-
481
Cost investigation of multihoming-based scheme to support mobility management in NEMO
Published 2016“…Moreover, a longer time is required to complete inter Handoff for mobile environment,which may cause performance degradation for the applications are mainly Voice over IP (VoIP), video streaming that running on Mobile Network Nodes (MNNs). …”
Get full text
Get full text
Article -
482
Development of Quran reciter identification system using MFCC and neural network
Published 2016“…Currently, the Quran is recited by so many reciters with different ways and voices. Some people like to listen to this reciter and others like to listen to other reciters. …”
Get full text
Get full text
Article -
483
-
484
A novel downlink semi-persistent packet scheduling scheme for VoLTE traffic over heterogeneous wireless networks
Published 2017“…This paper investigates Voice over LTE (VoLTE) Quality of Service (QoS) under a heterogeneous wireless communication scenario. …”
Get full text
Article -
485
Inclusive participatory design of bespoke music instruments and auxiliary access equipment, as emancipatory arts interventions advocating for equality and wellbeing
Published 2019“…Demonstrating benefits that arise through inclusive participation, the research facilitates expression of voice by disabled, non-verbal and marginalised participants whose contribution works to increase social awareness and equal rights; and toward their self-emancipation as designers and musicians. …”
Get full text
Thesis -
486
A qualitative exploration into how UK Pakistani male immigrants deal with personal problems and stresses in everyday life
Published 2012“…The current study hopes to address these particular gaps in the research. It seeks to give voice to a small, homogenous sample of first-generation Punjabi Pakistani men in order to gain a richer understanding of their coping experiences and how these influence their views and feelings about seeking psychological support. …”
Get full text
Thesis -
487
The utilisation of peer-assisted learning/mentoring and translanguaging in higher education
Published 2022“…In response to the need for more information, as regards the use of PALM activities and TRL with multilingual learners, this study intends to contribute student voice since the inclusion of learner opinion has been minimal. …”
Get full text
Article -
488
Optimization of supercritical carbon dioxide extraction of bioactive flavonoid compounds from spearmint (Mentha Spicata l.) leaves by using response surface methodology
Published 2012“…The optimal conditions were identified as 209.39 bar pressure, 50.00 °C temperature and 7.39 g/min co-solvent amount. The obtained extract under optimum SC-CO2 condition was analysed by high-performance liquid chromatography. …”
Get full text
Get full text
Article -
489
Optimization of ultrasound-assisted extraction of crude oil from winter melon (Benincasa hispida) seed using response surface methodology and evaluation of its antioxidant activity...
Published 2012“…Optimal conditions were identified as 65% power level, 52 °C temperature and 36 min sonication time for maximum crude yield (108.62 mg-extract/g-dried matter). …”
Get full text
Article -
490
Photocatalytic decomposition of acetaldehyde gas on TiO2-SiO2 thin film photocatalyst ― a kinetic analysis
Published 2013“…It is found that the first order reaction rate constant (k) of the TF95/5 thin film photocatalyst (1.2438 µmol dm-3 min-1) is higher than that of TF90/10 thin film (0.3648 µmol dm-3 min-1). …”
Get full text
Article -
491
Supercritical carbon dioxide extraction of oil from Thunnus tonggol head by optimization of process parameters using response surface methodology
Published 2013“…Total oil was extracted from ground fish head of Longtail tuna (Thunnus tonggol) using supercritical carbon dioxide (SC-CO2) at 20 to 40 MPa, 45 to 65 oC and 1 to 3 ml min−1. Response surface methodology (RSM) was employed to optimize the operating conditions of the SC-CO2 technique where the highest oil yield was obtained (35.6% on dry weight basis) at 40 MPa, 65 oC, and 3 ml min−1. …”
Get full text
Article -
492
Dry machining of brass using titanium carbonitride (TiCN) coated tool
Published 2013“…The optimum cutting condition for wet and dry machining of brass using TiCN coated cutting tool was found to be 498 m/min at d = 0.2 mm, f = 0.4 mm/rev. The tool tip temperature obtained from dry machining did not influence tool wear since the temperature rise is quite similar to the wet machining temperatures. …”
Get full text
Article -
493
Bladder scan vs urethral catheterization for measurement of immediate post partum bladder volume
Published 2011“…The mean for time interval between bladder scan and catheterization was 3 min(range between 1-8 min). There is a linear relationship between the bladder scan-estimated and catheter bladder volumes (r2=082). …”
Get full text
Article -
494
Rapid and sensitive LC method for the analysis of Gemifloxacin in Human plasma
Published 2009“…The mixture was then sonicated for 10 min followed by 20 min centrifugation at 5000 rpm (g = 3600). …”
Get full text
Article -
495
Personal control related to childbirth satisfaction among postpartum mothers in Hospital Tengku Ampuan Afzan (HTAA)
Published 2013“…Findings: The mean score for personal control among postnatal mother was 52.56 [SD = 10.693, min max (29, 70)] with the mean childbirth satisfaction score of 140.06 [SD = 17.109, min max (89, 170)]. …”
Get full text
Proceeding Paper -
496
Effect of peak current on material removal rate for electrical discharge machining of non-conductive Al2O3 ceramic
Published 2014“…MRR was found to be 0.052 mm3/min at peak current 1.1 A and it was found to be 0.132 mm3/min at peak current 1.3 A.…”
Get full text
Get full text
Article -
497
Coal-fired power plant airborne particles impact towards human health
Published 2015“…Manjung coal-fired power plant emission had been recognised as one of the potential anthropogenic sources of airborne particles. 8-hours airborne particles sampling had been done at Manjung Power Plant in March and July 2011 with 7-hole sampler at 2 L/min air flow and cyclone sampler at 2.2 L/min airflow. …”
Get full text
Article -
498
Reaction kinetics of free and immobilized β-glucosidase in alginate gel
Published 2013“…Michaelis constants obtained from linearized Langmuir plot are: vmax and Km as 21.10 μmol/mL.min and 0.0148 mol/L respectively for immobilized enzyme; vmax and Km for free enzyme were obtained as 24.33 μmol/mL.min and 0.0073 mol/L respectively. …”
Get full text
Get full text
Get full text
Proceeding Paper -
499
Development of a wastewater treatment system for chromium removal using chitosan
Published 2009“…The optimized conditions obtained at 28.79 mg chitosan dosage, pH 6.40, 20.20 min contact time and agitation speed of 156.20 rpm. …”
Get full text
Article -
500
Role of O6-alkylguanine-DNA alkyltransferase in the resistance of mouse spermatogenic cells to O6-alkylating agents
Published 2000“…Testicular O6-alkylguanine-DNA alkyltransferase concentrations were assayed between 0 and 240 min after O6-benzylguanine treatment and were shown to be > 95% depleted 15 min after treatment with O6-benzylguanine and remained at > 95% at all the times assayed. …”
Get full text
Article