-
141
-
142
Minutes of meeting. 2 February 1981
Published 1981“…Typewritten on a sheet of pink paper.…”
Get full text
Minutes -
143
-
144
A study of microwave induced plasmas
Published 1987“…Two 'analytical' MIP's incorporating sample aerosol introduction have been used with the slab-line cavity. One being supported on an argon flowrate of 0.1 1 min-1 using a Babing!…”
Get full text
Thesis -
145
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
146
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
147
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
148
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis -
149
Biomechanical evaluation and new improvement on ankle external fixator
Published 2023Get full text
Thesis -
150
Low-loss paper-substrate triple-band-frequency reconfigurable microstrip antenna for sub-7 GHz applications
Published 2023“…In this paper, a low-cost resin-coated commercial-photo-paper substrate is used to design a printed reconfigurable multiband antenna. The two PIN diodes are used mainly to redistribute the surface current that provides reconfigurable properties to the proposed antenna. …”
Get full text
Get full text
Article -
151
-
152
Novel opto-electronic and plastic fibre sensors
Published 1998“…Experimental results obtained confirm the long and linear operational range of the sensor (between 15 mm and 90 mm for a mirror target and between 20 mm and 100 mm for a matt white paper target). …”
Get full text
Thesis -
153
A comprehensive review on theoretical framework-based electric vehicle consumer adoption research
Published 2017“…As a part of long-term benefits, the adoption of EVs gives environmentally friendly innovation to society. …”
Article -
154
Localizatation estimation usign the technique of multi-sequence positioning
Published 2015“…The result showed that MSP showed more efficiently in short and long range as compared to TOA. However, RSS proven to perform better than MSP in long range estimation. …”
Get full text
Get full text
Get full text
Thesis -
155
Measurement and modelling of operational amplifier power supply rejection
Published 1995“…Measured results for 741 and pin-compatible operational amplifiers are tabulated. …”
Get full text
Article -
156
Sustainable firm performance of green supply chain management practice at petrochemical industry
Published 2020“…Therefore, to achieve the industry sustainability it is a need to have Green Supply Chain Management (GSCM) model toward petrochemical industry sustainability in line with the Green Industry Long Run Strategic Plan in Indonesia. …”
Get full text
Get full text
Get full text
Thesis -
157
Wideband and multiband antennas for multi-configuration mode applications
Published 2023Get full text
Thesis -
158
Photonic controlled metasurface for intelligent antenna beam steering applications including 6G mobile communication systems
Published 2023“…This paper presents a novel metasurface antenna whose radiation characteristics can be remotely controlled by optical means using PIN photodiodes. The proposed reconfigurable antenna is implemented using a single radiating element to minimize the size and complexity. …”
Get full text
Get full text
Article -
159
Cost-aware real-time divisible loads scheduling in cloud computing
Published 2024Get full text
Thesis -
160
Sustainable supply chain management in construction: an exploratory review for future research
Published 2022“…Although the importance of supply chain management in the construction sector has been recognized in recent years, its implementation still faces significant challenges. For the long-term evaluation of this creative sector, numerous intricate sustainability components, such as environmental, social, and financial, are necessary. …”
Get full text
Article