Showing 4,761 - 4,780 results of 11,485 for search '((((pine OR line) OR five) OR hiang) OR ((ssspinga OR ((pina OR spinna) OR pingat)) OR spin))', query time: 0.09s Refine Results
  1. 4761

    CFD studies on natural convection heat transfer of Al2O3-water nanofluids by Walvekar , Rashmi Gangasa, Ismail, Ahmad Faris, Mohamed, Khalid, Yusof, Faridah

    Published 2011
    “…This work is focused on numerical simulations of natural convection heat transfer in Al2O3-water nanofluids using computational fluid dynamics approach. Fluent v6.3 is used to simulate water based nanofluid considering it as a single phase. …”
    Get full text
    Article
  2. 4762

    Powder mixed micro electro discharge milling of titanium alloy: analysis of surface roughness by Ali, Mohammad Yeakub, Adesta, Erry Yulian Triblas, Abdul Rahman, Nur Atiqah, Mohamad Aris, Erniyati

    Published 2012
    “…The aim is to achieve minimum Ra value on titanium alloy (Ti-6Al-4V) machined with tungsten electrode for various level of concentration of SiC powder and discharge energy (E). …”
    Get full text
    Article
  3. 4763

    Forward masking threshold estimation using neural networks and its application to parallel speech enhancement by Gunawan, Teddy Surya, Khalifa, Othman Omran, Ambikairajah, Eliathamby

    Published 2010
    “…Objective measures using PESQ demonstrates that our proposed forward masking model, provides significant improvements (5-15 %) over four existing models, when tested with speech signals corrupted by various noises at very low signal to noise ratios. …”
    Get full text
    Article
  4. 4764

    Powder Mixed Micro Electro Discharge Milling of Titanium Alloy: Analysis of Surface Roughness by Ali, Mohammad Yeakub, Adesta, Erry Yulian Triblas, Abdul Rahman, Nur Atiqah, Mohamad Aris, Erniyati

    Published 2011
    “…The aim is to achieve minimum Ra value on titanium alloy (Ti-6Al-4V) machined with tungsten electrode for various level of concentration of SiC powder and discharge energy (E). …”
    Get full text
    Proceeding Paper
  5. 4765

    Gelatinization properties of sago and wheat flour mixtures by Sarker, Md. Zaidul Islam, A., Abd Karim, D. M. A., Manan, Nik Ab Rahman, Nik Norulaini, A. K. M., Omar

    Published 2003
    “…The peak temperature (Tp) and peak viscosity (Vp) increased with increasing sago in the sago-wheat mixtures. The setback values (5B) in sago-LPW mixtures were higher than in sago-HPW and sago-MPW mixtures. …”
    Get full text
    Article
  6. 4766

    Rheological behavior and stability of cassava starch for ceramic mould binder application by Alias, Tuti Yasmin, Idris, Mohd Hasbullah, Ahmad, Zuraida, Ourdjini, Ali

    Published 2012
    “…Pseudoplastic or shear thinning behavior for both binder and slurry were observed starting at 0.13 Pa.s and 2.5 Pa.s respectively. Calcium carbonate (aragonite) slurry from starch binder however, exhibited viscoelastic behavior compare to colloidal silica sol. …”
    Get full text
    Article
  7. 4767

    Influence of energy parameters of micro WEDM on kerf by Ali, Mohammad Yeakub, Willey, Liew Yun Hsien, Gure, S. A., Asfana, Banu

    Published 2012
    “…Using a wire electrode of 70 μm diameter, a minimum kerf width is found to be 92 μm for the micro WEDM parameters of 0.01 μF capacitance and 90.25 V gap voltage. Around 30% increament of the kerf is found to be high. …”
    Get full text
    Article
  8. 4768

    The discrimination conundrum in the appointment of arbitrators in international arbitration by Oseni, Umar Aimhanosi, Kadouf, Hunud Abia

    Published 2012
    “…However, the issue of racial and religious discrimination is of special interest and requires serious debate.This article attempts to discuss the issue of racial and religious discrimination in light of the recent decision of the Supreme Court of the United Kingdom in Jivraj v. Hashwani [2011] UKSC 40.The article tries to suggest a balanced view for promoting sustainable practices in international arbitration. …”
    Get full text
    Article
  9. 4769

    Surface roughness of sputtered silicon. II. Model verification by Ali, Mohammad Yeakub, Hung, NguyenPhu

    Published 2001
    “…The theoretical surface roughness was found to be within ±1 and ±5 nm of the measured surface roughness with the measurement uncertainty (standard deviation) of about ±0.36 and ±0.85 nm for R a and R t, respectively.…”
    Get full text
    Article
  10. 4770

    Surface integrity and removal rate of silicon sputtered with focused ion beam by Hung, NguyenPhu, Ali, Mohammad Yeakub, Fu, Yongqi, Ong, NanShing, Tay, MengLeong

    Published 2001
    “…A surface roughness in the range 2-5 nm was achieved, and was found to be linearly dependent on the pixel spacing. …”
    Get full text
    Article
  11. 4771

    Trench DMOS interface trap characterization by three-terminal charge pumping measurement by Izzudin , Ismah, Kamaruddin , Mohd. Hanif, Nordin, Anis Nurashikin, Soin, Norhayati

    Published 2012
    “…The charge pumping measurements showed very high source–drain current after approximately −2 V Vbase value. …”
    Get full text
    Article
  12. 4772

    Effects of neutron on reverse bias characteristics of commercially available SI and gaas diodes by Che Omar, Nuurul Iffah, Alang Md Rashid, Nahrul Khair, Abdul Karim, Julia, Abdullah , Jaafar, Hasbullah, Nurul Fadzlin

    Published 2012
    “…The diodes were irradiated using Pneumatic Transfer System facility at PUSPATI TRIGA reactor with neutron fluences up to (6.038  3.067) x1012 n /cm2.s for a period of 1, 3 and 5 minutes. The results showed an increase in leakage current for all diodes which may be due to the existence of neutron-induced displacement defects introduced into the semiconductor lattice. …”
    Get full text
    Article
  13. 4773

    Comparing metals adsorption by carbon adsorbents: evaluating absorption properties of different carbon adsorbents by Onundi, Yusuf Bamidele, Al-Mamun, Abdullah, Al-Khatib, Ma'an Fahmi Rashid

    Published 2012
    “…Optimum adsorption capacity of GAC and CNM were observed at pH 5 and 1 g/L dosage, while equilibrium adsorption conditions were generally noticed by 60 minutes of agitation at 100 rpm. …”
    Get full text
    Book
  14. 4774
  15. 4775

    Straightforward synthesis of novel 1-(2'-α-O-D-glucopyranosyl ethyl) 2-arylbenzimidazoles by Arumugam, Natarajan, Abdul Rahim, Aisyah Saad, Abd Hamid, Shafida, Osman, Hasnah

    Published 2012
    “…A series of novel 1-(2'-α-O-D-glucopyranosyl ethyl) 2-arylbenzimidazoles has been prepared via one-pot glycosylation of ethyl-1-(2'-hydroxyethyl)-2-arylbenzimidazole-5-carboxylate derivatives. Synthesis of the 2-arylbenzimidazole aglycones from 4-fluoro-3-nitrobenzoic acid was accomplished in four high-yielding steps. …”
    Get full text
    Article
  16. 4776

    A comparative study of the difference between MFCC and PLP in the recognition of sound by Alim, Sabur Ajibola, Alang Md Rashid, Nahrul Khair, Rahman, Md. Mozasser

    Published 2013
    “…The identification rate using the RNN classifier and MFCC is 72.7%, 73.7%, 78.9% 57.1% and 58.3% for aircraft, car, rain, thunder and train respectively as compared to what was obtained by using MLP. 31.6%, 19.4%, 18.5%, 38.0% and 26.4% decline is achieved for aircraft, car, rain, thunder and train respectively when comparing between MLP and RNN for MFCC. …”
    Get full text
    Article
  17. 4777

    Effect of coupling agent on the mechanical properties of flame retardant PP/ATH nanocomposites by Sabaruddin, Fatimah A’thiyah, Samat, Noorasikin

    Published 2013
    “…Polymer nanocomposites containing polypropylene (PP) as the polymer matrix and nanofiller aluminium hydroxide (ATH) as the flame retardant filler were compounded with various loading of maleic anhydride grafted polypropylene, MAPP (0, 1, 2, 3, 5 wt %). All materials were mixed using melt mixing process and were further prepared using an injection moulding machine. …”
    Get full text
    Article
  18. 4778

    Cooling of motorcyclist helmet with thermoelectric module by Hrairi, Meftah, Abdullah, Abdullah F., Ahmed, Mirghani Ishak

    Published 2013
    “…The numerical and experimental results showed a good agreement and indicated that the temperature inside the helmet was reduced from 25.5°C to 19.3°C in approximately 6 min.…”
    Get full text
    Article
  19. 4779

    Environmental friendly device: modeling of carbon nanotube with optimum chirality by Farhana, Soheli, Alam, A. H. M. Zahirul

    Published 2013
    “…Finally the minimum value of CNT bandgap of 0.4401eV shows that the optimum chirality is (25,0) for the modeling of carbon nanotube. …”
    Get full text
    Article
  20. 4780

    A low-cost PC-based range finder system by Motakabber, S. M. A., Ibrahimy, Muhammad Ibn

    Published 2013
    “…A numbers of test were done and found that the proposed system performances are good in terms of accuracy ±5%, simplicity,cost and power consumption.…”
    Get full text
    Article