamide-ceramic membranes
Published 2024“…Polyamide thin-film composite (TFC) membranes are widely used for reverse osmosis (RO), but most commercial RO membranes have a limited operating temperature of <45 °C. This has constrained the broader applications of RO in industries, where process and water feeds with high temperature >50 °C are common. …”
Get full text
Journal Article -
15
Structural behavior of CHS T-joints subjected to brace in-plane bending at elevated temperatures
Published 2013“…Within the range of investigated parameters, at 700◦C, the joint strength was only 8.40 kNm while at ambient temperature, it was 43.25 kNm. Furthermore, at high temperature, there was a change in the failure modes of the joints. …”
Get full text
Get full text
Conference Paper -
16
An evaluation of internal defects and their effect on trunk surface temperature in Casuarina equisetifolia L. (Casuarinaceae)
Published 2015“…The effectiveness of determining internal tree stem condition by measuring trunk surface temperatures with infrared cameras was assessed in this study. …”
Get full text
Get full text
Get full text
Journal Article -
17
Shear behavior of fiber-reinforced concrete hollow-core slabs under elevated temperatures
Published 2022“…The verified FE models were then used to investigate web-shear mechanism of PCHC slabs exposed to fire. It is shown that temperature-induced tensile stresses in concrete webs (instead of temperature-induced reduction in strength of concrete and strands) governed web-shear behavior of PCHC slabs under elevated temperatures.…”
Get full text
Journal Article -
18
Thermal properties of carbon nanofibers enhanced lightweight cementitious composite under high temperature
Published 2022“…Dehydration reaction at isothermal elevated temperature was characterised for the analysis of experimental results. …”
Get full text
Journal Article -
19
Boundary continuity effect on performance of composite beam-slab sub-assemblages at elevated temperature
Published 2022Subjects: Get full text
Journal Article -
20