-
381
Effect of heating rates on the microstructure and gas permeation properties of carbon membranes
Published 2018“…High performance tubular carbon membrane (TCM’s) for CO2 separation were prepared by controlling the carbonization heating rates in range of 1-7 oC/min carbonized at 800 oC under Argon environment. …”
Get full text
Article -
382
Choice of gDNA isolation method has a significant impact on average murine Telomere Length estimates
Published 2024“…We demonstrate that TL measurements, from murine gDNA, isolated via Spin Columns (SC) and Magnetic Beads (MB), generate significantly smaller T/S ratios compared to gDNA isolated via traditional phenol/chloroform methods. …”
Get full text
Article -
383
Organic-inorganic PTAA-SiGe transparent optical materials performance analysis for photo device applications
Published 2024“…To investigate the electrical performance of SiGe active materials based photo device, the spin coated organic p-materials contact is developed on sputtered SiGe on Quartz and ITO glass substrates. …”
Get full text
Article -
384
Organic-inorganic PTAA-SiGe transparent optical materials performancem analysis for photo device applications
Published 2024“…To investigate the electrical performance of SiGe active materials based photo device, the spin coated organic p-materials contact is developed on sputtered SiGe on Quartz and ITO glass substrates. …”
Get full text
Article -
385
Novel opto-electronic and plastic fibre sensors
Published 1998“…Non-linearities in the form of a spike are shown to exist in the very short ranges resulting in a minimum operational range of about 15 nun Beyond this minimum range the sensor response is linear and depends on the reflectivity of the target, the accuracy of calibration between the two detectors, any offset voltage present in any of the detectors, possible errors on the detected signals and the X, separation which in principle can be used to scale the sensor. …”
Get full text
Thesis -
386
Evaluating the Brexit and COVID-19’s influence on the UK economy: A data analysis
Published 2023“…For instance, the unemployment rate displayed a downward trend until 2020 but experienced a spike in 2021, persisting for a six-month period. …”
Get full text
Article -
387
Biosorption of Pb and Cu from aqueous solution using banana peel powder
Published 2016“…The effects of concentration and contact time on peel extract, the maximum adsorption for Pb has shown at 4 mg/L at 120 min for BPPU and was 6 mg/L at 150 min for BPPT. …”
Get full text
Get full text
Article -
388
-
389
Kualiti pengalaman pembelajaran pelajar-pelajar kejuruteraan di KUiTTHO dari aspek kognitif dan afektif
Published 2004“…Dapatan kajian menunjukkan kualiti keseluruhan pengalaman pembelajaran pelajar-pelajar kejuruteraan di KUiTTHO adalah pada tahap sederhana (skor min = 3.55). Bagi kualiti pengalaman pembelajaran dari aspek kognitif dan afektif adalah pada tahap sederhana (skor min = 3.48 dan 3.61 masing-masing). …”
Get full text
Get full text
Get full text
Thesis -
390
Silicon carbide powder mixed micro electro discharge milling of titanium alloy
Published 2011“…A multi criteria optimization on low Ra, high MRR and low EWR has been achieved which showed 2.68 µm Ra., 6.908 µg/min MRR and 1.518 µg/min EWRfor the input parameters of 15.42 g/l SiC powder concentration and 54.28 µJ discharge energy. …”
Get full text
Article -
391
Optimization of the conditions for extraction of serine protease from Kesinai plant (Streblus asper) leaves using Response Surface Methodology
Published 2011“…The most desirable conditions of 2.5 °C temperature, 4 min mixing time, 40 mL buffer at pH 7.5 was established for serine protease extraction from kesinai leaves.…”
Get full text
Article -
392
Investigation of vibration and surface roughness in micro milling of PMMA
Published 2012“…The optimum solution for minimum average vibration is 64.3 Hz with spindle speed 3000 rpm, feed rate 2 mm/min, and depth of cut 1.5 μm. However, the optimum solution for minimum average surface roughness, Ra is 0.352 μm with spindle speed 2000 rpm, feed rate 2 mm/min, and depth of cut 1.5 μm. …”
Get full text
Article -
393
Acid blue 25 adsorption on base treated Shorea dasyphylla sawdust: kinetic, isotherm, thermodynamic and spectroscopic analysis
Published 2012“…The optimum conditions for AB 25 adsorption were pH 2, stirring rate 500 r/min, adsorbent dosage 0.10 g and contact time 60 min. …”
Get full text
Article -
394
Treatment of biotreated palm oil mill effluent using powdered activated carbon produced from palm empty fruit bunch
Published 2013“…Powdered Activated Carbon (PAC) was produced from empty fruit bunch (EFB) precursors by CO2 activation at 800¬0C, N2 (2.5 L/min) for 30 mins and CO2 (0.1L/min) for 15 mins. …”
Get full text
Proceeding Paper -
395
Capabilities of cermets tools for high speed machining of austenitic stainless steel
Published 2006“…In the present work cermet tools coated with titanium nitride were used to turn austenitic stainless steel at speeds between 300 and 700 m min-1. Feed rates were varied between 0.05 to 0.4 mm rev-1. …”
Get full text
Article -
396
Pembangunan video dokumentari pendidikan bagi mata pelajaran teknologi konkrit
Published 2004“…The data was analyzed using statistic method from Statistical Packages for Social Sciences (SPSS) version 11.0 which include percentages, min score and standard devition. Research result are positif that is the min score for each item from section B exceeding 3.8. …”
Get full text
Get full text
Get full text
Thesis -
397
Rare presentation of burholderia psedomallei infection
Published 2007Get full text
Proceeding Paper -
398
Dissecting sperm mitochondrial G-quadruplex structures using a fluorescent probe biomarker to monitor and regulate fertilization capability
Published 2023“…To monitor the levels of mitochondrial DNA G-quadruplexes (mtDNA G4s) in spermatozoa and to explore the possibility using mtDNA G4s as a reliable marker in patients with multiple clinical insemination failures, a novel chemical TPE-mTO probe engineered in our previous work was used on both samples from the mice sperm and from patients with fertilization failure. …”
Get full text
Article -
399
Bayesian random forests for high-dimensional classification and regression with complete and incomplete microarray data
Published 2018“…As a further extension, missing covariates problem was also handled by pre-imputing the variables using Multivariate Imputation by Chain Equation (MICE) before building forests. Performance analysis was achieved using simulated and eighteen real-life classification and regression microarray cancer datasets. …”
Get full text
Get full text
Get full text
Thesis -
400
The production of carbon nanotubes using two-stage chemical vapor deposition and their potential use in protein purification
Published 2011“…The statistical analysis reveals that the optimum conditions for the CNT production were reaction temperature of 850 ◦C, reaction time of 60 min and gases flow rates of 40 and 150 ml/min for C2H2 and H2, respectively. …”
Get full text
Article