-
1
Structural and Optical Characteristics of Carboxymethylcellulose / Polyacrylic Acid Polymer Blend
Published 2021-12-01“…FESEM image for CMC/ PAA film showed the formation of small spherical grains for PAA into CMC that insured the existence of some peaks in XRD pattern of PAA in CMC film which means the improvement of the microstructure of the polymer matrix. …”
Get full text
Article -
2
Preparation and Antibiofilm Properties of Zinc Oxide/Porous Anodic Alumina Composite Films
Published 2018-07-01“…After being modified by Si69, the ZnO films translate from hydrophilia to hydrophobicity. The ZnO/PAA film with the optimal antibiofilm properties is prepared on the PAA surface by two-step anodization for 40 min. …”
Get full text
Article -
3
Cholesteric Liquid Crystal Photonic Hydrogel Films Immobilized with Urease Used for the Detection of Hg<sup>2+</sup>
Published 2022-04-01“…We demonstrate a simple and low-cost method for the detection of Hg<sup>2+</sup> assisted by a cholesteric liquid crystal photonic hydrogel (polyacrylic acid (PAA)) film with immobilized urease (CLC-PAA<sub>urease</sub> film). …”
Get full text
Article -
4
Highly Sensitive and Selective Surface Acoustic Wave Ammonia Sensor Operated at Room Temperature with a Polyacrylic Acid Sensing Layer
Published 2022-08-01“…The oxygen-containing functional groups on the surfaces of the PAA film make it sensitive and selective to ammonia molecules, even when tested at room temperature. …”
Get full text
Article -
5
Water-Absorbing Bioadhesive Poly(Acrylic Acid)/Polyvinylpyrrolidone Complex Sponge for Hemostatic Agents
Published 2022-12-01“…First, PAA solution was dried up in a vessel to form a film. The PAA film was then immersed in an aqueous PVP solution to obtain a highly swollen PAA/PVP hydrogel. …”
Get full text
Article -
6
Storage stability of vitamin C fortified purple mashed potatoes processed with microwave-assisted thermal sterilization system
Published 2023-04-01“…MATS processing caused a significant increase (P < 0.05) in the oxygen transmission rates (OTRs) of PAA pouches but did not affect the barrier properties of TLMO pouches. PAA film also had a significantly higher (P < 0.05) water vapor transmission rate (WVTRs) than TLMO films, which resulted in a significantly higher (P < 0.05) weight loss in the samples packaged in PAA pouches than TLMO pouches. …”
Get full text
Article -
7
Bismuth nanowire and antidot array studies motivated by thermoelectricity
Published 2005Get full text
Thesis -
8
-
9
Electropolymerization of acrylic acid on steel for enhanced joining by plastic deformation
Published 2024-06-01“…Interestingly, higher maximum shear force values are obtained for the PAA films when Zn metallic deposits are not present in the organic layer, but, when these welded specimens are heated up to 200 °C in a N2 atmosphere, it occurred exactly the opposite: Zn particle-containing PAA films showed the highest maximum shear force values for the same deposition time.…”
Get full text
Article -
10
A Sandwich Porous Alumina Nanostructures Based on Anodic Alumina
Published 2010-05-01“…A sandwich porous anodic alumina membrane (PAA/Al/PAA) films was producedusing two-step anodization approach on both sides of (250) μm pure aluminum foilelectrode as an anode. …”
Get full text
Article -
11
-
12