-
41
-
42
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
43
-
44
Biomechanical evaluation and new improvement on ankle external fixator
Published 2023Get full text
Thesis -
45
-
46
A study on laser engraving process parameters and performance characteristics for wood base materials
Published 2018“…This research presents a study on the parameter of laser engraving on pine wood and WPC materials by using EleksMaker Laser A5-Pro model with low diode laser (500Mw, 405nm wavelength). …”
Get full text
Get full text
Get full text
Thesis -
47
Holocene environmental change in the Scottish Highlands: multi-proxy evidence from blanket peats
Published 1997“…This thesis seeks to investigate the Holocene environmental history of two areas of Northern Scotland with specific reference to the evidence for pine woodland density variations and tree-line dynamics. …”
Get full text
Thesis -
48
On some dynamic systems arising in lattice models with competing ternary interactions
Published 2009“…Later similar result was proved for Potts model with three spins [2]. Let Let …”
Get full text
Proceeding Paper -
49
On the existence of phase transition for one dimensional P-adic countable state Potts model
Published 2011“…Note that it turns out that the finding condition does not depend on values of the prime p , and therefore, an analogous fact is not true when the number of spins is finite.…”
Get full text
Proceeding Paper -
50
On uniqueness of Gibbs measure for p-adic countable state Potts model on the Cayley tree
Published 2009“…An analogous fact is not true when the number of spins is finite.…”
Get full text
Get full text
Article -
51
Development of switchable planar reflectors for beam shaping realization
Published 2016“…The objective of this work was to investigate the feasibility of using strategic slot embedded patch element configurations for an efficient reconfigurable reflectarray antenna design. PIN diodes were incorporated with single and multiple slot embedded patch element configurations for the design of beam switchable planar reflectors. …”
Get full text
Get full text
Get full text
Thesis -
52
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
53
Evaluation of classifiers in a pressure and latency-based typing biometric system
Published 2011“…System authentication in present time relies on validation by some sort of a password or Personal Identification Number (PIN). However, if an intruder discovers this password or PIN, the user’s account can be easily compromised. …”
Get full text
Proceeding Paper -
54
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis -
55
Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing
Published 2023“…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
Get full text
Article -
56
Wear characteristics of Fe-C-Si and Fe-C-Al cast irons
Published 2011“…In the present study, wear behavior of the Fe-C-Si and Fe-C-Al cast irons were investigated using a pin-on-disk type apparatus at room temperature. …”
Get full text
Article -
57
Low-loss paper-substrate triple-band-frequency reconfigurable microstrip antenna for sub-7 GHz applications
Published 2023“…In this paper, a low-cost resin-coated commercial-photo-paper substrate is used to design a printed reconfigurable multiband antenna. The two PIN diodes are used mainly to redistribute the surface current that provides reconfigurable properties to the proposed antenna. …”
Get full text
Get full text
Article -
58
Innovative UWB phase shifters using groove gap-waveguide technology inspired by metasurfaces for beamforming networks operating at 100 GHz
Published 2025“…The metasurface features a "bed-of-nails" structure, where metal pins are connected to a bottom layer and spaced <λ/4 from a top plate. …”
Get full text
Conference or Workshop Item -
59
Metamaterial based ultra-wideband antennas for portable wireless applications
Published 2017“…Various approaches have been reported to reduce the physical size of RF antennas including using high permittivity substrates, shorting pins, reactive components, and more recently, metamaterials (MTM) based on composite right-/left-handed transmission-lines (CRLH-TLs). …”
Get full text
Book Section -
60
Ballistic impact fracture behaviour of continuous fibre reinforced al-matrix composites
Published 2010“…The materials response under high energy impact loads was studied using a gas gun. The projectiles were pins 1.2-1.5 mm in diameter and weighing 0.347-0.435 g. …”
Get full text
Article