-
181
Rites of intent: the participatory dimension of the city
Published 2014Subjects: Get full text
Book Section -
182
-
183
Unfinished architecture: urban continuity in the age of the complete
Published 2015Subjects: Get full text
Book Section -
184
The commercial street as “frozen” festival: a study in Chinese mercantile traditions
Published 2018Subjects: Get full text
Article -
185
-
186
-
187
A study on laser engraving process parameters and performance characteristics for wood base materials
Published 2018“…This research presents a study on the parameter of laser engraving on pine wood and WPC materials by using EleksMaker Laser A5-Pro model with low diode laser (500Mw, 405nm wavelength). …”
Get full text
Get full text
Get full text
Thesis -
188
Holocene environmental change in the Scottish Highlands: multi-proxy evidence from blanket peats
Published 1997“…This thesis seeks to investigate the Holocene environmental history of two areas of Northern Scotland with specific reference to the evidence for pine woodland density variations and tree-line dynamics. …”
Get full text
Thesis -
189
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
190
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
191
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
192
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis -
193
Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing
Published 2023“…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
Get full text
Article -
194
Biomechanical evaluation and new improvement on ankle external fixator
Published 2023Get full text
Thesis -
195
Novel opto-electronic and plastic fibre sensors
Published 1998“…Experimental results obtained confirm the long and linear operational range of the sensor (between 15 mm and 90 mm for a mirror target and between 20 mm and 100 mm for a matt white paper target). …”
Get full text
Thesis -
196
Low-loss paper-substrate triple-band-frequency reconfigurable microstrip antenna for sub-7 GHz applications
Published 2023“…In this paper, a low-cost resin-coated commercial-photo-paper substrate is used to design a printed reconfigurable multiband antenna. The two PIN diodes are used mainly to redistribute the surface current that provides reconfigurable properties to the proposed antenna. …”
Get full text
Get full text
Article -
197
-
198
Core power control analysis and design for triga nuclear reactor
Published 2023Get full text
Thesis -
199
-
200
Wideband and multiband antennas for multi-configuration mode applications
Published 2023Get full text
Thesis