Deep bedrock geothermal resources in the Maichen Sag, Beibuwan Basin and their potential for exploitation and utilization by Yan Zeng, Ying Zhang

“…Factors such as deep geo-temperature, thermophysical properties of rocks, and terrestrial heat flow values, were integrated into this quantitative evaluation of geothermal resources through the geological modeling-based volume method and the geothermal reservoir engineering-based numerical simulation method. …”
Get full text

Autonomous quantum error correction and fault-tolerant quantum computation with squeezed cat qubits by Qian Xu, Guo Zheng, Yu-Xin Wang, Peter Zoller, Aashish A. Clerk, Liang Jiang

“…Abstract We propose an autonomous quantum error correction scheme using squeezed cat (SC) code against excitation loss in continuous-variable systems. Through reservoir engineering, we show that a structured dissipation can stabilize a two-component SC while autonomously correcting the errors. …”
Get full text

OPTIMIZATION STUDY OF GATE OPERATION RULE IN CIAWI DAM AS FLOOD CONTROL FUNCTION

“…This research data is based on climatological data, low discharge data, flood hydrograph, and dam and reservoir engineering data. In addition, there are supporting data to perform calculations and analyzes, such as flood discharge data, elevation curve – reservoir volume and layout of the dam and its complementary buildings, existing operating patterns, and regional socio-economic data studies. …”
Get full text

A method for evaluating resource potential and oil mobility in liquid-rich shale plays—An example from upper Devonian Duvernay formation of the Western Canada Sedimentary Basin by Zhuoheng Chen, Chunqing Jiang, Julito Reyes, Xiaojun Liu, Edward Little

“…This paper discusses methods of assessing oil and gas resources and evaluating their mobility in shale reservoirs using programed pyrolysis data in conjunction with reservoir engineering parameters derived from production data. …”
Get full text

Production evolution patterns and development stage division of waterflooding oilfields by Bingyu JI, Ting XU, Xingjun GAO, Hongmin YU, He LIU

“…With the new model, the statistical correspondence between the production decline stage and the reserve-production imbalance is clarified, and the correlation of water cut with the recovery percent of recoverable reserves is discussed, providing quantitative basis of reservoir engineering for dividing development stages of oilfield and defining mature oilfields. …”
Get full text

The impact of viscoelastic nanofluids on the oil droplet remobilization in porous media: An experimental approach by Mobaraki Sina, Tabatabaee Hamid, Torkmani Reza Shiri, Khalilinezhad Seyed Shahram, Ghorashi Saeed

Get full text

Geomechanical analysis of formation deformation and permeability enhancement due to low-temperature CO2 injection in subsurface oil reservoirs by Ilyas Khurshid, Yoshiaki Fujii

“…However, the correlated reservoir-engineering problems with low-temperature CO2 injection including formation damage and leakage risk are still uncertain and has not been comprehensively investigated. …”
Get full text

Quantum-state engineering in cavity magnomechanics formed by two-dimensional magnetic materials by Chun-Jie Yang, QingJun Tong, Jun-Hong An

“…Compared with previous schemes, ours does not require any extra nonlinear interaction and reservoir engineering and is robust against the thermal fluctuation. …”
Get full text

Thermomechanics for Geological, Civil Engineering and Geodynamic Applications: Numerical Implementation and Application to the Bentheim Sandstone by Jacquey, Antoine B., Regenauer-Lieb, Klaus, Cacace, Mauro

“…The impacts of the multiscale and poromechanical behavior of geomaterials are relevant for a number of applications ranging from civil engineering, reservoir engineering, geological and geodynamic. The use of thermodynamic-consistent approaches to construct constitutive laws which span a large range of time scales is particularly relevant in this context. …”
Get full text

GIS application in oil and gas exploration & production activities based on past experience by Abd. Latef, Mohd. Zukhairi, Mahmud, Mohd. Razali

“…Subsurface data produced are inclusive of seismic, well, drilling and reservoir engineering data. Seismic data consists of seismic sections, seismic navigation, seismic shot-points maps, bathymetry data, velocity, etc. …”
Get full text

Deterministic tools to predict gas assisted gravity drainage recovery factor by Maryam Hasanzadeh, Mohammad Madani

“…Although, GAGD is known as one of the most effective recovery methods in reservoir engineering, the lack of available simulation and mathematical models is considerable in these kinds of reservoirs. …”
Get full text

A Comparison of Machine Learning Approaches for Prediction of Permeability using Well Log Data in the Hydrocarbon Reservoirs by Mohsen Talebkeikhah, Zahra Sadeghtabaghi, Mehdi Shabani

“…Permeability is a vital parameter in reservoir engineering that affects production directly. Since this parameter's significance is obvious, finding a way for accurate determination of permeability is essential as well. …”
Get full text

Fractal-Based Approaches to Pore Structure Investigation and Water Saturation Prediction from NMR Measurements: A Case Study of the Gas-Bearing Tight Sandstone Reservoir in Nanpu S... by Weibiao Xie, Qiuli Yin, Jingbo Zeng, Guiwen Wang, Cheng Feng, Pan Zhang

“…It provides a valuable scientific resource for reservoir engineering and petrophysics of unconventional reservoir types, such as tight sandstone, low porosity, and low permeability sandstone, shale, and carbonate rock reservoirs.…”
Get full text

Influence of Stress Anisotropy on Petrophysical Parameters of Deep and Ultradeep Tight Sandstone by Hui Zhang, Ke Xu, Binxin Zhang, Guoqing Yin, Haiying Wang, Zhimin Wang, Chao Li, Shujun Lai, Ziwei Qian

“…Rock mechanics parameters control the distribution of in situ stress and natural fractures, which is the key to sweet spot evaluation in reservoir engineering. Combined with the distribution of in situ stress, an experimental scheme of stress on rock physical parameters was designed. …”
Get full text

Application of the modified capacitance-resistance method to model reservoir pressure maintenance by Ali Lesan, Reza Shams, Peyman Pourafshary, Abbas Bahrodi, Hosna Rastkerdar

Get full text

Application of CO2 miscible flooding in ultra-low permeability beach-bar sand reservoir by Sen Yang, Sen Yang, Yangmengzhe Xu, Zhiwei Huang, Qunshuang Zhang, Ting Liu, Xuelei Li

“…According to the geological characteristics of the reservoir in the CL area of the Dongying Sag, the reasonable reservoir engineering parameters and surface injection procedures for the CO2 flooding have been formulated. …”
Get full text

INFLUENCE OF PRESSURE ON POROSITY–PERMEABILITY RELATIONSHIP IN SOUTHERN NIGER DELTA, NIGERIA by Chukwu C. Ben, Ngeri A. Paddy, Udota S. Benjamin

“…The results of this work can be used as an evaluation tool for reservoir engineering activities, structural engineering, well stability analysis, blowout and lost circulation prevention…”
Get full text

A study of the water resources management and division of the groundwater heat pump system construction in Anyang by Wenju ZHU, Jianhua PING, Junshan HOU, Yiwu NING, Wenbin GENG

Get full text

Relevance of analytical Buckley–Leverett solution for immiscible oil displacement by various gases by Aleksandr Zhuravljov, Zakhar Lanetc

“…To accomplish the goals of this research, the comparative analysis between the injection of compressible and incompressible gases was undertaken using the numerical solution of the correspondent reservoir engineering problems. The validation of the numerical model was performed showing that it matches the analytical Buckley–Leverett solution. …”
Get full text

Machine-Learning-Based Approach to Optimize CO₂-WAG Flooding in Low Permeability Oil Reservoirs by Ming Gao, Zhaoxia Liu, Shihao Qian, Wanlu Liu, Weirong Li, Hengfei Yin, Jinhong Cao

“…In this study, a numerical model of the CO₂-WAG technique was developed using the reservoir numerical simulation software CMG (Version 2021), which is widely used in the field of reservoir engineering. Then, 10,000 different reservoir models were randomly generated using the Monte Carlo method for numerical simulations, with each having different formation physical parameters, fluid parameters, initial conditions, and injection and production parameters. …”
Get full text