Showing 601 - 620 results of 869 for search '(((binaa OR pinggkwan) OR pinggsed) OR ((ling OR ((pina OR spingg) OR min)) OR pin))', query time: 0.23s Refine Results
  1. 601

    Waste cooking oil transesterification: influence of impeller type, temperature, speed and bottom clearance on FAME yield by Adeyemi, Nabeel A., Mohiuddin, A. K. M., Jameel, Ahmed Tariq

    Published 2011
    “…Peak yield time between 5 to 30 min was observed. Correlation between FAME yield, peak time and temperature was high (0.968). …”
    Get full text
    Article
  2. 602

    Multi-criteria optimization in end milling of AISI D2 hardened steel using coated carbide inserts by Karim, A.N. Mustafizul, Lajis, M.A., Amin, A. K. M. Nurul

    Published 2011
    “…At this stage, the optimum values of machining parameters - cutting speed, depth of cut and feed were determined as 44.27 m/min, 0.61 mm, 0.065 mm/tooth respectively. Under this set condition of machining operations a surface roughness of 0.348 μm and volume material removal of 7.45 cm3 were the best results compared to the rest four set conditions. …”
    Get full text
    Article
  3. 603

    Optimization of process parameters on EDM milling of stainless steel AISI 304 by A.K.M, Asif Iqbal, Khan, Ahsan Ali

    Published 2011
    “…The result shows that the machining parameter setting of voltage 120 V, rotational speed of electrode 1200 rpm and feed rate 4μm/s, gives optimized responses MRR 5.0259 x 10-3 mm3/min, EWR 53% and Ra 0.79 μm.…”
    Get full text
    Article
  4. 604

    Fish oil recovery from viscera of Indian mackerel (Rastrelliger kanagurta) by supercritical fluid: an optimization approach by Ferdosh, Sahena, Sarker, Md. Zaidul Islam, Nik Abd Rahman, Nik Norulaini, Selamat, Jinap, Karim, Md. Rezaul, Abdul Razak, Tariq, Abd Kadir, Mohd Omar

    Published 2012
    “…The optimum parameters for all 4 techniques applied were found to be 35 MPa, 60 °C, and 2 mL min-1 with an Oil recovery ranging from 93 to 99%. …”
    Get full text
    Article
  5. 605

    Performance of the trim and fill method in adjusting for the publication bias in meta-analysis of continuous data by Nik Idris, Nik Ruzni

    Published 2012
    “…Although the data was incorrectly adjusted, it was found that the Percentage Relative Bias (PRB) introduced into the estimates due to this adjustment is minimal (min: 0.007%, max: 0.109%) and coverage probability for estimates based on this incorrectly adjusted data is not significantly different from those of which is correctly not adjusted. …”
    Get full text
    Article
  6. 606
  7. 607

    Supercritical co2 extraction of African catfish (Clarias Gariepinus) oil and its fatty acid profile by Ferdosh, Sahena, Habib, Md Ashsan, Selamat, Jinap, Tariq, Abdul Razak, Sarker, Md. Zaidul Islam

    Published 2012
    “…Optimum points were obtained within the studied variables range at 65°C temperature, 35 MPa pressure, 2.6 mL/min flow rate and 3.6 h soaking time with maximum oil yield 66.96 and 40.6% from viscera and skin, respectively. …”
    Get full text
    Get full text
    Proceeding Paper
  8. 608

    Relationship between short duration and daily rainfall data in Kuala Lumpur by Salleh, Md. Noor, Al-Mamun, Abdullah, Mohamed Desa, Mohamed Nor, Mohamad Noor, Hanapi

    Published 2013
    “…Rainfall data of eleven different durations (15, 30, 45-min, 1, 2, 3, 6, 9, 12, 18 and 24-hr) were analysed to study the relationship with the daily rainfall data of each station. …”
    Get full text
    Proceeding Paper
  9. 609

    Growth and total carotenoid, chlorophyll a and chlorophyll b of tropical microalgae (Isochrysis sp.) in laboratory cultured conditions by Khan Chowdhury, Ahmed Jalal, Shamsudin, A.A, Rahman, M.F, Nurzatul , N.Z, Rozihan, M

    Published 2013
    “…Isochrysis sp. was cultured in f/2 medium at optimum light intensity (1200 Lux) with constant aeration (4.5 L min-1) at 8 pH. Salinity of the water was maintained between 20-24 g L-1 and temperature range was 20-24°C. …”
    Get full text
    Article
  10. 610

    Adsorption of cadmium from water by wasted biosolids by Al-Mamun, Abdullah, Alam, Md. Zahangir, Amid, Azura, Baharudin, Norhafizah Hanim

    Published 2013
    “…The parameters were biomass dose (mg/L), contact time (min), and agitation speed (rpm). Central Composite Design in DESIGN EXPERT® software had been chosen to investigate the relationship between the parameters. …”
    Get full text
    Get full text
    Proceeding Paper
  11. 611
  12. 612

    Multiplexing of reverse-transcription polymerase chain reaction for Hepatitis C virus genotyping by Hamzah, Hairul Aini, Mustafa Mahmoud, Mohammed Imad Al-Deen, Talib, Norlelawati A.

    Published 2013
    “…The bands (414 bp & 212 bp) could be cut simultaneously for the gel extraction and purification using MinElute Gel purification System (Qiagen, Germany) prior to cDNA sequencing. …”
    Get full text
    Proceeding Paper
  13. 613

    Screening of the process parameters for lipid production using mutant Synechococcus sp. PCC 7002 by Shari, Ummi S. Halmi, Zainal, Mus'ab, Azmi, Azlin Suhaida, Amid, Azura, Jimat, Dzun Noraini, Ahmad Raus, Raha, Muyibi, Suleyman Aremu, Mustafa, Iswaibah, Salleh, Noraini

    Published 2013
    “…The experimental design selected was Min-Run Res IV which consists of 12 runs and the response surfaces measured were specific growth rate and yield of lipid. …”
    Get full text
    Get full text
    Proceeding Paper
  14. 614

    Angiotensin II receptor blocker valsartan enhances glucose-induced insulin secretion by Ayob, Azizi, Hashim, Suhaimi, Azdan, Zulnizam, Abdul Razak, Tariq

    Published 2006
    “…The isolated ancreases were perfused with Kreb's solution containing bovine albumin (200 mg/dl) with low glucose (60 mg/dl) followed by high glucose (300 mg/dl) at a rate of 4 ml/min. The dose of Valsartan used was based on the peak plasma level achieved in human at standard single oral dose of 80 mg daily, which was 1.64 mg/L. …”
    Get full text
    Article
  15. 615
  16. 616

    Optimization of decolorization of methylene blue by lignin peroxidase enzyme produced from sewage sludge with Phanerocheate chrysosporium by Alam, Md. Zahangir, Mansor, Mariatul F., Khan Chowdhury, Ahmed Jalal

    Published 2009
    “…The validation of the model showed that the decolorization process gave the higher removal of 90% in agitation mode compared to the static mode with 65% for 60 min of incubation time by LiP enzyme.…”
    Get full text
    Article
  17. 617

    Development and validation of LC-MSMS bioanalytical method for the analysis of Amlodipine and gliclazide in Human plasma by Alaama, Mohammed, Helal Uddin, A.B.M., Mohamad, Huda Jamilah, Awang, Mohamed Saufi, Abbas, Syed Atif

    Published 2016
    “…The mobile phase consists of 0.1 % Formic acid and ACN with gradient elution program over 5 min. Results: The results of the intra-and inter-day precision and accuracy studies were well within the acceptable limits. …”
    Get full text
    Proceeding Paper
  18. 618

    Development and validation of high performance liquid chromatography method for analysis of Raloxifene HCl in rat plasma by liquid –liquid extraction by Mahmood, Syed, Bakhtiar, M. Taher, Mandal, Uttam Kumar

    Published 2016
    “…Separation of raloxifene from the treated samples was performed in a thermo-fisher syncronis RP- C18 column (150mm x 4.6 mm, 5μm particle size) at room temperature with a mobile phase containing acetonitrile and phosphate buffer of pH 6.1 (34:66 v/v) at a flow rate of 1 min/ml and ultraviolet detection at 285 nm. The developed method was validated for specificity, linearity, precision, accuracy, stability, sensitivity and recovery. …”
    Get full text
    Proceeding Paper
  19. 619

    Investigation of anticancer (breast cancer) activity of Moringa oleifera leaf extracts by Mirghani, Mohamed Elwathig Saeed, Ahmad Raus, Raha, Hossain, Nazia

    Published 2016
    “…The optimum condition was found to be temperature 50⁰C and incubation time 45 min with medium frequency at sonication and it obtained 88.39% cancer cell growth inhibition by this condition. …”
    Get full text
    Proceeding Paper
  20. 620

    Purification and characterization of surfactant-stable protease from Bacillus lichenformis: A potential additive for laundry detergent by Mardina, Vivi, Yusof, Faridah

    Published 2016
    “…The enzyme was stable at temperature range of 35 oC to 65 oC and also at pH 6.0 and 7.0 for 60 min. The presence of Mn2+ and Ca2+ ions in the produced protease stimulated strongly the activity of the enzyme by 176.65% and 119.07% respectively, while inhibitory effects were found in the presence of Cu2+, Zn2+, Mg2+, and EDTA. …”
    Get full text
    Get full text
    Article