-
181
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
182
MHD stagnation flow of nanofluid past a permeable shrinking surface with various conditions
Published 2018“…The purpose of the present study is to analyze the effects of slip and heat source/sink on magnetohydrodynamic stagnation-point flow and heat transfer past a permeable shrinking surface with convective boundary condition. …”
Get full text
Get full text
Get full text
Thesis -
183
Preparation of injection moulding processing for high density polyethylene via moldflow advisor 2015 simulation
Published 2018“…Both simulation and practical results have no sink marks. Therefore, it can be concluded that the simulation process had provided a good prediction for practical injection moulding preparation. …”
Article -
184
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
185
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
186
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis -
187
Radiative MHD Boundary Layer Flow and Heat Transfer Characteristics of Fe-Casson Base Nanofluid over Stretching/Shrinking Surface
Published 2024“…This paper considers the MHD boundary layer flow and heat transfer characteristics of FeCasson-based nanofluid over an exponentially stretching/shrinking surface, including heat source/sink and Newtonian heating effects. In this regard, to develop the system of the governing equations, the one phase model named as Tiwari and Das model is considered with iron nanoparticles. …”
Get full text
Article -
188
Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing
Published 2023“…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
Get full text
Article -
189
Performance of various forecasting algorithms to reduce the number of transmitted packets by sensor node in wireless sensor networks
Published 2018“…Additionally, in terms of absolute error in the data at the sink, the EDCD1 algorithm shows the best performance with less average error at 2.2803 for all sensors compared to others algorithms.…”
Get full text
Get full text
Get full text
Thesis -
190
Electrode Wear Rate of RBD Palm Oil as Dielectric Fluids on Electrical Discharge Machining (EDM) at Different Peak Current and Pulse Duration of Titanium Alloys
Published 2024“…The lowest EWR for kerosene and RBD palm oil is 0.0416mm3/min and 0.0480mm3/min, respectively, at the same IP=6A and ton=150µs. …”
Get full text
Article -
191
Biomechanical evaluation and new improvement on ankle external fixator
Published 2023Get full text
Thesis -
192
-
193
Novel opto-electronic and plastic fibre sensors
Published 1998“…Experimental results obtained confirm the long and linear operational range of the sensor (between 15 mm and 90 mm for a mirror target and between 20 mm and 100 mm for a matt white paper target). …”
Get full text
Thesis -
194
Low-loss paper-substrate triple-band-frequency reconfigurable microstrip antenna for sub-7 GHz applications
Published 2023“…In this paper, a low-cost resin-coated commercial-photo-paper substrate is used to design a printed reconfigurable multiband antenna. The two PIN diodes are used mainly to redistribute the surface current that provides reconfigurable properties to the proposed antenna. …”
Get full text
Get full text
Article -
195
Wideband and multiband antennas for multi-configuration mode applications
Published 2023Get full text
Thesis -
196
Measurement and modelling of operational amplifier power supply rejection
Published 1995“…Measured results for 741 and pin-compatible operational amplifiers are tabulated. …”
Get full text
Article -
197
Photonic controlled metasurface for intelligent antenna beam steering applications including 6G mobile communication systems
Published 2023“…This paper presents a novel metasurface antenna whose radiation characteristics can be remotely controlled by optical means using PIN photodiodes. The proposed reconfigurable antenna is implemented using a single radiating element to minimize the size and complexity. …”
Get full text
Get full text
Article -
198
Development of coated peanut separator and frying skillet machine
Published 2018“…The groundnut is sticking and become like a ping pong size ball and the time consuming to fry is longer. …”
Get full text
Article -
199
Hydromagnetic radiative effect on water, kerosene based on single walled carbon nanotubes induced by a stretching/shrinking sheet with viscous-ohmic dissipation
Published 2018“…The influence on the velocity and temperature are presented both in tabular and graphical forms for various parameter such as magnetic field parameter (M), thermal radiation parameter (N), nonlinear parameter (m), Richardson number (RI), heat source parameter (�), heat sink parameter (…”
Get full text
Get full text
Get full text
Thesis -
200