Showing 1 - 20 results of 221 for search '"temperature"', query time: 0.09s Refine Results
  1. 1

    Ultrasonic sectorial inspection in the presence of temperature gradients by Mateus Yamada Müller, Tatiana de Almeida Prado, Thiago Estrela Kalid, Thiago Alberto Rigo Passarin, Daniel Rodrigues Pipa

    Published 2023-08-01
    “…Optimal linear approximation parameters are determined offline from a controlled Full Matrix Capture (FMC) test, in which the setup consists of a phased array transducer, a high-temperature resistant wedge and an aluminium test block with flaws at known positions. …”
    Get full text
    Article
  2. 2

    Temperature and geometry impact on defect detection and sizing by Jana Veselá, Pavel Mareš, Jaroslav Brom

    Published 2023-08-01
    “…The measurement was done within a temperature range of 50°C to 200°C in increment of 50°C. …”
    Get full text
    Article
  3. 3
  4. 4

    High Temperature Characterization of the Stiffness Matrix of Different Steels by Arno Volker, Mikael Malmström, Anton Jansson, Bevis Hutchinson, Johan Lönnqvist, Hans Sollander, Frenk Van Den Berg

    Published 2023-08-01
    “…Several samples; AISI 304, interstitially free, low carbon, martensite, and pearlite, were measured in a Gleeble® Thermal-Mechanical Simulator 3800 in conjunction with LUS (GLUS®) during annealing from room temperature up to a maximum temperature in the range between 675 and 1000 °C. …”
    Get full text
    Article
  5. 5

    High Temperature Magnetic Properties of Selected Steel Grades by John W. Wilson, Lei Zhou, Fanfu Wu, Frenk Van Den Berg, Haibing Yang, Claire Davis, Anthony J Peyton

    Published 2023-08-01
    “…However, if the data produced by these systems is to be fully exploited it is necessary to accurately measure the magnetic properties of steel grades of interest at temperatures up to the Curie point. This work details measurements carried out to assess the magnetic properties of selected steels grades, supplied by Tata Steel, up to the Curie temperature using a novel test rig based on a modified Epstein frame designed by the University of Manchester with high temperature trials at the University of Warwick. …”
    Get full text
    Article
  6. 6

    Modeling of temperature scenarios in a multicore processor system by E. Glocker, D. Schmitt-Landsiedel

    Published 2013-07-01
    “…In a multicore system a reciprocal influence between the temperatures of neighbouring cores occur leading to increasing core temperature compared to a single core. …”
    Get full text
    Article
  7. 7
  8. 8

    Safe storage guidelines for soybeans at different temperatures and moisture contents by Tang, Fang, Ouyang, Yi, Qi, Zhihui, Zhang, Haiyang

    Published 2018-11-01
    “…The safe storage conditions (temperature, moisture content, duration) were estimated by means of a curve fitted using the power function fitting. …”
    Get full text
    Article
  9. 9
  10. 10
  11. 11

    Temperature-Controlled in-situ Tensile Tests of Polymer Tape with Single Particles by Sarah Heupl, Julia Maurer, Johann Kastner

    Published 2023-08-01
    “…Depending on the application area of the polymer, temperatures can be very high or low – leading to a different performance compared to room temperature. …”
    Get full text
    Article
  12. 12

    Temperature variation linked to trellis height: an opportunity for adaptation to climate change? by Laure de Rességuier, Philippe Pieri, Théo Petitjean, Séverine Mary, Cornelis van Leeuwen

    Published 2023-08-01
    “… Temperature is a key factor in vine growth and grape composition (Jones, 2006). …”
    Get full text
    Article
  13. 13

    Impact of negative and positive bias temperature stress on 6T-SRAM cells by S. Drapatz, G. Georgakos, D. Schmitt-Landsiedel

    Published 2009-05-01
    “…With introduction of high-k gate oxide materials, the degradation effect <i>Positive Bias Temperature Instability</i> (PBTI) is starting to play an important role. …”
    Get full text
    Article
  14. 14
  15. 15

    Development of HOIS guidance for ultrasonic NDT for non-intrusive inspection at elevated temperatures by Helen Peramatzis, Steve Burch

    Published 2023-08-01
    “…The HOIS joint industry project, with support from the Net Zero Technology Centre (NZTC), has recently been focussing on NII of components with operating temperatures of up to 250°C (typical of upstream applications). …”
    Get full text
    Article
  16. 16
  17. 17

    Calculations of Temperature and Thermo-Elastic Displacement Distributions Generated by Laser-Ultrasonic Inspection System by Alex Karpelson

    Published 2024-02-01
    “… Calculations of temperature and thermo-elastic displacement distributions generated by laser-ultrasonic inspection system are performed. …”
    Get full text
    Article
  18. 18

    Reliable non-destructive detection and characterization of material degradation caused by high-temperature corrosion by Sebastian Barton, Niklas Steinbrecher, Hans Jürgen Maier

    Published 2023-08-01
    “…The testing technique combines the use of temperature-resistant sensors and a variation of the component temperature in a wide range. …”
    Get full text
    Article
  19. 19

    Chilling temperature and low moisture content to keep soybean grain quality during storage by Rigueira, Roberta J. A., Filho, Adilio F. Lacerda, Lazzari, Flavio A., Marques, Kaio K. M., Coelho, Marcelo P.

    Published 2018-11-01
    “…To evaluate the effect of MC and temperature on the quality parameters of soybean seeds, samples were stored at 58±2% RH, with five different MCs, at 15 °C (chilling temperature) and 30 °C (average temperature inside silos in Brazil) for 180 days. …”
    Get full text
    Article
  20. 20

    Effect of temperature-humidity index on the evolution of trade-offs between fertility and production in dairy cattle by Aurélie Vinet, Sophie Mattalia, Roxane Vallée, Christine Bertrand, Anne Barbat, Julie Promp, Beatriz C. D. Cuyabano, Didier Boichard

    Published 2024-03-01
    “…Conclusions Within the range of weather conditions studied, increasing temperatures are not expected to exacerbate the fertility-production trade-off. …”
    Get full text
    Article