-
1081
Effect of high velocity oxy-fuel (HVOF) coatings on fatigue behaviour of carbon steel
Published 2021“…Tensile test was carried out with a strain rate of 0.5 mm/min and a dog bone shaped specimen in accordance with ASTM-E8 standard. …”
Get full text
Get full text
Get full text
Thesis -
1082
-
1083
-
1084
Microwave absorber based on biocomposites derived from agricultural wastes with reinforcement of poly lactic acid
Published 2021“…Due to fabrication error, the MA thickness is different form the simulation although their plots show same trends except for the shifted resonant frequency. A fine-tune simulation shows that the fabricated MA consider to have ’ = 2.46 and tan = 0.12 and frequency at 8.17 GHz where the corresponding AR is 32%, FBW is 26.8% and FOM is 3.2% per unit mm which is close to the fabricated results. …”
Get full text
Thesis -
1085
Influence of workpiece preheating on chatter and machinability of Titanium alloy - Ti6Al4V
Published 2011“…The cutting speed was varied in the range from 40 to 160 m/min; with varying depths of cut and feed rates. …”
Get full text
Book Chapter -
1086
Oil uptake and deep-frying performance of virgin coconut oil and palm solid shortening blends
Published 2012“…The fresh chickens were fried in a blended frying medium using an open fryer for 8 hours per day intermittently at 30 min interval for five consecutive days. Three types of oils were used; i.e. …”
Get full text
Article -
1087
Fracture strength and fractographic analysis of zirconia copings treated with four experimental silane primers
Published 2013“…Zirconia copings were vertically loaded on the cusp area until the first crack failure was occurred using Precision Universal Tester at a constant crosshead speed of 1 mm/min. Then, the machine was manually controlled to cause more failure to further determine the texture of fracture. …”
Get full text
Get full text
Article -
1088
Study of the effects of process parameters on electroforced sedimentation in solid–liquid separation using response surface methodology
Published 2016“…The optimized values for current density, total solid volume per unit cross-sectional area and polyacrylamide dose for the highest sedimentation velocity (0.0199 cm/min) were 6.0 A/m2 , 7.74 mm and 1.53 % (based on the weight of zinc oxide), respectively. …”
Get full text
Get full text
Get full text
Article -
1089
Adsorption of Zn from aqueous solution by activated carbon derived empty fruit bunches: Statistical approach
Published 2009“…Thermal activation temperature (10000C) and time (30 min) were optimized to produce activated carbon from EFB. …”
Get full text
Proceeding Paper -
1090
Ultrasound-assisted process optimization and tribological characteristics of biodiesel from palm-sesame oil via response surface methodology and extreme learning machine - Cuckoo s...
Published 2020“…The optimum yield of P50S50 biodiesel obtained was 96.6138% under operating parameters of time (38.96 min), duty cycle (59.52%), methanol to oil ratio (60 V/V %) and catalyst amount (0.70 wt%). …”
Get full text
Get full text
Article -
1091
-
1092
-
1093
-
1094
-
1095
-
1096
-
1097
-
1098
-
1099
-
1100