Showing 161 - 180 results of 844 for search '(((((pingka OR spinka) OR tinggal) OR (inche OR sspine)) OR pine) OR (spinn OR (pin OR min)))', query time: 0.08s Refine Results
  1. 161

    Characterisation of surface texture using AFM with trimmed probe tip by Ali, Mohammad Yeakub, Lim, BengHai

    Published 2006
    “…A comparison of the scanning results with analytical calculation showed that the trimmed tips were superior in imaging the profile for both the hole shaped and pin shaped microfeatures. But when using the trimmed high aspect ratio tip, the scanning speed was significantly low. …”
    Get full text
    Article
  2. 162

    Distraction osteogenesis over intramedullary nail : a report of two cases by Sulaiman , Razak, Munajat, Ismail, Yaakub, Ismail, Awang, Mohd Shukrimi

    Published 2006
    “…The healing index was 19.5 days/cm and 14.8 days/cm respectively, compared favorably to 30 days/cm with traditional method of distraction osteogenesis. There were mild pin tract infections and joint stiffness which responded to non-operative treatment.…”
    Get full text
    Article
  3. 163

    A study on abrasive water jet machining of aluminum with garnet abrasives by Khan, Ahsan Ali, Munajat, Noraziaty, Tajudin, Harnisah

    Published 2005
    “…The feed rate of the work should be kept within 40 rum min- I (at the jet pressure of 30 h i and the stand-off distance of3 mm). because a feed rate beyond 40 mm min-I results in sharp increase in taper angle. …”
    Get full text
    Article
  4. 164

    Adsorption behaviour of manganese (Mn2+) removal from aqueous solution using carbon nanotubes by Kabbashi, Nassereldeen Ahmed, Mirghani, Mohamed Elwathig Saeed, Y., Farhana I.

    Published 2010
    “…Different pHs are pH 6.0, pH 6.5, pH 7.0, pH 7.5 and pH 8.0, CNT dosages are 5mg, 6.25mg, 7.5mg, 8.75mg or 10mg, contact time are 10 min, 32.5 min, 55 min, 87.5 min and 120 min while the agitation speeds are 100rpm, 150rpm, 200rpm, 250rpm and 300rpm. …”
    Get full text
    Proceeding Paper
  5. 165

    Efficacy of Malaysian plant extracts in preventing peroxidation reactions in model and food oil systems by Jaswir, Irwandi, Hassan, Torla, Mohd Said, Mohd Zaki

    Published 2004
    “…This was followed by the extracts of limau purut leaves (85 min), peels (60 min), and stems (39 min). The antioxidative activities of these plants, however, were lower than those of rosemary and sage. …”
    Get full text
    Article
  6. 166

    Effects of flux application and melting parameters in investment casting of pure aluminium by in-situ melting technique by Saleh, Aslinda

    Published 2018
    “…The aluminium granules then were heated at the temperature of 850oC for 30 min in argon environment at the flow rate of argon gas 0.5, 2.5 and 5 l/min to reduce the oxidation of the aluminium granules. …”
    Get full text
    Thesis
  7. 167

    Kesan pembelajaran berasaskan masalah terhadap motivasi pelajar dalam mata pelajaran kemahiran hidup by Jasman, Kamal

    Published 2014
    “…Namun begitu, nilai skor min motivasi keseluruhan Kumpulan Rawatan adalah lebih tinggi daripada Kumpulan Kawalan. …”
    Get full text
    Get full text
    Get full text
    Thesis
  8. 168

    Oxidative behaviour of four Malaysian edible plant extracts in model and food oil systems by Jaswir, Irwandi, Octavianti, Fitri, Hendri, Ridar, ., Elmi, Khatib, Alfi

    Published 2012
    “…This was followed by the extracts of Chinese cabbage (80 min), “kucai” (60 min), and “kesom” (40 min). The antioxidative activities of these plants, however, were lower than those of rosemary and sage. …”
    Get full text
    Article
  9. 169

    Pembangunan modul pembelajaran kendiri pendidikan alam sekitar bagi pelajar sekolah menengah by Ramli, Azuin

    Published 2003
    “…sf;ca/ Packages For socz'a/ & f e / : c e j (SP-S^ i^er^zoH 77.0 yang melibatkan skor min, peratus dan ujian t. Dapatan kajian menunjukkan kesesuaian isi kandungan modul (skor min= 3.19), kesesuaian aktiviti (skor min = 3.18), tahap keboiehiaksanaan (skor min = 3.17) dan ciri-ciri mesra pengguna (skor min = 3.20) adaiah pada tahap yang tinggi. …”
    Get full text
    Get full text
    Get full text
    Thesis
  10. 170

    Extraction and characterisation of pectin from dragon fruit (hylocereus polyrhizus) peels by Abang Zaidel, Dayang Norulfairuz, Md Rashid, Jamaeyah, Hamidon, Nurul Hazirah, Md. Salleh, Liza, Mohd Kassim, Angzzas Sari

    Published 2017
    “…Pectin from dragon fruit peels was determined as low methoxyl pectin and has high percentage of antioxidant activity with low value of inhibition concentration (IC50) (0.0063 to 0.0080 mg/mL). 60 min extraction sample exhibits the highest antioxidant activity (81.91 % at 40 μg/mL), followed by 80 min extraction (81.68 % at 40 μg/mL), 40 min extraction (81.38 % at 40 μg/mL) and 20 min extraction (81.31 % at 40 μg/mL).…”
    Get full text
    Article
  11. 171

    The potential of effective microorganism (EM) inclusion in enhancing the properties of cement paste and concrete by Ismail, Noorli

    Published 2019
    “…Furthermore, the high compressive strength and low porosity also leading to improve the internal densification of cement matrix which reported the formation of calcium silicate hydrate (CSH) and ettringite by detecting from formation of bundle shape and needles like pine leaves, acicular, thin, narrow and pointed shape, respectively at later age of 28 days and 60 days using scanning electron microscopy (SEM). …”
    Get full text
    Thesis
  12. 172

    Experimental evaluation of new pipe sleeve with weep holes for concrete leakage prevention by Wan Nazri, Wan Muhammad Hafizuddin

    Published 2018
    “…As a result, the weep-holes angle of 60° with 10% weep-holes surface area has recorded the highest water infiltration rate and water flow rate out of the mortar with 20.898 ml/min and 3.764 ml/min, respectively, obtaining the highest reduction of the moisture content by 3.1%. …”
    Get full text
    Get full text
    Get full text
    Thesis
  13. 173

    Kesediaan tenaga pengajar UTHM dalam melaksanakan Program 2u2i (2 tahun universiti, 2 tahun industri) by Puat, Nurul Azwa

    Published 2019
    “…Secara keseluruhannya, hasil analisis data menunjukkan bahawa tahap kesediaan tenaga pengajar dalam aspek pengetahuan (min=2.83), kemahiran (min=3.43), sikap (min=3.53) dan sumber (min=3.13) adalah pada tahap yang sederhana. …”
    Get full text
    Get full text
    Get full text
    Thesis
  14. 174

    A study on removal characteristics of (Mn2+) from aqueous solution by CNT by Ahmed Kabashi, Nassereldeen, Muyibi, Suleyman Aremu, Mirghani, Mohamed Elwathig Saeed, Yahya, Farhana I.

    Published 2009
    “…Different pHs are pH 6.0, pH 6.5, pH 7.0, pH 7.5 and pH 8.0, CNT dosages are 5mg, 6.25mg, 7.5mg, 8.75mg or 10mg, contact time are 10 min, 32.5 min, 55 min, 87.5 min and 120 min while the agitation speeds are 100rpm, 150rpm, 200rpm, 250rpm and 300rpm. …”
    Get full text
    Article
  15. 175

    The impact of intrapartum pethidine on the neonatal outcome. a prospective review by Husin, Roziah, Abdulwahab, Dalia F, Busu Rerah, Ruqaiah, Ismail, Rozihan, Awang, Mokhtar

    Published 2012
    “…All neonates delivered with good Apgar Score, 8 at 1 min and 9 at 5 min. A total of nine (22.5%) cases were admitted to the Neonatal Intensive Care Unit (NICU). …”
    Get full text
    Article
  16. 176

    Fabrication and characterisation of Cobalt Chromium Molybdenum (CoCrMo) foams using slurry method by Ab Manaf, Nur Suliani

    Published 2018
    “…This was followed by the appropriate sintering temperature results which were 1000°C, 1100°C and 1200°C with heating rate of 1.5°C/min, 1.0°C/min and 0.5°C/min. Moreover, for the soaking time factor, the relevant durations were 60, 90 and 120 minutes. …”
    Get full text
    Get full text
    Get full text
    Thesis
  17. 177

    Physical, mechanical and environmental properties of fired clay bricks incorporated with palm oil mill waste by Sarani, Noor Amira

    Published 2019
    “…However, lower heating rate (1°C/min) should be considered to attain excellent properties of brick. …”
    Get full text
    Get full text
    Get full text
    Thesis
  18. 178

    Design and Implementation of Active Antennas for IoT-Based Healthcare Monitoring System by MUSA, UMAR, MOHD SHAH, SHAHARIL, A. MAJID, HUDA, MAHADI, ISMAIL AHMAD, A. RAHIM, MOHAMAD KAMAL, YAHYA, MUHAMMAD SANI, ZAINAL ABIDIN, ZUHAIRIAH

    Published 2024
    “…Two dual-band (2.4 GHz and 5.8 GHz) microstrip patch antennas, one with a PIN diode and one without, are fabricated using Rogers Duroid RO3003™ substrate. …”
    Get full text
    Article
  19. 179

    Design and Implementation of Active Antennas for IoT-Based Healthcare Monitoring System by MUSA, UMAR, MOHD SHAH, SHAHARIL, A. MAJID, HUDA, AHMAD MAHADI, ISMAIL, A. RAHIM, MOHAMAD KAMAL, YAHYA, MUHAMMAD SANI, ZAINAL ABIDIN, ZUHAIRIAH

    Published 2024
    “…Two dual-band (2.4 GHz and 5.8 GHz) microstrip patch antennas, one with a PIN diode and one without, are fabricated using Rogers Duroid RO3003™ substrate. …”
    Get full text
    Article
  20. 180

    Design and Implementation of Active Antennas for IoT-Based Healthcare Monitoring System by MUSA, UMAR, MOHD SHAH, SHAHARIL, A. MAJID, HUDA, MAHADI, ISMAIL AHMAD, A. RAHIM, MOHAMAD KAMAL, YAHYA, MUHAMMAD SANI, ZAINAL ABIDIN, ZUHAIRIAH

    Published 2024
    “…Two dual-band (2.4 GHz and 5.8 GHz) microstrip patch antennas, one with a PIN diode and one without, are fabricated using Rogers Duroid RO3003™ substrate. …”
    Get full text
    Article