Showing 5,121 - 5,140 results of 11,856 for search '(((link OR (((spinal OR spine) OR thin) OR aina)) OR five) OR ((spink OR pin) OR ming))', query time: 0.10s Refine Results
  1. 5121
  2. 5122
  3. 5123

    Vertical variation of lead, copper and manganese in core sediments collected from Tanjung Lumpur mangrove forest, Pahang, Malaysia by Yunus, Kamaruzzaman, Mohd Yusuf, Nurulnadia, Mohamad Shazili, Noor Azhar, Saad, Shahbudin, Bidai, Joseph

    Published 2011
    “…The average concentrations of Pb, Cu, and Mn in core samples were 36.28±7.04 μg/g dry weights, 50.17±5.84 μg/g dry weights, and 110.41±14.48 μg/g dry weights, respectively. …”
    Get full text
    Article
  4. 5124

    Radiation vulcanization of natural rubber latex loaded with carbon nanotubes by Atieh, Muataz Ali, Nazir, Nazif, Yusof, Faridah, Fettouhi, Mohammed, Ratnam, Chantara Thevy, Alharthi, Mamdouh, Abu-Ilaiwi, Faraj A., Mohammed, Khalid, Al-Amer, Adnan

    Published 2010
    “…The radiation vulcanization of natural rubber latex (NRL) has been carried out with 150 keV electrons beam with the presence of carbon nanotubes. …”
    Get full text
    Article
  5. 5125

    Analysis of engine performance with enhanced fuel by Ihsan, Sany Izan, Farid, Khairussani, Mel, Maizirwan, Mohiuddin, A. K. M.

    Published 2011
    “…Mitsubishi 4G 15 internal combustion four engine was tested with various percentages of ethanol mixed with gasoline starting trom 5%, 15%, 25% and 35%. The results show that by increasing the percentage of ethanol in the fuel, the engine can have more power as well as higher efficiency with low specific fuel consumption (SFC). …”
    Get full text
    Book Chapter
  6. 5126

    Gum Arabic: a narrative emulsifying agent by Mirghani, Mohamed Elwathig Saeed, Mel, Maizirwan, Misran, Fatimah

    Published 2011
    “…The optimal amount of GA used was 20% (w/v) and the temperature was 65°C, while the ratio of oil to aqueous phase was not affected directly.…”
    Get full text
    Book Chapter
  7. 5127

    Bioenergy from loeophyllum-Rhizopus fungal biofuel cell by Awang Bakar, Aimi Syahirah, Othman, Raihan, Yahya, Muhd Zu Azhan, Othman, Rashidi, Nik Din, Nik Mohd Suhaimi

    Published 2012
    “…Upon incubation period of 8 days, the Gloeophyllum-Rhizopus MFC is capable to deliver 5 mW of power output continuously for 21 days under uncontrolled, open ambient surroundings. …”
    Get full text
    Article
  8. 5128

    Fabrication of Bio-MEMS Nanostructure by focused ion beam by Ali, Mohammad Yeakub, Mohd Fuad, Nurul Hajar

    Published 2010
    “…The optimized values of Ra were 13.7 nm was obtained at acceleration voltage of 20 keV, dwell time of 15 μs and milled depth of 0.6 μm. …”
    Get full text
    Proceeding Paper
  9. 5129

    Aluminum-silicon carbide composites for enhanced physio- mechanical properties by Debnath, Sujan, Chee, Won Yeo, Rahman, Muhammad Ekhlasur, Reddy, Moola Mohan, Maleque, Md. Abdul, Ali, Mohammad Yeakub

    Published 2012
    “…Different weight fraction of Silicon carbide, SiC (5 wt%, 10 wt% and 15 wt %) particulate-reinforced AMMCs are fabricated and characterizations of physical and mechanical properties of the materials are performed based on the experimental. …”
    Get full text
    Article
  10. 5130

    Organizational approach to Total Quality Management: a case study by Islam, Rafikul, Mustafa, Mohamad Reeduan

    Published 2008
    “…Malaysian Administrative Modernization and Management Planning Unit (MAMPU) has outlined Total Quality Management (TQM) by means of seven core principles: (1) top management commitment, (2) strategic quality planning, (3) customer focus, (4) training and recognition, (5) enhancing teamwork, (6) performance measurement, and (7) quality assurance. …”
    Get full text
    Article
  11. 5131

    Theoretical study of atomic level understanding of the reactive ion etching (RIE) by Muhida, Rifki, Rahman, Md. Mamudur, Chowdhury, Md. Sazzad Hossien, Muhida, Riza, Zainuddin, Hishamuddin, Zakaria, Azmi, Kasai, Hideaki

    Published 2012
    “…By considering CO ions as reactive gases, we etch Fe ion from the cluster surface providing ion pentacarbonyl, i.e., Fe(CO)5. By density functional theory based first principle calculations, we calculate the potential energy surface(PES) of the system and describe the mechanism of the reaction. …”
    Get full text
    Article
  12. 5132

    Design of high gain microstrip Yagi array antenna for avalanche radar by Mohd. Isa, Farah Nadia, Brennan, P.V.

    Published 2012
    “…This paper presents the design and construction of a microstrip Yagi array antenna operating at 5.3 GHz, to be used with an avalanche sensor in avalanche measurement. …”
    Get full text
    Proceeding Paper
  13. 5133

    Thermal conductivity of carbon nanotube nanofluid—experimental and theoretical study by Walvekar, Rashmi Gangasa, Ismail, Ahmad Faris, Khalid, Mohammad

    Published 2012
    “…The concentration of CNTs was varied from 0.01–0.1 wt% while the concentration of GA was varied from 1–2.5 wt%, respectively. The effect of particle volume fraction and temperature on the thermal conductivity enhancement of the nanofluids was also studied. …”
    Get full text
    Article
  14. 5134

    Design and simulation of a thermoelectric cooling system for motorcyclist helmet by Hrairi, Meftah, Abdullah, Abdullah F., Ahmed, Mirghani Ishak

    Published 2012
    “…The numerical and experimental results showed a good agreement and indicated that the temperature inside the helmet was reduced from 25.5 °C to 19.3 °C in approximately 6 min.…”
    Get full text
    Get full text
    Proceeding Paper
  15. 5135

    Body mass index in the institionalised elderly people in Rumah Sri Kenangan by Wan Su, Kamaruzaman

    Published 1997
    “…The prevalence of low BMI (<20.0 kg/m2) was 50.0% and 17.6% of them had BMI below 17.5 kg/m2. There was no significant difference in the prevalence of low BMI between age (old and young elderly), gender (male and female) and ethnicity (Malay, Chinese and Indian). …”
    Get full text
    Get full text
    Article
  16. 5136

    Empirical modelling of vibration in micro end milling of PMMA by Ali, Mohammad Yeakub, Mohamed, Abd. Rahman, Khan, Ahsan Ali, Asfana, Banu, Lutfi, M., Fahmi, M. I.

    Published 2013
    “…The optimum solution for minimum average vibrationis 64.3 Hz with spindle speed 2500 rpm, feed rate 2 mm/min and depth of cut 1.5 ìm. These micro end milling parameters are suitable to machine PMMA to get high precision. …”
    Get full text
    Article
  17. 5137

    Study of cells attachment using impedance spectroscopy technique by Arifuzzaman, S. M., Nordin, Anis Nurashikin, Mel, Maizirwan, Spray, David, Voiculescu, Ioana

    Published 2011
    “…In this paper we report on the electrical impedance spectroscopy characterization of the attachment of two mammalian cell lines: endothelial cells (RFPEC) and fibroblast cells (V79). For electrical cell–substrate impedance sensing (ECIS) of the endothelial cells a commercially available eightwell cell culture impedance array (ECIS-8W1E) was used. …”
    Get full text
    Proceeding Paper
  18. 5138

    Characterization of the Baobab fruit shells as adsorbtion material by Mustafa, Monawar Munjid, Kabbashi, Nassereldeen Ahmed, Al-Khatib, Ma'an Fahmi Rashid, Alam, Md. Zahangir

    Published 2016
    “…This research is focused on the characterization of the Baobab fruit shells in terms of lignin (54.08%), cellulose (24.87%) and hemicellulose (21.05%) content, as well as proximate analysis such as ash content (5.17%), moisture content (6.48%), volatile matter (86.73%) and carbon content (1.22%). …”
    Get full text
    Proceeding Paper
  19. 5139

    Enhanced servo performance of a single axis positioning system in an intelligent robust framework by Raafat, Safanah M., Akmeliawati, Rini, Martono, Wahyudi

    Published 2010
    “…The main distinguishing features of this approach are: the accurate, fast identification of the uncertainty bounds using an adaptive neuro fuzzy inference system and the automatic tuning of the performance weighting function in accordance to performance requirements. v-gap measure is utilized to validate the intelligent identified uncertainty bounds for wider stability region. …”
    Get full text
    Proceeding Paper
  20. 5140

    The formation of carbon nanofibers on powdered activated carbon impregnated with nickel. by Ahmed, Yehya M., Al-Mamun, Abdullah, Muyibi, Suleyman Aremu, Al-Khatib, Ma'an Fahmi Rashid, Jameel, Ahmed Tariq, Al-Saadi, Mohammed A.

    Published 2009
    “…Variable weight percentage ratios of the catalyst salt (Ni+2) were used for the impregnation (1, 3, 5, 7 and 9%, respectively). The product displays a relatively high surface area, essentially constituted by the external surface, and the absence of the bottled pores encountered with activated carbon. …”
    Get full text
    Proceeding Paper