-
5061
Full-wave rectification of a low-voltage source
Published 2011“…The solution for this dilemma is 10 take thc AC voltage lind lectify it into a DC voltage supply (Scllaefer, 1%5; Baliga, 2010). To that end. many such circuits have been constructed. …”
Get full text
Book Chapter -
5062
CFD studies on natural convection heat transfer of Al2O3-water nanofluids
Published 2011“…This work is focused on numerical simulations of natural convection heat transfer in Al2O3-water nanofluids using computational fluid dynamics approach. Fluent v6.3 is used to simulate water based nanofluid considering it as a single phase. …”
Get full text
Article -
5063
Powder mixed micro electro discharge milling of titanium alloy: analysis of surface roughness
Published 2012“…The aim is to achieve minimum Ra value on titanium alloy (Ti-6Al-4V) machined with tungsten electrode for various level of concentration of SiC powder and discharge energy (E). …”
Get full text
Article -
5064
Forward masking threshold estimation using neural networks and its application to parallel speech enhancement
Published 2010“…Objective measures using PESQ demonstrates that our proposed forward masking model, provides significant improvements (5-15 %) over four existing models, when tested with speech signals corrupted by various noises at very low signal to noise ratios. …”
Get full text
Article -
5065
Powder Mixed Micro Electro Discharge Milling of Titanium Alloy: Analysis of Surface Roughness
Published 2011“…The aim is to achieve minimum Ra value on titanium alloy (Ti-6Al-4V) machined with tungsten electrode for various level of concentration of SiC powder and discharge energy (E). …”
Get full text
Proceeding Paper -
5066
Gelatinization properties of sago and wheat flour mixtures
Published 2003“…The peak temperature (Tp) and peak viscosity (Vp) increased with increasing sago in the sago-wheat mixtures. The setback values (5B) in sago-LPW mixtures were higher than in sago-HPW and sago-MPW mixtures. …”
Get full text
Article -
5067
Rheological behavior and stability of cassava starch for ceramic mould binder application
Published 2012“…Pseudoplastic or shear thinning behavior for both binder and slurry were observed starting at 0.13 Pa.s and 2.5 Pa.s respectively. Calcium carbonate (aragonite) slurry from starch binder however, exhibited viscoelastic behavior compare to colloidal silica sol. …”
Get full text
Article -
5068
Influence of energy parameters of micro WEDM on kerf
Published 2012“…Using a wire electrode of 70 μm diameter, a minimum kerf width is found to be 92 μm for the micro WEDM parameters of 0.01 μF capacitance and 90.25 V gap voltage. Around 30% increament of the kerf is found to be high. …”
Get full text
Article -
5069
The discrimination conundrum in the appointment of arbitrators in international arbitration
Published 2012“…However, the issue of racial and religious discrimination is of special interest and requires serious debate.This article attempts to discuss the issue of racial and religious discrimination in light of the recent decision of the Supreme Court of the United Kingdom in Jivraj v. Hashwani [2011] UKSC 40.The article tries to suggest a balanced view for promoting sustainable practices in international arbitration. …”
Get full text
Article -
5070
Surface roughness of sputtered silicon. II. Model verification
Published 2001“…The theoretical surface roughness was found to be within ±1 and ±5 nm of the measured surface roughness with the measurement uncertainty (standard deviation) of about ±0.36 and ±0.85 nm for R a and R t, respectively.…”
Get full text
Article -
5071
Trench DMOS interface trap characterization by three-terminal charge pumping measurement
Published 2012“…The charge pumping measurements showed very high source–drain current after approximately −2 V Vbase value. …”
Get full text
Article -
5072
Effects of neutron on reverse bias characteristics of commercially available SI and gaas diodes
Published 2012“…The diodes were irradiated using Pneumatic Transfer System facility at PUSPATI TRIGA reactor with neutron fluences up to (6.038 3.067) x1012 n /cm2.s for a period of 1, 3 and 5 minutes. The results showed an increase in leakage current for all diodes which may be due to the existence of neutron-induced displacement defects introduced into the semiconductor lattice. …”
Get full text
Article -
5073
Comparing metals adsorption by carbon adsorbents: evaluating absorption properties of different carbon adsorbents
Published 2012“…Optimum adsorption capacity of GAC and CNM were observed at pH 5 and 1 g/L dosage, while equilibrium adsorption conditions were generally noticed by 60 minutes of agitation at 100 rpm. …”
Get full text
Book -
5074
Adaptive Short Time Fourier Transform (STFT) analysis of Seismic Electric Signal (SES): A comparison of hamming and rectangular window
Published 2012“…During this period of time 5 earthquakes were recorded with magnitudes greater than 6R. …”
Get full text
Proceeding Paper -
5075
Straightforward synthesis of novel 1-(2'-α-O-D-glucopyranosyl ethyl) 2-arylbenzimidazoles
Published 2012“…A series of novel 1-(2'-α-O-D-glucopyranosyl ethyl) 2-arylbenzimidazoles has been prepared via one-pot glycosylation of ethyl-1-(2'-hydroxyethyl)-2-arylbenzimidazole-5-carboxylate derivatives. Synthesis of the 2-arylbenzimidazole aglycones from 4-fluoro-3-nitrobenzoic acid was accomplished in four high-yielding steps. …”
Get full text
Article -
5076
A comparative study of the difference between MFCC and PLP in the recognition of sound
Published 2013“…The identification rate using the RNN classifier and MFCC is 72.7%, 73.7%, 78.9% 57.1% and 58.3% for aircraft, car, rain, thunder and train respectively as compared to what was obtained by using MLP. 31.6%, 19.4%, 18.5%, 38.0% and 26.4% decline is achieved for aircraft, car, rain, thunder and train respectively when comparing between MLP and RNN for MFCC. …”
Get full text
Article -
5077
Effect of coupling agent on the mechanical properties of flame retardant PP/ATH nanocomposites
Published 2013“…Polymer nanocomposites containing polypropylene (PP) as the polymer matrix and nanofiller aluminium hydroxide (ATH) as the flame retardant filler were compounded with various loading of maleic anhydride grafted polypropylene, MAPP (0, 1, 2, 3, 5 wt %). All materials were mixed using melt mixing process and were further prepared using an injection moulding machine. …”
Get full text
Article -
5078
Cooling of motorcyclist helmet with thermoelectric module
Published 2013“…The numerical and experimental results showed a good agreement and indicated that the temperature inside the helmet was reduced from 25.5°C to 19.3°C in approximately 6 min.…”
Get full text
Article -
5079
Environmental friendly device: modeling of carbon nanotube with optimum chirality
Published 2013“…Finally the minimum value of CNT bandgap of 0.4401eV shows that the optimum chirality is (25,0) for the modeling of carbon nanotube. …”
Get full text
Article -
5080
A low-cost PC-based range finder system
Published 2013“…A numbers of test were done and found that the proposed system performances are good in terms of accuracy ±5%, simplicity,cost and power consumption.…”
Get full text
Article