-
281
Ant colony optimization for controller and sensor-actuator location in active vibration control
Published 2013“…Analytical model of the simply supported plate with piezoelectric patches is derived using thin plate theory. …”
Get full text
Proceeding Paper -
282
ZnO / polymer junction growth for hybrid solar cell applications
Published 2011“…With the employment of zinc oxide (ZnO) and polyethylene oxide (PEO) thin films. ITO based thin films of ZnO were deposited by sputtering technique and ITO based thin films of polyethylene were deposited by solution cast technique and used as an active polymer blend. …”
Get full text
Book Chapter -
283
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
284
Fabrication and characterization of poly (ethylene oxide) for photo-electronic devices
Published 2015“…Ionic conducting polymer thin films consist of poly (ethylene oxide)-chitosan blend, ammonium iodide NH4I and iodine crystal I2 were prepared by solution cast technique at room temperature. …”
Get full text
Get full text
Proceeding Paper -
285
Enrichment of fruit wastes with white rot fungi under submerged state bioconversion
Published 2013“…On Banana and Pineapple (BPin) the protein content were recorded as18.05 and 15.75 mg/g, which was higher than Papaya and Pineapple (PinPw) and Banana and Papaya (BPw)composite. M6 has 15.4 and 9.78 mg/g on BPinPw, 13.84 and 13.59 mg/g on BPw, 20.82, and 22.97 mg/g on BPin and 18.29 and 11.59 mg/g on PinPw. …”
Get full text
Proceeding Paper -
286
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
287
-
288
-
289
Development of remote operability CNC milling
Published 2010“…Attachment consists of three main equipments; material indexing device, Sub clamp with pin and vise index…”
Get full text
Proceeding Paper -
290
The system architecture of E-braille by using the microcontroller and external controller unit
Published 2016“…This refreshable braille cell can refresh the character. The pin for each braille cell is controlled by using piezoelectric bimorph. …”
Get full text
Get full text
Article -
291
Energy absorption performance of braided basalt reinforced composite tubes under axial loads
Published 2018“…A numerical model of sandwich tube with the highest energy absorption capability obtained experimentally was developed and validated with the experimental result. The main finding shows that sandwich tubes have better crushing control than thin-walled tubes under a dynamic impact loading. …”
Get full text
Thesis -
292
A study on controllable aluminium doped zinc oxide patterning by chemical etching for MEMS application
Published 2017“…This present work reports on the study of controllable aluminium doped zinc oxide (AZO) patterning by chemical etching for MEMS application. The AZO thin film was prepared by RF magnetron sputtering as it is capable of producing uniform thin film at high deposition rates. …”
Get full text
Get full text
Get full text
Article -
293
ANT colony optimization for controller and sensor-actuator location in active vibration control
Published 2013“…This paper discusses on active vibration control of a simply supported thin plate excited and actuated by piezoelectric patches. …”
Get full text
Article -
294
-
295
Evaluation of classifiers in a pressure and latency-based typing biometric system
Published 2011“…System authentication in present time relies on validation by some sort of a password or Personal Identification Number (PIN). However, if an intruder discovers this password or PIN, the user’s account can be easily compromised. …”
Get full text
Proceeding Paper -
296
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis -
297
-
298
-
299
Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing
Published 2023“…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
Get full text
Article -
300
Identification of Cryptosporodium from Dairy Cattle in Pahang, Malaysia
Published 2016“…This study was carried out to determine the prevalence of Cryptosporidium infection in cattle in Kuantan, Pahang, Malaysia and to find out the association between the occurrence of infection and 3 different ages of cattle (calves less than 1 year, yearling, and adult cattle). …”
Get full text
Get full text
Article