-
61
Overview of Jute Fibre as Thermoplastic Matrix Polymer Reinforcement
Published 2024Get full text
Article -
62
-
63
Experimental investigation assessment of railway ground vibration: a case study in Kluang-Gemas, Kluang District, Johor, Malaysia
Published 2023Get full text
Conference or Workshop Item -
64
-
65
A study on laser engraving process parameters and performance characteristics for wood base materials
Published 2018“…This research presents a study on the parameter of laser engraving on pine wood and WPC materials by using EleksMaker Laser A5-Pro model with low diode laser (500Mw, 405nm wavelength). …”
Get full text
Get full text
Get full text
Thesis -
66
-
67
Holocene environmental change in the Scottish Highlands: multi-proxy evidence from blanket peats
Published 1997“…This thesis seeks to investigate the Holocene environmental history of two areas of Northern Scotland with specific reference to the evidence for pine woodland density variations and tree-line dynamics. …”
Get full text
Thesis -
68
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
69
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
70
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
71
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis -
72
Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing
Published 2023“…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
Get full text
Article -
73
Biomechanical evaluation and new improvement on ankle external fixator
Published 2023Get full text
Thesis -
74
Low-loss paper-substrate triple-band-frequency reconfigurable microstrip antenna for sub-7 GHz applications
Published 2023“…In this paper, a low-cost resin-coated commercial-photo-paper substrate is used to design a printed reconfigurable multiband antenna. The two PIN diodes are used mainly to redistribute the surface current that provides reconfigurable properties to the proposed antenna. …”
Get full text
Get full text
Article -
75
Measurement and modelling of operational amplifier power supply rejection
Published 1995“…Measured results for 741 and pin-compatible operational amplifiers are tabulated. …”
Get full text
Article -
76
Photonic controlled metasurface for intelligent antenna beam steering applications including 6G mobile communication systems
Published 2023“…This paper presents a novel metasurface antenna whose radiation characteristics can be remotely controlled by optical means using PIN photodiodes. The proposed reconfigurable antenna is implemented using a single radiating element to minimize the size and complexity. …”
Get full text
Get full text
Article -
77
Development of coated peanut separator and frying skillet machine
Published 2018“…The groundnut is sticking and become like a ping pong size ball and the time consuming to fry is longer. …”
Get full text
Article -
78
Design and Implementation of Active Antennas for IoT-Based Healthcare Monitoring System
Published 2024“…Two dual-band (2.4 GHz and 5.8 GHz) microstrip patch antennas, one with a PIN diode and one without, are fabricated using Rogers Duroid RO3003™ substrate. …”
Get full text
Article -
79
Design and Implementation of Active Antennas for IoT-Based Healthcare Monitoring System
Published 2024“…Two dual-band (2.4 GHz and 5.8 GHz) microstrip patch antennas, one with a PIN diode and one without, are fabricated using Rogers Duroid RO3003™ substrate. …”
Get full text
Article -
80
Design and Implementation of Active Antennas for IoT-Based Healthcare Monitoring System
Published 2024“…Two dual-band (2.4 GHz and 5.8 GHz) microstrip patch antennas, one with a PIN diode and one without, are fabricated using Rogers Duroid RO3003™ substrate. …”
Get full text
Article