-
141
-
142
-
143
-
144
-
145
A study of microwave induced plasmas
Published 1987“…Two 'analytical' MIP's incorporating sample aerosol introduction have been used with the slab-line cavity. One being supported on an argon flowrate of 0.1 1 min-1 using a Babing!…”
Get full text
Thesis -
146
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…This suggests a possible link in the deformation processes under either stress. …”
Get full text
Thesis -
147
-
148
Neutral point inverter controller using H infinity techniques
Published 2014“…For applications in renewable energy and distributed generation, there is often a need to have a neutral line to provide a current path. This can be achieved by using a neutral-point circuit that consists of a conventional neutral leg and a split dc link. …”
Get full text
Get full text
Get full text
Thesis -
149
Novel opto-electronic and plastic fibre sensors
Published 1998“…The middle POF is coupled to a red LED and emits light onto a flat target with the two outer fibres receiving the reflected light from the target and guiding it to two silicon PIN photodiodes. Theoretical investigations on the behaviour of the sensor are presented for ranges between 0 mm and 100 mm, and for targets with different reflectivities. …”
Get full text
Thesis -
150
In vitro growth of human keratinocytes and oral cancer cells into microtissues: an aerosol-based microencapsulation technique
Published 2017“…In this paper, we proposed a growth of microtissue model for the human keratinocytes (HaCaT) cell line and an oral squamous cell carcinoma (OSCC) cell line (ORL-48) based on a simple aerosol microencapsulation technique. …”
Get full text
Article -
151
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
152
A modified weight optimisation for higher-order neural network in time series prediction
Published 2020“…The MCS-MCMC results is further benchmarked with the standard Multilayer Perceptron, standard Pi-Sigma Neural Network (PSNN), Pi-Sigma Neural Network-Modified Cuckoo Search, Pi-Sigma Neural Network-Markov chain Monté Carlo, standard Functional Link Neural Network (FLNN), Functional Link Neural Network-Modified Cuckoo Search and Functional Link Neural Network-Markov chain Monté Carlo which emphasis in optimising the accuracy rate. …”
Get full text
Get full text
Get full text
Thesis -
153
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
154
Antivirals for broader coverage against human coronaviruses
Published 2024“…Spike is also not applicable for targeting other HCoVs as these are not well-conserved sequences among human CoVs. …”
Get full text
Article -
155
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
156
Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing
Published 2023“…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
Get full text
Article -
157
Biomechanical evaluation and new improvement on ankle external fixator
Published 2023Get full text
Thesis -
158
Optimization of received power and SNR for an indoor attocells network in visible light communication
Published 2019“…In this paper, the optical attocells configuration and LEDs distribution are proposed for optimizing the received power and Signal-to-Noise Ratio (SNR) in the Line of Sight (LOS) propagation link. Besides that, the trade-off between minimum SNR and received power are investigated. …”
Get full text
Article -
159
Low-loss paper-substrate triple-band-frequency reconfigurable microstrip antenna for sub-7 GHz applications
Published 2023“…In this paper, a low-cost resin-coated commercial-photo-paper substrate is used to design a printed reconfigurable multiband antenna. The two PIN diodes are used mainly to redistribute the surface current that provides reconfigurable properties to the proposed antenna. …”
Get full text
Get full text
Article -
160
An antenna array utilizing slotted conductive slab: inspired by metasurface and defected ground plane techniques for flexible electronics and sensors operating in the millimeter‑wa...
Published 2023“…The antenna array is excited through a single microstrip line. The radiating elements in the array are interconnected to each other with a microstrip line. …”
Get full text
Get full text
Article