-
661
Laser metal deposition of low carbon 410L stainless steel and heat treatment
Published 2023“…The yield strength is 601.9 MPa for as-built condition and 930.6 MPa for heat-treated condition (1000 °C/10 min); the ultimate tensile strength (UTS) is 923.0 MPa for as-built condition and 1101.5 MPa for the heat-treated condition (1000 °C/10 min); the elongation is 17.7% for as-built condition and 15.1% for the heat-treated condition (1000 °C/10 min). …”
Get full text
Journal Article -
662
Dose response effect of carbohydrate mouth rinse on 10 km running time trial
Published 2018“…Results: No significant difference (p = .441) in 10 km running time trial were observed between 6.4% CHO [mean 63.83 (SD 11) min] and 15% CHO [mean 65.91 (SD 13.36) min]. No significant difference were found in HR (p = .440) between 6.4% CHO [mean 162 (SD 7) beats/min] and 15% CHO [mean 158 (SD 13) beats/min]. …”
Get full text
Final Year Project (FYP) -
663
Pengetahuan, Sikap dan Praktis (KAP) Komuniti Pekebun Kecil Koko (KPKK) berkaitan Malaysian Good Agricultural Practices (MyGAP)
Published 2024“…Tahap amalan pertanian baik (APB) menunjukkan nilai min tertinggi oleh praktis (min 4.20). Diikuti, dengan tahap sikap (min 4.08) dan tahap pengetahuan (min 4.01) oleh KPKK. …”
Get full text
Article -
664
Mechanical properties of pultruded Kenaf fibre-reinforced vinyl ester composites
Published 2016“…The investigation of the effect of pulling speed on the mechanical properties of pultruded kenaf composites shows the optimal pulling speed for tensile strength and compressive strength is 0.3 m/min, tensile modulus 0.1 m/min, flexural strength 0.4, flexural modulus 0.2 m/min. …”
Get full text
Thesis -
665
Influence of machining parameters and tool geometry on tool wear during cobalt chromium-molybdenum micro drilling
Published 2024“…The cutting speeds of 50 m/min, 65 m/min, and 80 m/min were varied. A total of 11 runs were performed, with each run consisting of drilling 30 holes. …”
Get full text
Article -
666
Nano-engineering the evolution of skyrmion crystal in synthetic antiferromagnets
Published 2022“…Moreover, when the bottom layer thickness increases, the annihilation of skyrmion shifts from evolving into a ferromagnetic spin texture to evolving into an antiferromagnetic spin texture. …”
Get full text
Journal Article -
667
Unveiling the chirality of the quantum anomalous Hall effect
Published 2024“…By lδz, we find that the chiral flow-direction of an electron in the QAHE is not explicitly related to the intrinsic spin axis, thereby enabling the spin-momentum-unlocking edge states in an antiferromagnetic QAHE system. …”
Get full text
Journal Article -
668
Back to the Basics of SARS-CoV-2 Biochemistry: Microvascular Occlusive Glycan Bindings Govern Its Morbidities and Inform Therapeutic Responses
Published 2024“…Consistent with the biochemistry of coronaviruses as well established over decades, SARS-CoV-2 makes its initial attachment to host cells through the binding of its spike protein (SP) to sialylated glycans (containing the monosaccharide sialic acid) on the cell surface. …”
Get full text
Article -
669
NMDA receptor activation enhances inhibitory GABAergic transmission onto hippocampal pyramidal neurons via presynaptic and postsynaptic mechanisms
Published 2011“…Thus NMDARs at glutamatergic synapses on both CA1 pyramidal neurons and interneurons appear to exert feedback and feedforward inhibition for determining the spike timing of the hippocampal microcircuit.…”
Get full text
Get full text
Journal Article -
670
Kinetics of papaya pectinesterase
Published 1995“…The activity was linear up to 20 min with an enzyme concentration of up to 6.14 μg. …”
Get full text
Article -
671
Magnetic levitation using neodymium magnets for vertical axis wind turbine (VAWT) II
Published 2012“…This project involved the design and fabrication of a test model vertical axis wind turbine, however as this experiment was carried out indoor without any wind condition, the author used a dc motor to simulate the wind required to spin the turbine. The advantage of this motor allows the author some control over the speed of the turbine. …”
Get full text
Final Year Project (FYP) -
672
Singlet fission in organic crystals : ultrafast spectroscopic study
Published 2014“…Singlet fission (SF) is a spin-allowed process in which one singlet excited molecule shares its energy with an adjacent molecule in the ground state, both molecules forming a pair of triplet states. …”
Get full text
Thesis -
673
Microwave tunable dielectric properties of multilayer CNT membranes for smart applications
Published 2013“…Multilayer multiwall carbon nanotube (MWCNT) silicone composite membranes with thickness greater than 10 μm were prepared with a spin-coating method. Dielectric permittivity and tunability of the circular membranes were measured from 0.1 to 7 GHz by using a single-port coaxial line method. …”
Get full text
Get full text
Journal Article -
674
Analysis of Λ b 0 → pK − μ + μ − decays
Published 2024“…The data are consistent with receiving contributions from a mixture of Λ resonances with different spin-parity quantum numbers. The angular coefficients show a pattern of vector-axial vector interference that is a characteristic of the type of flavour-changing neutral-current transition relevant for these decays.…”
Journal article -
675
Lying and rumination time as predictors of subclinical ketosis, metritis, and hypocalcaemia in dairy cows during the periparturient period: A systematic review and meta-analysis
Published 2024“…Meanwhile, the MD of RT was significantly different in both periods (MD = −61.76 and −73.33 min/day, P < 0.05) for SCK and during the prepartum for metritis (MD = −23.37 min/day, P = 0.04). …”
Get full text
Article -
676
Compressive strength of cemented sand
Published 2013“…In this paper, the four main factors affecting the compressive strength of cemented sand will be investigated: water-cement ratio of 0.5, 0.6, 0.7; sand-cement ratio of 4.0, 5.0, 6.0; curing age at 3, 7 and 28 days; strain rate of 0.5mm/min, 1.0mm/min, and 2.0 mm/min. The other factors such as dry density, sample dimensions (height and diameter), curing conditions were kept constant. …”
Get full text
Final Year Project (FYP) -
677
ProtAgents: Protein discovery via large language model multi-agent collaborations combining physics and machine learning
Published 2024“…Current methodologies for protein design often rely on AI-based models, such as surrogate models that address end-to-end problems by linking protein structure to material properties or vice versa. However, these models frequently focus on specific material objectives or structural properties, limiting their flexibility when incorporating out-of-domain knowledge into the design process or comprehensive data analysis is required. …”
Get full text
Article -
678
Degradation Mechanisms and Applications in Ion Intercalation Materials
Published 2024“…Overall, I set up a consistent framework modeling degradation from single particle to population level and vice versa in LiBs.…”
Get full text
Thesis -
679
Optimization of Sb2(S, Se)3 photoabsorbers for photoelectrochemical hydrogen evolution reaction
Published 2024“…However, there was a preferred growth orientation of (hk1) over (hk0) plane for the samples with 10% Se when annealing temperature increased, and vice versa for the samples with 20% Se. Moreover, all antimony chalcogenide films show compact morphology without any presence of the pinholes. …”
Get full text
Final Year Project (FYP) -
680
Evaluation of CQAs
Published 2012“…However, the English sites outdo the Chinese sites in terms of answer responsiveness; and vice-versa in terms of corpus comprehensiveness. …”
Get full text
Thesis