-
21
Feedback controller and observer design to maximize stability radius
Published 2006Get full text
Proceeding Paper -
22
Tooth wear and erosive tooth wear among 16-year-old Malaysian adolescents
Published 2013Get full text
Article -
23
Tolerance towards sensor failures: an application to a double inverted pendulum
Published 2006Get full text
Proceeding Paper -
24
Roll and yaw stabilisation using nonlinear energy method
Published 2007Get full text
Proceeding Paper -
25
Automatic aircraft landing control using nonlinear energy method
Published 2010Get full text
Get full text
Proceeding Paper -
26
Disturbance decoupled fault reconstruction using sliding mode observers
Published 2010Get full text
Article -
27
-
28
Disturbance decoupled fault reconstruction using sliding mode observers
Published 2008Get full text
Proceeding Paper -
29
Preliminary design of sliding mode controller for angular positional tracking of an aircraft
Published 2009Get full text
Proceeding Paper -
30
-
31
-
32
-
33
Development of green transportation system
Published 2013“…The high acceleration periods of the green transport (EV) needs powerful electrical currents, causes temperature spike of the cells of LiFePO4. The cell temperature spike is due to internal resistance and electrochemical reaction which causes the battery performance decline. …”
Get full text
Proceeding Paper -
34
Antivirals for broader coverage against human coronaviruses
Published 2024“…Spike is also not applicable for targeting other HCoVs as these are not well-conserved sequences among human CoVs. …”
Get full text
Article -
35
Bio-fuel-contaminated lubricant and hardening effects on the friction and wear of AISI 1045 steel
Published 1998“…A study has been made on the wear and fiction of hardened AISI 1045 steel using a pi-pin-ondisc type of fiction and wear apparatus. During the investigation the linear pin wear, coe@cient of friction and rise in pin specimen temperature were monitored and wear and fiction curues 'plotted. …”
Get full text
Article -
36
Novel opto-electronic and plastic fibre sensors
Published 1998“…The middle POF is coupled to a red LED and emits light onto a flat target with the two outer fibres receiving the reflected light from the target and guiding it to two silicon PIN photodiodes. Theoretical investigations on the behaviour of the sensor are presented for ranges between 0 mm and 100 mm, and for targets with different reflectivities. …”
Get full text
Thesis -
37
-
38
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
39
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
40
Enrichment of fruit wastes with white rot fungi under submerged state bioconversion
Published 2013“…On Banana and Pineapple (BPin) the protein content were recorded as18.05 and 15.75 mg/g, which was higher than Papaya and Pineapple (PinPw) and Banana and Papaya (BPw)composite. M6 has 15.4 and 9.78 mg/g on BPinPw, 13.84 and 13.59 mg/g on BPw, 20.82, and 22.97 mg/g on BPin and 18.29 and 11.59 mg/g on PinPw. …”
Get full text
Proceeding Paper