-
441
Active vibration isolation system to improve free space optics communication
Published 2013“…A Free Space Optics (FSO) link consists of a transmitter and a receiver telescope which requires a continuous alignment for successful transmission of data. …”
Get full text
Article -
442
Enchancing QoS protection in MPLS networks
Published 2010“…In fact, QoS is important for interactive voice and video application and for specific clients. However, link failure always incurs delay and packet losses of the traffic passing through the failed link. …”
Get full text
Proceeding Paper -
443
Neutral point inverter controller using H infinity techniques
Published 2014“…This can be achieved by using a neutral-point circuit that consists of a conventional neutral leg and a split dc link. In this project, a H infinity (H∞ ) current controller is proposed to force the current flowing through the split dc link to be nearly zero so that the neutral-point current is stable, and then, a current control loop is added to eliminate the imbalance of the current so that the neutral-point current is balanced with respect to the dc terminals. …”
Get full text
Get full text
Get full text
Thesis -
444
How to assess ankle osteoarthritis: comparison of the Kellgren and Lawrence scale with functional outcome and digital image analysis
Published 2012“…Functional outcome was assessed with the AOFAS Hindfoot score. Bone density and minJSW were measured using a previously validated Ankle Image Digital Analysis software (AIDA). …”
Get full text
Article -
445
-
446
-
447
Mas Cotek (Ficus deltoidea): a possible supplement for Type II Diabetes: (a pilot study)
Published 2011Get full text
Book Chapter -
448
Non-invasive measurement method of skin conditions by using Dermalab® combo
Published 2014“…The readings were taken on volar forearm of the volunteers were taken using TEWL probe and hydration pin probe. A set of questionnaire was also distributed to obtain the information about the skin care regime and their daily habits. …”
Get full text
Proceeding Paper -
449
Providing feedback for students' drafts in academic writing: can developmental Rubric do the trick?
Published 2015“…Teachers were able to specifically pin-point the areas where students needed to improve their academic writing. …”
Get full text
Proceeding Paper -
450
Formation of Fe-C-Si ternary composite coating on CP-titanium and its tribological interaction with Jatropha oil
Published 2016“…The wear behavior of coated CP-titanium was performed using pin-on-disk machine at room temperature under Jatropha-biodiesel lubricated condition. …”
Get full text
Proceeding Paper -
451
A Novel MIMO antenna integrated with a solar panel and employing AI-equalization for 5G wireless communication networks
Published 2024“…We demonstrate that the directivity of this antenna array can be precisely electronically reconfigured using PIN diode switches. Additionally, we show the feasibility of integrating solar panels with the proposed MIMO antenna array. …”
Get full text
Get full text
Article -
452
Design of microstrip ultra wide band antenna with two notch filters for wireless communication
Published 2015“…In order to add reconfigurable characteristics to the patch antenna, two copper strips are putted on the slots to represent the ON and OFF switching status of an ideal Pin diode. By using this simple switching technique, the current distribution of the patch changes and enables the antenna to have four modes of operation. …”
Get full text
Get full text
Get full text
Thesis -
453
Theoretical analysis of photoparametric amplifier
Published 2010“…The second method is to use Optiwave software in implement is the photo parametric amplifier circuit. Photo diode PIN type has been used to detect any coming signal at the receiver circuit. …”
Get full text
Get full text
Get full text
Thesis -
454
Ultrasound-assisted extraction of valuable compounds from winter melon (Benincasa hispida) seeds
Published 2013“…Effects of amplitude (25-75%), temperature (40-60°C) and sonication time (20-60 min) on crude extraction yield (CEY) and radical scavenging activities (RSA, % inhibition of DPPH˙ and ABTS˙+ free radicals) of extracts were determined using complete randomised design (CRD). …”
Get full text
Article -
455
High performance liquid chromatographic method for Iso-a-Acids
Published 2006“…The mobile phase contains acetonitrile-water- H3PO4 (50 : 50 : 0.01, v/v/v) and is used with a Phenomenex Hypersil 5 m C18 column 250 � 4.6 mm, flow rate 1.5mL/min. Baseline separation of all 6 isomers was achieved with a total run time of 25 min. …”
Get full text
Article -
456
Microstructure and tensile properties of friction stir processed Al-Si alloy
Published 2018“…Samples were subjected to FSP using fixed tool rotation speed 1400 rpm and traverse speed 42 mm/min, with tool angle tilted 3˚.The influence of the FSP on the microstructure and tensile properties of the cast AlSi-Cu-Ni alloy samples were studied. …”
Get full text
Article -
457
Fatty acid composition of Malaysian giant mudskipper (Periophthalmodon schlosseri) fish oil
Published 2010“…An HP-5 non-polar capillary column was used and the temperature was initially kept at 50oC for 2 min and then programmed at 5oC min-1 to 250oC. …”
Get full text
Get full text
Get full text
Proceeding Paper -
458
Eco-friendly machining of T6061 aluminium alloy using titanium carbonitride (TiCN) coated tools
Published 2012“…The optimum cutting parameters for machining T6061 Aluminium alloy using TiCN coated tool is found; 333 m/min (water based) and 415 m/min (palm oil) at a depth of cut of 0.4 mm and feed rate of 0.6 mm/rev.…”
Get full text
Article -
459
A comparative study of the effectiveness of β-glucosidase immobilized on CNT-nanoparticles and Ca-alginate beads
Published 2014“…The Michaelis constants, Km and Vmax, determined using Langmuir linearized plot are respectively 0.09048 μmol/mL and 0.00989 μmol/mL.min for immobilized Ca-alginate; and 0.0985 μmol/mL and 0.01237 μmol/mL.min for immobilized MWCNT. …”
Get full text
Get full text
Proceeding Paper -
460
Multi-response optimizations for high speed ductile mode machining of soda lime glass
Published 2015“…Obtained results demonstrated that optimal combination of the response parameters, 0.78 μm Ra, 107 μm (Tw) and 0.56 min (Tl) were achieved with maximum desirability 77%, at the lowest depth of cut 20 μm at spindle speed of approximately 40000 rpm with feed rate of 69 mm/min.…”
Get full text
Get full text
Article