Showing 881 - 899 results of 899 for search '(((pin OR min) OR ((spinge OR slingge) OR spie)) OR ((lisa OR fins) OR sping))', query time: 0.07s Refine Results
  1. 881

    Dietary effect of red paprika used to enhance the coloration of red tilapia (oreochromis niloticus) by H. Amiruddin, M., Norhalis, M. F., Sumarwati, Sri, Rashid, Y. Norma

    Published 2021
    “…The result of this research showed that the caudal and dorsal either muscle or fin showed the highest color at the fish which fed with 8% red paprika. …”
    Get full text
    Article
  2. 882

    Heat transfer enhancement in a rectangular duct by using winglet and nanofluids by Ghitheeth Al-Challabi, Ali Hussein

    Published 2014
    “…These vortices disrupt the growth of the thermal boundary layer and serves to bring about heat transfer enhancement between the fluid and the fin surfaces. The geometrical configuration considered in this study is representative of a channel with winglets spread over three rows each row 13 a pair of winglets. …”
    Get full text
    Get full text
    Thesis
  3. 883

    Ballistic impact fracture behaviour of continuous fibre reinforced al-matrix composites by Ali, Al-Hamdan, Nimir, Yassin Lutfi Mahmud, Mustafa, Ramadan J.

    Published 2010
    “…The materials response under high energy impact loads was studied using a gas gun. The projectiles were pins 1.2-1.5 mm in diameter and weighing 0.347-0.435 g. …”
    Get full text
    Article
  4. 884

    Modeling of a turning tool holder with finite elements and simulation of its free vibration frequencies by Jaafar, Israd Hakim, Shaik Dawood, Mohd. Sultan Ibrahim, Amin, A. K. M. Nurul, Shah, Qasim Hussain

    Published 2012
    “…This latter difference is unavoidable, due to the experimental test setup whereby the tool holder is clamped within the fixture with only 2 pins as opposed to the more rigid boundary condition applied to the finite element model, whereby the whole holder length within the carriage is rigidly supported at the element nodes. …”
    Get full text
    Article
  5. 885

    Utilization of Business Analytics by SMEs in Halal Supply Chain Management Transactions by Marjudi, Suziyanti, Setik, Roziyani, Raja Lope Ahmad, Raja Mohd Tariqi, Wan Hassan, Wan Azlan, Md Kassim, Aza Azlina

    Published 2023
    “…This creates a holistic Halal Financial technology (FinTech) transaction permissibility dashboard, increasing the effectiveness of HSCMT for Malaysia Halal SME Owners (MHSO) by an average usability score of 83.67%. …”
    Get full text
    Article
  6. 886

    Experimental and numerical investigation of suddenly expanded flow field for supersonic Mach numbers with and without annular cavities by Quadros, Jaimon Dennis, Khan, Sher Afghan, Prashanth, T.

    Published 2020
    “…The experimental results showed that the base pressure fin the suddenly expanded flow field was significantly influenced by annular cavities for low area ratios and high nozzle pressure ratios. …”
    Get full text
    Article
  7. 887
  8. 888

    Utilization of Business Analytics by SMEs in Halal Supply Chain Management Transactions by Marjudi, Suziyanti, Setik, Roziyani, Raja Mohd Tariqi Raja Lope Ahmad, Raja Mohd Tariqi Raja Lope Ahmad, Wan Hassan, Wan Azlan, Md Kassim, Aza Azlina

    Published 2023
    “…This creates a holistic Halal Financial technology (FinTech) transaction permissibility dashboard, increasing the effectiveness of HSCMT for Malaysia Halal SME Owners (MHSO) by an average usability score of 83.67%. …”
    Get full text
    Article
  9. 889
  10. 890
  11. 891
  12. 892

    Prediction of sedimentation and bank erosion due to the construction of Kahang Dam by Nda, Muhammad

    Published 2020
    “…This research used the Artificial Neural Network (ANN) and ANN with Autoregressive (AR) (NNETAR) in predicting suspended sediment concentration using sediment concentration, discharge and water level as inputs. Similarly, erosion pins were installed on four transects to monitor the riverbank for thirteen months. …”
    Get full text
    Get full text
    Get full text
    Thesis
  13. 893
  14. 894
  15. 895

    Effect of dual flocculant by unmodified manihot esculenta starch and aluminium sulphate on the removal of chemical oxygen demand optimized by response surface methodology by Rahmat, S., Othman, N, Ahmad, S. N., Asharuddin, S. M.

    Published 2024
    “…Besides the performance of COD removal increased, the dosage of the chemical coagulant was reduced by up to 64% at the optimum condition of 18 mg/L alum dosage, 307 mg/L starch dosage, pH 9, and 27 mins settling time. The analysis of variance (ANOVA) indicated that the quadratic model was significantly developed with a p-value < 0.05. …”
    Get full text
    Conference or Workshop Item
  16. 896
  17. 897

    Green approach to treat institutional wastewater by using cassava peels starch (CPS) as coagulant aid by Kumar, Vicky

    Published 2018
    “…Removal efficiency of dual coagulant (alum+CPS) were achieved at optimum dosage of 40:60 mg/L at pH 8 with 60 mins settling time with removal efficiency of COD (41%), TSS (86%) and Turbidity (91%). …”
    Get full text
    Get full text
    Get full text
    Thesis
  18. 898

    Green synthesis, characterization and laser irradiation of silver nanoparticles and its bimetallic nanoparticles by Saleh Mubarak, Salah

    Published 2020
    “…In contrast, Ag/Cu NPs were synthesized by mixing Cu solution (1, 3, 5 and 7 mM) with Gre-Ag NPs at room temperature and left for 10 mins. Moreover, the silver nanostructures (Ag NSs) was fabricated by manipulating Gre-Ag NPs with diode laser 450 nm at different times. …”
    Get full text
    Get full text
    Get full text
    Thesis
  19. 899

    In vitro bioactivities of anodised titanium in mixtrue of B-Glycerophosphate and calcium acetate for biomedical application by Lee, Te Chuan

    Published 2016
    “…The parameters for anodic oxidation method such as applied voltage (50-350 V), current density(10-70 mA.cm-2), electrolyte concentration (0.02 M β-GP + 0.2 M CA, 0.04 M β-GP + 0.04 M CA) , anodising time (5-10 mins), agitation speed (300-1500 rpm), ultrasonic amplitude (20-60 μm) and bath temperature (4-100 °C) were varied to investigate the impact on the surface properties of titanium. …”
    Get full text
    Get full text
    Get full text
    Thesis