-
301
The tribological behaviour of Fe-C-Al cast iron – effect of temperature
Published 2013“…The wear and friction tests were conducted using universal pin-on-disk machine at 25 0C, 100 0C, 200 0C and 300 0C temperature. …”
Get full text
Article -
302
Low-loss paper-substrate triple-band-frequency reconfigurable microstrip antenna for sub-7 GHz applications
Published 2023“…In this paper, a low-cost resin-coated commercial-photo-paper substrate is used to design a printed reconfigurable multiband antenna. The two PIN diodes are used mainly to redistribute the surface current that provides reconfigurable properties to the proposed antenna. …”
Get full text
Get full text
Article -
303
-
304
Biotar ironmaking using wooden biomass and nanoporous iron ore
Published 2009“…In our experiments, three types of iron ores containing different amounts of combined water (CW; 1.6, 3.8, and 9.0 mass %) were first dehydrated at 450 °C to make them porous and then heated with pine tree biomass at 500-600 °C for the gasification and the tar vapor generated was decomposed to deposit carbon within/on the porous ores. …”
Get full text
Article -
305
Physico-mechanical properties of polymer concrete containing micro-filler of palm oil fuel ash
Published 2018“…Objective of this study is to present a research conducted on ground (fine) and unground (coarse) POFA in polymer concrete (PC) followed by determination on the physico-mechanical properties of PC. …”
Article -
306
Bitumen modification using oil palm fruit ash for stone mastic asphalt
Published 2024Get full text
Thesis -
307
AI-powered COVID-19 forecasting: a comprehensive comparison of advanced deep learning methods
Published 2024“…Bayesian optimization was also implemented to fine-tune these models. Results: The evaluation framework revealed that each model exhibited different levels of predictive accuracy and precision. …”
Get full text
Article -
308
AI-powered COVID-19 forecasting: a comprehensive comparison of advanced deep learning methods
Published 2024“…Bayesian optimization was also implemented to fine-tune these models. Results: The evaluation framework revealed that each model exhibited different levels of predictive accuracy and precision. …”
Get full text
Article -
309
Influence of mesh sizes and orientations on expanded aluminium sheets on tensile performances
Published 2022“…According to the results of the experiment, specimens with fine mesh have higher tensile stress, which is 44.90 MPa for fine mesh specimens with a 30° orientation, compared to medium and coarse mesh sizes, which have the lowest strength, which is 7.06 MPa for coarse mesh specimens with a 60° orientation. …”
Get full text
Conference or Workshop Item -
310
The Exploration of the Characteristics of Concrete Incorporating Ultrafine Coal Bottom Ash and Spent Garnet
Published 2024“…Two such materials, ultrafine coal bottom ash (uCBA) and spent garnet (SG), have shown potential as substitutes for cement and fine aggregate, respectively. This research examines the effectiveness of uCBA as a partial replacement for cement and SG as a partial replacement for fine aggregate in concrete, at varying levels of 3%, 6%, and 9% for uCBA and 10%, 20%, and 30% for SG. …”
Get full text
Article -
311
The Exploration of the Characteristics of Concrete Incorporating Ultrafine Coal Bottom Ash and Spent Garnet
Published 2024“…Two such materials, ultrafine coal bottom ash (uCBA) and spent garnet (SG), have shown potential as substitutes for cement and fine aggregate, respectively. This research examines the effectiveness of uCBA as a partial replacement for cement and SG as a partial replacement for fine aggregate in concrete, at varying levels of 3%, 6%, and 9% for uCBA and 10%, 20%, and 30% for SG. …”
Get full text
Article -
312
Wideband and multiband antennas for multi-configuration mode applications
Published 2023Get full text
Thesis -
313
On phase separation points for one-dimensional models
Published 2009“…In the paper, the one-dimensional model with nearest-neighbor interactions In, n ∈ Z, and the s pin values ±1 is considered. It is known that, under some conditions on parameters of In, a phase transition occurs for this model. …”
Get full text
Article -
314
Measurement and modelling of operational amplifier power supply rejection
Published 1995“…Measured results for 741 and pin-compatible operational amplifiers are tabulated. …”
Get full text
Article -
315
Performance of asphalt pavement containing potential cool paving materials
Published 2023Get full text
Thesis -
316
A modified savonius turbine with moveable blades for higher efficiency
Published 2024Get full text
Thesis -
317
-
318
Photonic controlled metasurface for intelligent antenna beam steering applications including 6G mobile communication systems
Published 2023“…This paper presents a novel metasurface antenna whose radiation characteristics can be remotely controlled by optical means using PIN photodiodes. The proposed reconfigurable antenna is implemented using a single radiating element to minimize the size and complexity. …”
Get full text
Get full text
Article -
319
Characterisation of surface texture using AFM with trimmed probe tip
Published 2006“…A comparison of the scanning results with analytical calculation showed that the trimmed tips were superior in imaging the profile for both the hole shaped and pin shaped microfeatures. But when using the trimmed high aspect ratio tip, the scanning speed was significantly low. …”
Get full text
Article -
320
Distraction osteogenesis over intramedullary nail : a report of two cases
Published 2006“…The healing index was 19.5 days/cm and 14.8 days/cm respectively, compared favorably to 30 days/cm with traditional method of distraction osteogenesis. There were mild pin tract infections and joint stiffness which responded to non-operative treatment.…”
Get full text
Article