-
8201
Wheat leaf epidermal pattern as a model for studying the influence of stress conditions on morphogenesis
Published 2018-11-01“…Subsequently, these data can be used for verification of computer models of leaf morphogenesis. Further study of the mechanisms of the effect of cold stress on morphogenesis will add to the search for additional opportunities to increase wheat yields in areas of risky agriculture.…”
Get full text
Article -
8202
Design, modeling and research of the new non-autonomous chaotic generator
Published 2019-06-01“…For realization of nonlinearity use only one bipolar power source for the opamp is enough. Results of computer modelling and simulation using MultiSim, i.e. the volt-ampere characteristic (VAC) at certain values of the components of the scheme's nominal values, is presented. …”
Get full text
Article -
8203
Evaluation of Indoor Thermal Environmental Conditions of Residential Buildings in Saudi Arabia
Published 2022-02-01“…Two main methods used to evaluate indoor thermal conditions are physical measurements and computer modelling. Instruments were used to monitor the house during both summer and winter months. …”
Get full text
Article -
8204
Analytical Model with Independent Control of Load–Displacement Curve Branches for Brittle Material Strength Prediction Using Pre-Peak Test Loads
Published 2022-10-01“…Fracture mechanics methods continue to be developed, which, combined with numerical methods of computer modeling, are implemented in software packages. …”
Get full text
Article -
8205
The Dynamic Characteristics of Railway Portal Frame Bridges: A Comparison between Measurements and Calculations
Published 2024-02-01“…We propose a conservative estimation of the frequency range influenced by the shear wave interference of the SSSI and recommend using it as an application limit in the development of computational models. Based on this estimation, a <span style="font-variant: small-caps;">Calculation Model</span> is presented. …”
Get full text
Article -
8206
Numerical simulation study on impact factors to dynamic filtration loss
Published 2024-01-01“…In this study, we simulated the dynamic filtration loss of drilling fluid during drilling under formation conditions using commercial software CMG (Computer Modelling Group). The effects of filtration time, filtrate viscosity, pressure difference, internal filter cake permeability, and external filter cake permeability on filtration loss were investigated. …”
Get full text
Article -
8207
A Hierarchical Framework for Day-Ahead Optimal Operation Planning of Active Distribution Networks with Multi-Microgrids
Published 2023-05-01“…The present paper proposes a hierarchical (master-slave problem) computational model to achieve optimal coordinated operation of multi-microgrids connected to an I. …”
Get full text
Article -
8208
Testing and Evaluation of Flexural Tensile Strength of Prestressed CFRP Cables
Published 2022-10-01“…Then, bending tensile tests were conducted to evaluate the effects of the above factors on the ultimate tensile strength, and the correctness of the computational model was verified using experiments. Finally, the ultimate performance of CFRP cables was theoretically predicted using the established model. …”
Get full text
Article -
8209
Transport institutions and organisations in the formulation of policies for Australian local area traffic management: A 50-year retrospectiveFootnotes
Published 2023-10-01“…A review of 115 studies on Australian local area traffic management (LATM) schemes covers network planning, computer modelling, overall design considerations, the deployment of various traffic control devices, project evaluation and numerous before and after case studies. …”
Get full text
Article -
8210
Influence of the Shrinkage of the Inner Layer of Steel Tubes on Permissible Thermal Load
Published 2024-02-01“…In 30HN2MFA steel, the shrinkage effect occurred at a temperature of approx. 750 °C, while in X37CrMoV5-1 steel it occurred at a temperature of approx. 870 °C. In the computational model, 30 cross-sections of the three-meter-long tube were analyzed. …”
Get full text
Article -
8211
Finite Element Study of PEEK Materials Applied in Post-Retained Restorations
Published 2022-08-01“…Background: This study aimed to investigate the biomechanical behaviors of polyether ether ketone (PEEK) and traditional materials (titanium and fiber) when used to restore tooth defects in the form of prefabricated post or customized post via computational modelling. Methods: First, the prototype of natural tooth, and the prototypes of prefabricated post and customized post were established, respectively, whilst the residual root was restored with dentin ferrule using reverse engineering methods. …”
Get full text
Article -
8212
Universal Bond Models of FRP Reinforcements Externally Bonded and Near-Surface Mounted to RC Elements in Bending
Published 2024-01-01“…In addition, the concrete–FRP connection is divided into zones and the current phase and length of each zone are determined, allowing for more detailed analysis of the connection at different load stages. The proposed computational model and its derivation focus on the performance of the joint between the two cracks and the distribution of the shear stresses in that joint. …”
Get full text
Article -
8213
Probabilistic calibration of a Greenland Ice Sheet model using spatially resolved synthetic observations: toward projections of ice mass loss with uncertainties
Published 2014-09-01“…Computer models of ice sheet behavior are important tools for projecting future sea level rise. …”
Get full text
Article -
8214
Mindfulness training reduces slippery slope effects in moral decision-making and moral judgment
Published 2023-02-01“…In contrast, for the Training group, mindfulness training prevented moral preferences from declining. Computational modeling revealed that mindfulness training specifically reduced the increase in the weights of money over time in both the decision-making and judgment tasks, thereby curbing the “slippery slope” effects. …”
Get full text
Article -
8215
Classification-Based Regression Models for Prediction of the Mechanical Properties of Roller-Compacted Concrete Pavement
Published 2020-05-01“…Overall, the proposed methodology formed a reliable soft computing model that can be implemented for material engineering, construction, and design.…”
Get full text
Article -
8216
ParaStell: parametric modeling and neutronics support for stellarator fusion power plants
Published 2024-04-01“…The three-dimensional variation inherent to stellarator geometries and fusion sources motivates three-dimensional modeling to obtain accurate results from computational modeling in support of design and analysis of first wall, blanket, and shield (FWBS) systems. …”
Get full text
Article -
8217
PERSPECTIVES OF THE METHODS DEVELOPMENT FOR AIRCRAFT MAINTAINABILITY CERTIFICATION
Published 2018-08-01“…The kinds of requirements within the aviation regulations and means of compliance for them are recommended, which have to be corrected and developed, as well as directions of works necessary for that, including implementation of computer modelling and prototypes testing for showing compliance of aircraft with the maintainability certification requirements. …”
Get full text
Article -
8218
Numerical simulation analysis of the solid-liquid coupling process in a hybrid landslide: A case study of the Wushanping landslide
Published 2022-12-01“…A two-phase coupled computational model based on the SPH method is proposed. …”
Get full text
Article -
8219
Contribution of Somatic and Dendritic SK Channels in the Firing Rate of Deep Cerebellar Nuclei: Implication in Cerebellar Ataxia
Published 2016-01-01“…Methods: In this study, multi-compartment computational model of DCN was used. This computational stimulation allowed us to study the changes in the firing activity of DCN neuron without concerns about interfering parameters in the experiment. …”
Get full text
Article -
8220
Bio-activity prediction of drug candidate compounds targeting SARS-Cov-2 using machine learning approaches.
Published 2023-01-01“…The ChEMBL and PubChem database contains experimental data from screening small molecules against SARS-CoV-2 3CLpro, which expands the opportunity to learn the pattern and design a computational model that can predict the potency of any drug compound against coronavirus before in-vitro and in-vivo testing. …”
Get full text
Article