-
201
Effect of knowledge management practices on business performance in Bangladesh pharmaceutical industry
Published 2012“…This is due to the fact that firms’ performances are increasingly hinge upon managing knowledge of their employees rather than managing only physical facilities and resources. …”
Get full text
Article -
202
The potential of effective microorganism (EM) inclusion in enhancing the properties of cement paste and concrete
Published 2019“…Furthermore, the high compressive strength and low porosity also leading to improve the internal densification of cement matrix which reported the formation of calcium silicate hydrate (CSH) and ettringite by detecting from formation of bundle shape and needles like pine leaves, acicular, thin, narrow and pointed shape, respectively at later age of 28 days and 60 days using scanning electron microscopy (SEM). …”
Get full text
Thesis -
203
Effect of Knowledge Management Practices on Business Performance in Bangladesh Pharmaceutical Industry
Published 2012“…This is due to the fact that firms’ performances are increasingly hinge upon managing knowledge of their employees rather than managing only physical facilities and resources. …”
Get full text
Get full text
Proceeding Paper -
204
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
205
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
206
Enrichment of fruit wastes with white rot fungi under submerged state bioconversion
Published 2013“…On Banana and Pineapple (BPin) the protein content were recorded as18.05 and 15.75 mg/g, which was higher than Papaya and Pineapple (PinPw) and Banana and Papaya (BPw)composite. M6 has 15.4 and 9.78 mg/g on BPinPw, 13.84 and 13.59 mg/g on BPw, 20.82, and 22.97 mg/g on BPin and 18.29 and 11.59 mg/g on PinPw. …”
Get full text
Proceeding Paper -
207
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
208
Development of remote operability CNC milling
Published 2010“…Attachment consists of three main equipments; material indexing device, Sub clamp with pin and vise index…”
Get full text
Proceeding Paper -
209
The system architecture of E-braille by using the microcontroller and external controller unit
Published 2016“…This refreshable braille cell can refresh the character. The pin for each braille cell is controlled by using piezoelectric bimorph. …”
Get full text
Get full text
Article -
210
Infusing Qur’anic moral codes into engineering studies: Selected themes
Published 2006“…Engineering profession, like medical and other professions, has a deep impact on the society. …”
Get full text
Article -
211
Evaluation of classifiers in a pressure and latency-based typing biometric system
Published 2011“…System authentication in present time relies on validation by some sort of a password or Personal Identification Number (PIN). However, if an intruder discovers this password or PIN, the user’s account can be easily compromised. …”
Get full text
Proceeding Paper -
212
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis -
213
Material properties and design aspects of folding bicycle frame
Published 2011“…The relationship between materials properties and design is not straight forward because the behavior of the material in the finished product could be different from that of the raw material. The swing hinge technique could be a better technique in the design for the folding bicycle frame.…”
Get full text
Article -
214
Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing
Published 2023“…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
Get full text
Article -
215
Novel opto-electronic and plastic fibre sensors
Published 1998“…Likely variations in the source light intensity do not affect the performance and accuracy of the sensor. …”
Get full text
Thesis -
216
Risk management policies of telecommunication and engineering laboratories
Published 2016“…The Telecommunication laboratories plays an important role in carrying out research in the different fields like Telecommunication, Information Technology, Wireless Sensor Networks, Mobile Networks and many others fields. …”
Get full text
Article -
217
Biomechanical evaluation and new improvement on ankle external fixator
Published 2023Get full text
Thesis -
218
Ethical dimensions in robot creation industry
Published 2005“…Being one of the salient fields, it has for long intrigued engineers as to how to invent the adjacent human-like machine that could emulate human emotions, styles and patterns in precisely identical mode. …”
Get full text
Article -
219
The tribological behaviour of Fe-C-Al cast iron – effect of temperature
Published 2013“…The wear and friction tests were conducted using universal pin-on-disk machine at 25 0C, 100 0C, 200 0C and 300 0C temperature. …”
Get full text
Article -
220
Low-loss paper-substrate triple-band-frequency reconfigurable microstrip antenna for sub-7 GHz applications
Published 2023“…In this paper, a low-cost resin-coated commercial-photo-paper substrate is used to design a printed reconfigurable multiband antenna. The two PIN diodes are used mainly to redistribute the surface current that provides reconfigurable properties to the proposed antenna. …”
Get full text
Get full text
Article