Application of pressure-sensitive paint to low-speed flow around a U-bend of strong curvature by Quinn, M, Gongora-Orozco, N, Kontis, K, Ireland, P

“…This study investigates the surface pressure distribution around a U-bend of sharp curvature with three different inlet velocities: 29.7, 21.5 and 12.0ms-1. …”

Measurements of hypersonic double cone flows with shock wave/boundary layer interactions in the X3 expansion tunnel by Kennedy, A, McGilvray, M, James, CM, Morgan, RG, Zander, F

“…The data presented is a full transient set of surface heat flux, and surface pressure measurements along the axial length of the model as well as a full suite of tunnel data. …”

Computational Analysis Of Incompressible Viscous Flow Over Single And Multi-Element Airfoils by El-Sayed, Omer Ali

“…Computed results for the studied cases were compared with experimental data in terms of surface pressure and lift coefficients which show reasonable agreement. …”
Get full text

The Influence of a Blade-Guiding Fin on the Pneumatic Performance of an Axial-Flow Cooling Fan by Hengtao Shu, Haizhou Chen

“…The main external flow characteristics of the cooling fan, the blade surface pressure distribution, the static pressure efficiency and the fan power were obtained and compared. …”
Get full text

Synoptic Survey of Floods Caused by Heavy Rainfall of 4 February 2006 in the Lorestan Basin

“…The results show that three factors exist floods damage; low surface pressure in this area, located west wind advection on ground low pressure and adaptation of left output shaft of  subtropical Jet-Stream on advection of westerly winds are the main cause of the flood in this basin. …”
Get full text

Degradation Behavior of Poly(Lactide-Co-Glycolide) Monolayers Investigated by Langmuir Technique: Accelerating Effect by Gayeon Kim, Vishal Gavande, Vasi Shaikh, Won-Ki Lee

“…Alkaline hydrolysis was strongly affected by their hydrophilicity, while the surface pressure of monolayers for enzymatic degradations was a major factor.…”
Get full text

STUDY OF THE SYNOPTIC SITUATION THAT FAVOR THE FREEZING RAIN IN NORTHWESTERN TRANSYLVANIA by NATALIA URBAN

“…To determine the average barrel near the ground rules have been used geopotential fields at 1000 hPa and the surface pressure field. Field analysis was also done at ground level pressure and temperature throughout the air column. …”
Get full text

Performance of Overset Mesh in Modeling the Wake of Sharp-Edge Bodies by Suyash Verma, Arman Hemmati

“…The flow past a pitching square panel is also investigated at two Reynolds numbers. The study of surface pressure distribution and shear forces acting on the panel suggests that a higher streamwise pressure gradient exists for the high Reynolds number case, which leads to an increase in lift, whereas the highly viscous effects at low Reynolds number lead to an increased drag production. …”
Get full text

Predicting Pressure Sensitivity to Luminophore Content and Paint Thickness of Pressure-Sensitive Paint Using Artificial Neural Network by Mitsugu Hasegawa, Daiki Kurihara, Yasuhiro Egami, Hirotaka Sakaue, Aleksandar Jemcov

“…The present approach of applying ANN and the data augmentation has the potential to predict pressure-sensitive paint (PSP) characterizations that improve the performance of PSP for global surface pressure measurements.…”
Get full text

Tensiometric and Thermodynamic Study of Aliphatic and Aromatic Amine in Aqueous D-Glucose Solutions: A Comparative Study by Shadma Tasneem

“…The experimental data investigated by this study were utilized to evaluate various interfacial parameters, including surface pressure, surface excess concentration, and other thermodynamic parameters of surface assembly, which are discussed in terms of solute–solvent and solute–solute interactions. …”
Get full text

The Study of Stress State in Indentation of a Flat Punch with Rounded Edge in Axisymmetric Backward Extrusion by Ban Bakir Alamer

“…Analytical solution have to obtained of contact problem for indentation of flat punch with rounded edges in axi symmetric extrusion to both surface pressure and interior stress fields for a given die shape at different velocity fields. …”
Get full text

Aerological observations in the Tropics in the Early Twentieth Century by Stefan Brönnimann, Alexander Stickler

“…We compare the observed wind profiles with corresponding profiles extracted from the (“Twentieth Century Reanalysis(”, which provides global three-dimensional weather information back to 1871 based on an assimilation of sea-level and surface pressure data. The comparison shows a good agreement at the coast but less good agreement further inland, at the shore of Lake Victoria, where the circulation is more complex. …”
Get full text

Characterization of Marangoni Forced Convection in Casson Nanoliquid Flow with Joule Heating and Irreversibility by Muhammad Adil Sadiq, Tasawar Hayat

“…Marangoni forced convection depends on the differences in surface pressure computed by magnetic field, temperature, and concentration gradient. …”
Get full text

Design guidelines of surface texturing to improve lubrication characteristics under reciprocating motion by Tetsuta MATSUMURA, Toshikazu FUJINO, Tatsuhiro JIBIKI, Katsumi IWAMOTO, Masaki ODA

“…The effects of texturing are compared with those of no texturing under various operating conditions as determined from the sliding speed, viscosity coefficient of the lubricant, and surface pressure, and the placement and dimensions of the texturing that result in lower friction are evaluated. …”
Get full text

Warmer Antarctic summers in recent decades linked to earlier stratospheric final warming occurrences by Hyesun Choi, Hataek Kwon, Seong-Joong Kim, Baek-Min Kim

“…The trend toward earlier stratospheric final warming appears to play a considerable role in warmer summers over parts of interior Antarctica through the strengthening of the anti-cyclonic surface pressure anomaly. This could influence the regional sea-ice modulation over the Southern Ocean.…”
Get full text

Evaluation of a displacement-body model for hypersonic shock-wave/boundary-layer interaction by Lopez, Lee (Lee Gabriel)

Get full text

Modelling chorded prosthetic mitral valves using the immersed boundary method. by Watton, P, Luo, X, Singleton, R, Wang, X, Bernacca, G, Molloy, P, Wheatley, D

“…In addition, an external surface pressure may be applied to the leaflets, thus enabling the deformations that arise under steady loads to be solved. …”

AN OPERATIONAL DATA ASSIMILATION SCHEME FOR THE MARTIAN ATMOSPHERE by Lewis, S, Read, P

“…It is, however, capable of analysing any asynoptic, randomly-distributed dataset, which may include surface pressure, temperature, velocity or constituent data originating either from other past or future spacecraft missions or from models. …”

Mixing characteristics in a hypersonic flow around a transpiration cooled flat plate model by Hermann, T, Ifti, H, McGilvray, M, Doherty, L, Geraets, R

“…A flat plate model is used which is equipped with a gas injection system, four surface mounted heat flux gauges and three surface pressure sensors located downstream of the injection point. …”

The influence of sorbitol on the adsorption of surfactants at the air-liquid interface by Staples, E, Thompson, L, Tucker, I, Penfold, J, Thomas, R, Lu, JR

“…The addition of 300 g/liter of sorbitol to an aqueous solution of C12E6 reduces the critical micellar concentration, cmc, from ~7 x 10-5 to ~3 x 10-5 M, and increases the surface pressure at the cmc; the effect on the C12E3/SDS mixture is less. …”