-
381
Preparation of injection moulding processing for high density polyethylene via moldflow advisor 2015 simulation
Published 2018“…Both simulation and practical results have no sink marks. Therefore, it can be concluded that the simulation process had provided a good prediction for practical injection moulding preparation. …”
Article -
382
Electrode Wear Rate of RBD Palm Oil as Dielectric Fluids on Electrical Discharge Machining (EDM) at Different Peak Current and Pulse Duration of Titanium Alloys
Published 2024“…The lowest EWR for kerosene and RBD palm oil is 0.0416mm3/min and 0.0480mm3/min, respectively, at the same IP=6A and ton=150µs. …”
Get full text
Article -
383
Biodiesel production from sludge palm oil by ultrasonic energy
Published 2009“…The reduction of free fatty acids (FFAs) was measured at different sonication time from 30-300 min and the optimum time was determined. It is reasonable to conclude that the conversion of FFAs to fatty acid methyl ester by applying ultrasonic energy is related to long sonication time. …”
Get full text
Proceeding Paper -
384
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
385
Yam contributes to improvement of glucose metabolism in rats
Published 2009“…Insulin levels at 30 min and 60 min were significantly lower than those in the control group. …”
Get full text
Article -
386
A New Design and Simulation of Smart Sensing for Emergency Vehicle
Published 2024“…The sensor can detect the sound of emergency vehicles and respond immediately to them by signalling smaller parallel visitors to change the screen from pink to green or vice versa. Therefore, this flow reduces the travel time required for emergencies.…”
Get full text
Article -
387
-
388
Effect of high velocity oxy-fuel (HVOF) coatings on fatigue behaviour of carbon steel
Published 2021“…Tensile test was carried out with a strain rate of 0.5 mm/min and a dog bone shaped specimen in accordance with ASTM-E8 standard. …”
Get full text
Get full text
Get full text
Thesis -
389
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
390
Enrichment of fruit wastes with white rot fungi under submerged state bioconversion
Published 2013“…On Banana and Pineapple (BPin) the protein content were recorded as18.05 and 15.75 mg/g, which was higher than Papaya and Pineapple (PinPw) and Banana and Papaya (BPw)composite. M6 has 15.4 and 9.78 mg/g on BPinPw, 13.84 and 13.59 mg/g on BPw, 20.82, and 22.97 mg/g on BPin and 18.29 and 11.59 mg/g on PinPw. …”
Get full text
Proceeding Paper -
391
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
392
-
393
The system architecture of E-braille by using the microcontroller and external controller unit
Published 2016“…This refreshable braille cell can refresh the character. The pin for each braille cell is controlled by using piezoelectric bimorph. …”
Get full text
Get full text
Article -
394
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…This consists of a densely crossllnked core of mainly diester crosslinks, surrounded by a less densely crosslinked network containing more ether crosslinks. …”
Get full text
Thesis -
395
Automated platform for histological race and sex comparison of human cortical bone
Published 2019“…Validation of the system was divided into two main parts. In first part, parameter measurement and calculation performed by the system were compared with existing tools in terms of percentage error in measurement (DinoCapture: 5.3%, L-measure: 5.1%, ImageJ: 4.7%, designed system: 4.0%) and consumed time for measurement (DinoCapture: 15-20min, L-measure: 15-20min, ImageJ: 20-25min, designed system: 1-2min). …”
Get full text
Get full text
Get full text
Thesis -
396
Radiative MHD Boundary Layer Flow and Heat Transfer Characteristics of Fe-Casson Base Nanofluid over Stretching/Shrinking Surface
Published 2024“…This paper considers the MHD boundary layer flow and heat transfer characteristics of FeCasson-based nanofluid over an exponentially stretching/shrinking surface, including heat source/sink and Newtonian heating effects. In this regard, to develop the system of the governing equations, the one phase model named as Tiwari and Das model is considered with iron nanoparticles. …”
Get full text
Article -
397
Ultrasonic and electroplating approach for washcoat of γ-alumina and nickel oxide (nio) catalyst on fecral substrate for catalytic converter
Published 2018“…Several problems in developing CATCO such as washcoat layer is spalling since the loose adhesion and unstable oxide growth in long term oxidation. Therefore, the main objective of this study are to embed γ-Al2O3 into substrate, to improve thermal stability as well as to improve conversion efficiency of exhaust gas emission. …”
Get full text
Get full text
Get full text
Thesis -
398
-
399
Evaluation of classifiers in a pressure and latency-based typing biometric system
Published 2011“…System authentication in present time relies on validation by some sort of a password or Personal Identification Number (PIN). However, if an intruder discovers this password or PIN, the user’s account can be easily compromised. …”
Get full text
Proceeding Paper -
400