Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test by Mohd Harun, Dalila

“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text

Enrichment of fruit wastes with white rot fungi under submerged state bioconversion by Jamal, Parveen, Saheed, Olorunnisola Kola, Alam, Md. Zahangir, Muyibi, Suleyman Aremu, Abdul Karim, Mohamed Ismail

“…On Banana and Pineapple (BPin) the protein content were recorded as18.05 and 15.75 mg/g, which was higher than Papaya and Pineapple (PinPw) and Banana and Papaya (BPw)composite. M6 has 15.4 and 9.78 mg/g on BPinPw, 13.84 and 13.59 mg/g on BPw, 20.82, and 22.97 mg/g on BPin and 18.29 and 11.59 mg/g on PinPw. …”
Get full text

Electrical breakdown and structural characterization in synthetic resins using optical techniques by Dodd, Stephen John

“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text

Development of remote operability CNC milling by ., Afzeri, Muhida, Riza, ., Darmawan

“…Attachment consists of three main equipments; material indexing device, Sub clamp with pin and vise index…”
Get full text

The system architecture of E-braille by using the microcontroller and external controller unit by Burhan, Muhammad Mansor, Toha, Siti Fauziah

“…This refreshable braille cell can refresh the character. The pin for each braille cell is controlled by using piezoelectric bimorph. …”
Get full text
Get full text

Evaluation of classifiers in a pressure and latency-based typing biometric system by Moez Khan, Imran, ., Imama, Ushama, K. M., Aibinu, Abiodun Musa, Lai, Weng Kin

“…System authentication in present time relies on validation by some sort of a password or Personal Identification Number (PIN). However, if an intruder discovers this password or PIN, the user’s account can be easily compromised. …”
Get full text

An investigation of defect formation and growth in epoxy resin using light scattering methods by Perkins, Elaine Ann

“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text

Enhancement of sulfonated poly ether ether ketone based electrolytes for bipolar membrane fuel cell by Sayed Daud, Syarifah Noor Syakiylla

Get full text

Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing by ISA, SITI RAHENA, JUSOH, MUZAMMIL, THENNARASAN SABAPATHY, THENNARASAN SABAPATHY, KAMARUDIN, MUHAMMAD RAMLEE, OSMAN, MOHAMED NASRUN, AKRAM ALOMAINY, AKRAM ALOMAINY

“…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
Get full text

Molding of three-dimensional microcomponents by Hung, W. N. P., Agnihotri, M. M., Ali, Mohammad Yeakub, Yuan, S.

“…The research results showed that a microcomponent can be fabricated to the minimum size of 10 ± 1μm (0.0004 inch) with surface roughness <10 nm Rt. Molding of micro-size geartrains and orthopedic meso-size fasteners was completed to illustrate the capability of this process.…”
Get full text

PCR-based chromosome walking: the SFR 3 case by Amid, Azura, Warren, Garreth J., Bramley, Peter M.

“…Eleven new PCR markers had been designed to fine map the gene. Roughly 557 F2 plants tested in these experiments and 38 lines were then used in the fine mapping experiments. …”
Get full text

Wear characteristics of Fe-C-Si and Fe-C-Al cast irons by Shaha, Sugrib Kumar, Haque, Md. Mohafizul, Khan, Ahsan Ali

“…In the present study, wear behavior of the Fe-C-Si and Fe-C-Al cast irons were investigated using a pin-on-disk type apparatus at room temperature. …”
Get full text

Biomechanical evaluation and new improvement on ankle external fixator by Ramlee, Muhammad Hanif

Get full text

Analysis of Sound Propagation Behaviors for Supersonic Jet on Far Field Region by Computational Aero-Acoustics (CAA) Simulation by Maulana, Yudi, Manshoor, Bukhari, Khalid, Amir, Zaman, Izzuddin, Didane, Djamal Hissein, Abdul Haq, Reazul Haq, Kamarudin, Kamarul-Azhar, Nurmutia, Syahreen, Saleman, Abdul Rafeq, Rathje, Rio Marco, Rothe, Christin, Ibrahim, Mohd Nizam

“…The CFD and CAA analyses were performed in transient state simulation and the 2-inch Acoustics Reference Nozzle (ARN2). The result shows that the overall SPL throughout the frequency is proportional to the jet velocity of the supersonic jet. …”
Get full text

The tribological behaviour of Fe-C-Al cast iron – effect of temperature by Maleque, Md. Abdul, Sugrib , S.

“…The wear and friction tests were conducted using universal pin-on-disk machine at 25 0C, 100 0C, 200 0C and 300 0C temperature. …”
Get full text

Low-loss paper-substrate triple-band-frequency reconfigurable microstrip antenna for sub-7 GHz applications by Singh, Ajit Kumar, Mahto, Santosh Kumar, Sinha, Rashmi, Alibakhshikenari, Mohammad, Al-Gburi, Ahmed Jamal Abdullah, Ahmad, Ashfaq, Kouhalvandi, Lida, Virdee, Bal Singh, Dalarsson, Mariana

“…In this paper, a low-cost resin-coated commercial-photo-paper substrate is used to design a printed reconfigurable multiband antenna. The two PIN diodes are used mainly to redistribute the surface current that provides reconfigurable properties to the proposed antenna. …”
Get full text
Get full text

Application of ultrasonic guided wave for structural health monitoring of pipeline by Chua, Mukhlis @ Chua Ching Kok

Get full text

Mechanical, durable and acoustic properties evaluation of concrete containing granulated blast furnace slag and waste tyres aggregate by Mohamed Mhaya, Akram

Get full text

Physico-mechanical properties of polymer concrete containing micro-filler of palm oil fuel ash by A. Khalid, Nur Hafizah, Ismail, Mohammad, Mohd. Sam, Abd Rahman, Mohamed, Azman, A. Ismail, Mohamed, Jamellodin, Zalipah, Salleh, Norhafizah, A. Hamid, Noor Azlina, A. Majid, Masni

“…Objective of this study is to present a research conducted on ground (fine) and unground (coarse) POFA in polymer concrete (PC) followed by determination on the physico-mechanical properties of PC. …”

Identifying key drivers of food price inflation in Malaysia by Norazman, Umi Zakiah, Khalid, Haniza, Mat Ghani, Gairuzazmi

“…In Malaysia, food price inflation reached its highest level at 8.8% in mid-2008 compared to overall inflation of 5.5% for the same period, mainly blamed on the spike in world commodity prices. However, recent moves by the government to rationalize food and energy subsidies have also led to higher than normal headline inflation figures and cause public concern. …”
Get full text