Selective recognition of bisphenol a using molecularly imprinted polymer based on choline chloride-methacrylic acid deep eutectic solvent monomer: Synthesis characterization and ad... by Syed Asim Hussain Shah, Syed Asim Hussain Shah, Muggundha Raoov Ramachandran, Muggundha Raoov Ramachandran, Mansur, Sity Aishah, Md Saleh, Noorashikin, Asman, Saliza

“…Fourier transform infrared spectrometry (FTIR), scanning electron microscopy (SEM), thermogravimetric analysis (TGA), and differential scanning calorimetry (DSC) were used to characterize the synthesized polymers. …”
Get full text

Study on the effect of zeolite rice husk particles on polysulfone membrane by Rosman, Nurafiqah

“…Physical characterization were carried out using thermogravimetric analysis (TGA), scanning electron microscope (SEM), porosity, tensile strength, atomic force microscope (AFM) and water contact angle (CA). …”
Get full text
Get full text
Get full text

Design of reflectarray antenna integrated with FSS textured configurations for wireless communication applications by Kiyani, Arslan

“…Integrated FSS Reflectarray (FSS-RA) configurations based on iterative loop length approach are than implemented for operation in both X and Ku-band to improve the static phase range for the reduction of phase errors resulting in scan blindness. It has been demonstrated that the maximum static phase range of 540° can be obtained with the loop length variation of 6.8mm. …”
Get full text
Get full text
Get full text

Modeling electric field distribution on insulator under electron bombardment in vacuum by Sutjipto, Agus Geter Edy, Jufriadi, ., Muhida, Riza, ., Afzeri, Adesta, Erry Yulian Triblas

“…This report gives a simple explanation on this phenomenon. A scanning electron microscope was used not only as a tool to produce energetic electron beam to charge an insulator without metallic coating and to produce a surface discharging (surface breakdown/flashover) but also to observe the visible charging and discharging on the sample surface. …”
Get full text

Experimental analysis and simulation of catalytic converters by Mohiuddin, A. K. M.

“…After completing the test, the converters were cut to extract the substrate or 'honeycomb' inside the housing and being analyzed for microstructure and materials composition using Scanning Electron Microscopy (SEM) and Energy Dispersive Analysis (EDX). …”
Get full text

Identification of marine sand-dwelling dinoflagellates in Dinawan Island, Sabah by Al-Has, Asilah, Mohammad Noor, Normawaty

“…Samples were identified using light microscopy (LM) and Scanning Electron Microscopy (SEM). Sixteen dinoflagellates species have been identified including 4 potential toxic species i.e. …”
Get full text

Focused ion beam machining of silicon by Hung, NguyenPhu, Fu, Yongqi, Ali, Mohammad Yeakub

“…The surface integrity and machined features were measured with a scanning probe microscope. Statistical models were established to predict the sputtered depths and MRRs. …”
Get full text

Micromilling of tungsten carbide using focused ion beam by Ali, Mohammad Yeakub, Ong, A. S., Konneh, Mohamed

“…All the experiments were carried out with dry micromilling using serpentine scanning mode. Empirical models were formulated to predict the sputtered depth which increased with higher ion dose significantly but the relationship was nonlinear. …”
Get full text

Geometrical integrity of microholes produced by micro-EDM by Ali, Mohammad Yeakub

“…At first, an experimental process was developed to open the internal geometry of the holes and then characterized the geometrical integrity and surface texture using scanning electron microscope (SEM) and atomic force microscope (AFM).…”
Get full text

Thermal, mechanical, and rheological properties of biodegradable polybutylene succinate/carbon nanotubes nanocomposites by Ali, Fathilah, Mohan, Raja

“…Biodegradable poly(butylene succinate)/carbon nanotubes nanocomposites were prepared by melt mixing process and the influence of carbon nanotubes on the properties of the nanocomposites was investigated. Differential scanning calorimetry showed that crystallization temperature (Tc) increase with increasing carbon nanotube content. …”
Get full text

Investigation of recast layer of non-conductive ceramic due to micro-EDM by Mohamed, Abd. Rahman, Asfana, Banu, Ali, Mohammad Yeakub

“…The recast layer thickness was observed using scanning electron microscope and its hardness was measured using micro-Vickers hardness tester. …”
Get full text
Get full text

Evaluation of radar reflectivity-rainfall rate, Z-R relationships during a stratiform event in the tropics by Sobli, Nuurul Hudaa, Ismail, Ahmad Fadzil, Asnawi, Ani Liza, Saad, Wahida

“…The inaccuracy might also be due to the differences between the ground-level precipitation and the precipitation aloft since a radar does not scan all the way down except at close range. Several Z-R relationships had been proposed in the attempt to achieve better accuracy for rainfall estimates by radar system in the tropical climate. …”
Get full text

Modeling electric field distribution on insulator under electron bombardment in vacuum by Sutjipto, Agus Geter Edy, Jufriadi, ., Muhida, Riza, Adesta, Erry Yulian Triblas

“…This report gives a simple explanation on this phenomenon. A scanning electron microscope was used not only as a tool to produce energetic electron beam to charge an insulator without metallic coating and to produce a surface discharging (surface breakdown/flashover) but also to observe the visible charging and discharging on the sample surface. …”
Get full text

Physical properties of electroless nickel-tungsten coating on mild steels obtained from acetic bath by Mahmood, Mahmood Hameed, Harun, Nurliyana, -, Suryanto, Hilmy, Irfan

“…The influence of sodium acetate and sodium tungstate on deposits was investigated and characterized using scanning electron microscope (SEM), energy dispersive X-ray spectrometer (EDX) and x-ray diffraction (XRD) to assess the phase, content and microstructure features. …”
Get full text

Effect of clamshells filler loading on the tensile properties of polyhydroxybutyrate by Othman, Maizatulnisa, Hashim, Mohd Yusoff, Ibrahim, Nor Azowa, Khalid, Khalisanni, Mohamad, Souad A.

“…The tensile strength and modulus of PHB showed significant improvement with the incorporation of the filler up to 30 wt %, and this finding was supported by micrographs obtained from scanning electron microscope (SEM) which revealed uniform distribution of the filler in the polyhydroxybutyrate region. …”
Get full text

Synthesis of carbon nanotubes and its potential application in protein purification by using skim latex serum by N,M, Mubarak, Yusof, Faridah, Al-Khatib, Ma'an Fahmi Rashid, Al Hazza, Muataz Hazza Faizi, I.Y, Qudsieh, Al-Saadi, Mohammed A., Mohamed, Khalid

“…The morphology and the structure of CNTs were characterized using field emission scanning electron microscope (FSEM) and transmission electron microscope (TEM). …”
Get full text

Effect of multiple extrusions and influence of PP contamination on the thermal characteristics of bottle grade recycled PET by Itim, Bachir, Philip, Mathew

“…The thermal characteristics of bottle grade recycled PET pellets contaminated with 5% PP prepared by multiple extrusions were studied by differential scanning calorimetry (DSC) at constant heating rate of 10 degrees C/min for various extrusion cycles. …”
Get full text

Preparation and characterization of magnetic chitosan and its application for preconcentration of platinum(IV) metal ions by Mohd Daud, Jamaluddin, Ahmad, Nurliza

“…Physical characterizations of the beads were carried out by scanning electron microscope (SEM), image analyzer, Fourier transformed infrared spectrometer (FTIR) and vibrating-sample magnetometer (VSM). …”
Get full text

Surface modification by EDM using CO-CR sintered powder metallurgy electrod by Khan, Ahsan Ali, Ndaliman , Mohammed Baba, Ali , Mohammad Yeakub, Mansor, Mas Hafizah, Idrus, Nurul-Ain

“…The EDM variables of peak current, pulse duration and pulse interval were applied to investigate these surface properties. Scanning electron microscopy / energy dispersive x-ray spectroscopy SEM/EDX analysis confirmed migration of electrode materials (Co and Cr) onto the EDMed surface. …”
Get full text

Rheological and thermal behaviour of high impact polystyrene nanocomposite by Al-Ghamdi, Ahmed S., Ali, Mohammad Yeakub

“…Glass transition temperature (Tg) were also investigated using non-isothermal differential scanning calorimeter analysis. The viscosity was found to be directly proportional to MWCNTs’ loading, up to five times the value of pure HIPS at loading level of 7.5wt% of MWCNTs. …”
Get full text