-
561
Finishing of wire electric discharge machined surface
Published 2016“…However, the formation of recast layer on the structure surface during fabrication greatly reduces the fatigue strength of the structure and also induces micro cracks and tensile residual stress into the surface. …”
Get full text
Thesis-Master by Coursework -
562
Ada apa dengan Tahun Baharu 2025
Published 2025“…Tahun baharu merupakan detik di mana kita membuka lembaran baru dalam hidup dan maju ke hadapan setapak lagi. …”
Get full text
UMPSA News -
563
Effective process of commercialization at the research institutions in Malaysia.
Published 2023Get full text
Article -
564
Songket Tenun: Pengesahan Konsep (S/O: 14817)
Published 2021“…Songket tenun ini mempunyai potensi yang tinggi dimana produk baru Songket tenun Sintok dan Kedah kepada pasaran tempatan dan antarabangsa. …”
Get full text
Monograph -
565
Impact resistance of reinforced concrete members
Published 2015“…Lastly, one of the test specimens has an added engineered cementitious composite (ECC) protective layer. This protective layer was added to demonstrate its ability to act as a sacrificial layer to protect the concrete. …”
Get full text
Final Year Project (FYP) -
566
Characteristics of scanning curves of two soils
Published 2011“…The first slope model consisted of a fine sand layer overlying a gravelly sand layer, while the second slope model involved a silty sand layer overlying a gravelly sand layer. …”
Get full text
Get full text
Journal Article -
567
Wave propagation in coastal waters
Published 2015“…To do so, a laboratory model was used with the bottom mud as a viscoelastic layer and the top water column using tap water. A material known as Polydimethylsiloxane (PDMS) was used to model the bottom mud layer. …”
Get full text
Final Year Project (FYP) -
568
Analysis of hydraulic conductivity of tropical peat soil on sand and clay substratum in Pesisir Selatan, West Sumatra
Published 2024“…Notably, AWP in the sand substratum layer was lower (22.50%vol) than in the clay substratum layer (30.53%vol). …”
Get full text
Article -
569
Studies on plasma assisted molecular beam epitaxial growth of GaN-based multilayer heterostructures on Si for photodetector application
Published 2019“…Importantly, it has been confirmed that SiNx layer acts as a blocking layer for Ga/Si diffusion across the AlN layer. …”
Get full text
Get full text
Thesis -
570
Scene text detection using neural network
Published 2019“…In this project, we tend to first of all introduce some relevant ideas. we tend to describe the selective search technique used for region proposal, and also the compositions of building blocks of convolutional neural network (CNN) that embrace convolutional layer, pooling layer, corrected linear units (ReLU), fully-connected layer and loss layer. we tend to detail the method of information set preparation that consists of data assortment, information labelling and format transformation, that is taken into account as vital preparation work for coaching method.The core part of this project is that the institution of the scene text detection system from the module style to the model testing and validation.…”
Get full text
Final Year Project (FYP) -
571
A theoretical insight into the use of anti-reflective coatings for the upliftment of sensitivity of surface plasmon resonance sensors
Published 2021“…With 40 nm of gold, 3 layers of Titania (9 nm) and a layer of Silica (3 nm), our simulation results predict a sensitivity of 214 deg/RIU at 532 nm, which is a major improvement when compared to other sensor structures.…”
Get full text
Journal Article -
572
Fabrication of high-performance thin-film composite and nanochannel-enabled next-generation membranes for water desalination
Published 2023“…Because the performance of a composite membrane is determined by both the support and active layer, it was attempted to scrutinize the nanoscale characteristics of the polyamide active layer that determine the separation capabilities of TFC membranes (Chapter 5). …”
Get full text
Thesis-Doctor of Philosophy -
573
Deposition and characterisation of a diamond/Ti/diamond multilayer structure
Published 2024“…For the latter, a hydrogen gas diluted with PH3 precursor recipe produced smaller nanocrystalline diamond crystals for the top layer. The titanium layer in between the two diamond layers possesses a very-fine-grained microstructure. …”
Get full text
Journal Article -
574
Beam heating explains critical current suppression measured during ion irradiation of REBCO tapes
Published 2024“…In this paper, we show that Ic suppression is independent of atomic displacement rate in the REBCO layer, the latter of which increases twelve-fold as we reduce the beam energy from 2400 to 800 keV. …”
Get full text
Article -
575
Nanostructured materials for electrochemical carbon dioxide reduction and biosensing
Published 2021“…Third, Ag nanorods with build-in nanogaps are fabricated by using our ultrasonic nanoimprinting after depositing alumina sacrificial layer and Ag layer on the substrate by e-beam evaporation. …”
Get full text
Thesis-Doctor of Philosophy -
576
Machine learning hardware accelerator for single-event-latchup (SEL) and micro-SEL detection in commercial-off-the-shelf (COTS) systems
Published 2024“…Logarithmic and linear quantization strategies are thereafter proposed to process the weights in the LSTM layer and fully connected (FC) layer, respectively. …”
Get full text
Thesis-Master by Coursework -
577
THE ART OF AFFILIATE MARKETING /
Published 2024“…Buku ini bertujuan memberikan anda pengetahuan dan pendidikan sebelum anda bermula sebagai affiliate yang sekali gus memanfaatkan peluang yang ditawarkan oleh dunia digital saat ini. Sama ada anda baru berjinak-jinak dalam bidang ini ataupun sedang mencari cara untuk mengoptimumkan pendapatan affiliate anda, panduan ini menjadi sumber ilmu yang berharga. …”
text -
578
Effects of polyemitter crystal structure on the gain of a double poly bipolar transistor
Published 2008“…It was demonstrated that the common emitter current gain of bipolar transistors could be improved by replacing the emitter metal contact by a highly doped polysilicon layer. A number of works, both theoretical and experimental, investigating this effect, have been published. …”
Get full text
Thesis -
579
Electrospinning a small diameter tubular scaffold for tissue engineering blood vessels
Published 2011“…In this work, the aim was to fabricate a bilayered nanofibrous scaffold (I.D<6mm) using the electrospinning technique. The first layer would be aligned longitudinally and the second layer aligned circumferentially. …”
Get full text
Final Year Project (FYP) -
580
Development of graphene and its electrochemical characteristics
Published 2011“…In this project, a simple yet inexpensive method is used to fabricate graphene layers. A Ni/C/p-Si tri-layer stack was fabricated when diamond-like carbon (DLC) or amorphous carbon layer was deposited onto Si/SiO2 substrate followed by Ni layer sputtered onto the carbon layer. …”
Get full text
Final Year Project (FYP)