-
461
An Optimal Tradeoff between Entanglement and Copy Complexity for State Tomography
Published 2024Get full text
Article -
462
Ultra-thin bulk silicon thinning of advanced microprocessors & graphics processors fabricated in Sub-20 nm technology
Published 2020“…In particular, initial fault isolation techniques exploit infrared laser beams to probe the circuitry through silicon thinned mechanically to 50 um. …”
Get full text
Thesis-Master by Research -
463
Nanotwins-containing microstructure and superior mechanical strength of a Cu‒9Al‒5Fe‒5Ni alloy additively manufactured by laser metal deposition
Published 2021“…The nanotwins were formed at the interface of the plate-like β* phase, which was induced by the low stacking fault energy of the alloy and high cooling rate of LMD. …”
Get full text
Journal Article -
464
Dynamical and statistical properties of anyons in fractional quantum hall effect
Published 2024“…The latter prop- erty makes it a subject of immense interest due to application in fault-tolerant quantum computing. Here, we employ a perspective that anyons are the appro- priate degree of freedom to describe the relevant physics of FQH systems. …”
Get full text
Thesis-Doctor of Philosophy -
465
Preventing interreligious conflict : lessons from the ambivalence of the sacred and Singapore
Published 2019“…Viewed from the lens of Samuel Huntington and Philip Jenkins, religion appears destined to be a major fault line causing instability in a clash of civilizations. …”
Get full text
Thesis -
466
Does mental fatigue affect performance in racket sports? a systematic review
Published 2024“…Six studies revealed that mental fatigue impacts stroke performance in table tennis, affecting speed, accuracy, faults, and only second-serve accuracy in tennis. …”
Get full text
Article -
467
Seismic attenuation tomography from 2018 Lombok earthquakes, Indonesia
Published 2021“…A low P-wave quality factor (low-Qp), low P-wave velocity (Vp), and high ratio of P-wave velocity and S-wave velocity (Vp/Vs), which coincide with a shallower earthquake (<20 km) northwest of Lombok Island, might be associated with a brittle area of basal and imbricated faults influenced by high fluid content. At the same time, the high-Qp, low Vp, and low Vp/Vs, which coincide with a deeper earthquake (>20 km) northeast of Lombok Island, might be associated with an area that lacks fluid content. …”
Get full text
Journal Article -
468
Comparative spatial predictions of the locations of soil-rock interface
Published 2021“…The spatial trend of the geological interface cannot be captured by the polynomial regression method with a relatively high (i.e., 10) order of the polynomial when faults and folds exist. Advantages of the spline regression method over the conditional random field methods include that (i) it provides a clear and explicit spatial trend of the SRI, which well reflects the geological complexity of the sites; (ii) it avoids the cumbersome estimation of random field parametric values, which is a challenging task under the condition of limited data; and (iii) it can differentiate the zones with different prediction accuracies, which cannot be accomplished by the conditional random field method due to limited data. …”
Get full text
Journal Article -
469
Thermal performance enhancement of eutectic PCM laden with functionalised graphene nanoplatelets for an efficient solar absorption cooling storage system
Published 2021“…The f-GNP dispersions accelerate the heat storage process with a maximum decrease of 17.3% in the total melt duration. In addition, the role of increased viscosity on the natural convection is simultaneously studied with the increased thermal conduction due to nanoplatelets dispersions.…”
Get full text
Journal Article -
470
Rapid characterization of graded alloys fabricated by 3D printing
Published 2023“…However, Cu is highly reflective to the laser commonly used in 3D printing, which makes it challenging to be fully melted and then fabricated without evident defects. …”
Get full text
Final Year Project (FYP) -
471
Role of Sm3+ ions as network-modifying on elastic, mechanical, and radiation shielding properties of MgO–B2O3–TeO2 glasses
Published 2023“…A series of samarium doped magnesium borotellurite glass with empirical formula (60-)TeO2–30B2O3–10MgO– (Sm2O3) was produced via melt-quenching technique, with x is varied to 0.0, 0.5, 1.0, 2.0 and 3.0 mol. …”
Get full text
Article -
472
Insights from coral microatolls into sea-level variability and subduction zone behavior
Published 2024“…We use forward elastic dislocation models to determine potential causative faults that could produce vertical deformation seen in the coral record. …”
Get full text
Thesis-Doctor of Philosophy -
473
Fabrication and properties of oxide semiconductor nanowires
Published 2016“…At last, we report the growth of kinked single-crystalline In2O3 nanostructures consisting of nanocone base and nanowire tip connected without any twin boundaries or stacking faults. During the tailored growth, when the diameter of gold catalyst nanoparticle at the apex of the nanocone shrunk to ~100 nm as a result of the gold atom migration, the growth direction switched from [111] to either [110] or [112], depending on the growth conditions. …”
Get full text
Thesis -
474
Model predictive control for converters in hybrid AC/DC microgrid part II
Published 2019“…Besides maximizing the use of the clean energy resources, microgrids also can operate in islanding mode should grid failures and fault occur. Renewable energy system integration into power systems connected to the grid have proved to be difficult because of the challenges it comes with. …”
Get full text
Final Year Project (FYP) -
475
Monitoring and control of AC power distribution board through sound card-based SCADA system
Published 2014“…The protection of ACPDB is achieved by setting reference values in LabVIEW and LabVIEW send control signal to hardware in the event of fault.…”
Get full text
Thesis -
476
Health monitoring, lifetimes estimation, and thermal management of IGBT-based power converters
Published 2017“…This methodology protects a power devices from over current and short circuit current, and isolates the fault current from the rest of the system. The proposed short-circuit detection and protection circuit is compared with conventional gate-voltage clamping method, and results show that the proposed method aids in the soft shutdown of the IGBT, and considerably reduces the fault current and power dissipations compared to the conventional method.…”
Get full text
Thesis -
477
Investigating the inner controls on explosive eruptions using textural analyses and petrology
Published 2022“…I find that sudden decompression-induced crystallization of the matrix due to important undercooling of the melt plays a major role in promoting mafic magma fragmentation and generating mafic PDCs. …”
Get full text
Thesis-Doctor of Philosophy -
478
Strain rate, temperature, and their coupled effects on the deformation process of four polycarbonates and a short glass fibre reinforced polycarbonate composite
Published 2023“…This research presents the thermomechanical responses of four polycarbonate resins: three are homo-polycarbonate with different melt flow rates, one is co-polycarbonate with impact-modified co-monomer; another one is polycarbonate-based short glass fibre composite. …”
Thesis -
479
History dependence of the microstructure on time-dependent deformation during in-situ cooling of a nickel-based single-crystal superalloy
Published 2019“…Between 1000 °C and 900 °C, stress relaxation prevails and gives rise to softening as evidenced by a decreased dislocation density and the presence of long segment stacking faults in γ phase. Lattice strains decrease in both the γ matrix and γ′ precipitate phases. …”
Get full text
Get full text
Journal Article -
480
High sensitivity transparent glass ceramic systems development based on MgSO4:Dy2O3–B2O3 and MgSO4:Dy2O3–B2O3:ZnO:An investigation of FT-IR and thermal properties for thermolumines...
Published 2024“…Two series of glass ceramics, [(MgSO4)86(Dy2O3)14]x[B2O3]1-x with x = 0.1, 0.2, 0.3, 0.4, 0.5 and [MgSO4-Dy2O3–B2O3]0·2[ZnO]x with x = 0.05, 0.1, 0.15, 0.2, were successfully prepared using the melt quenching technique. The synthesized samples were characterized using X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR), field emission scanning electron microscopy (FE-SEM), and differential thermal analysis (DTA). …”
Get full text
Get full text
Article