-
441
Non-invasive measurement method of skin conditions by using Dermalab® combo
Published 2014“…The readings were taken on volar forearm of the volunteers were taken using TEWL probe and hydration pin probe. A set of questionnaire was also distributed to obtain the information about the skin care regime and their daily habits. …”
Get full text
Proceeding Paper -
442
Providing feedback for students' drafts in academic writing: can developmental Rubric do the trick?
Published 2015“…Teachers were able to specifically pin-point the areas where students needed to improve their academic writing. …”
Get full text
Proceeding Paper -
443
Formation of Fe-C-Si ternary composite coating on CP-titanium and its tribological interaction with Jatropha oil
Published 2016“…The wear behavior of coated CP-titanium was performed using pin-on-disk machine at room temperature under Jatropha-biodiesel lubricated condition. …”
Get full text
Proceeding Paper -
444
A Novel MIMO antenna integrated with a solar panel and employing AI-equalization for 5G wireless communication networks
Published 2024“…We demonstrate that the directivity of this antenna array can be precisely electronically reconfigured using PIN diode switches. Additionally, we show the feasibility of integrating solar panels with the proposed MIMO antenna array. …”
Get full text
Get full text
Article -
445
Design of microstrip ultra wide band antenna with two notch filters for wireless communication
Published 2015“…In order to add reconfigurable characteristics to the patch antenna, two copper strips are putted on the slots to represent the ON and OFF switching status of an ideal Pin diode. By using this simple switching technique, the current distribution of the patch changes and enables the antenna to have four modes of operation. …”
Get full text
Get full text
Get full text
Thesis -
446
Theoretical analysis of photoparametric amplifier
Published 2010“…The second method is to use Optiwave software in implement is the photo parametric amplifier circuit. Photo diode PIN type has been used to detect any coming signal at the receiver circuit. …”
Get full text
Get full text
Get full text
Thesis -
447
An empirical assessment of business cycle asymmetries: evidence from Malaysia
Published 2010“…We find strong evidence of steep asymmetry but not deep sharp asymmetry for Malaysia which is in contrast to the findings of Khong and Lau (2007) and Eng and Wang (2008). These findings have important implications for econometric modeling and policy making.…”
Get full text
Article -
448
-
449
-
450
-
451
-
452
-
453
A comparative study between turbulence model RSM results of a dual inlet cyclone separator and k-epsilon RNG turbulence model
Published 2023“…The research evalute the results of Wang et al. 's (Chern Eng Process Intensification 158:108188, [2]) dual :intake cyclODe separator (known as 90° DI CyclODe) with a 7, 10, and 12 Jtm particle diameter and inlet velocity 15.5 m/s. …”
Get full text
Conference or Workshop Item -
454
Words and facts: children's fast mapping, retention and extension
Published 2015“…It has been researched primarily in the field of word learning and evidence suggests that a pre-school child can link a novel word with its referent and retain this link up to 1 month later (e.g. …”
Get full text
Thesis -
455
Identification of a novel method for differentiating human monocytic cell line into macrophages
Published 2020“…This research developed a method for producing macrophage-like cells under conditions that may stimulate in vivo using a monocytic cell (THP-1) and a human liver cell (HUH7). …”
Get full text
Thesis -
456
RC circuit response
Published 2011“…Also, besides being a charge storage element, capacitor is like a delay element too with a time constant given by r=RC…”
Get full text
Book Chapter -
457
Women involvement in dry fish value chain approaches towards sustainable livelihood
Published 2012“…It points out that the sample women are involved in different income generating activities like drying, sorting and grading, cleaning and salting. …”
Get full text
Article -
458
-
459
A statistical approach for the prediction of cutting forces in end milling of medium carbon steel (S45C)
Published 2008Get full text
Proceeding Paper -
460