-
121
-
122
A study of microwave induced plasmas
Published 1987“…Two 'analytical' MIP's incorporating sample aerosol introduction have been used with the slab-line cavity. One being supported on an argon flowrate of 0.1 1 min-1 using a Babing!…”
Get full text
Thesis -
123
-
124
-
125
In vitro growth of human keratinocytes and oral cancer cells into microtissues: an aerosol-based microencapsulation technique
Published 2017“…In this paper, we proposed a growth of microtissue model for the human keratinocytes (HaCaT) cell line and an oral squamous cell carcinoma (OSCC) cell line (ORL-48) based on a simple aerosol microencapsulation technique. …”
Get full text
Article -
126
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
127
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
128
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
129
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis -
130
Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing
Published 2023“…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
Get full text
Article -
131
Biomechanical evaluation and new improvement on ankle external fixator
Published 2023Get full text
Thesis -
132
-
133
Low-loss paper-substrate triple-band-frequency reconfigurable microstrip antenna for sub-7 GHz applications
Published 2023“…In this paper, a low-cost resin-coated commercial-photo-paper substrate is used to design a printed reconfigurable multiband antenna. The two PIN diodes are used mainly to redistribute the surface current that provides reconfigurable properties to the proposed antenna. …”
Get full text
Get full text
Article -
134
Linerboard made from Soda-Anthraquinone (Soda-AQ) treated coconut coir fiber and effect of pulp beating
Published 2015“…Based on chemical analysis, the composition of coir fiber is suitable for the pulping process. Out of nine pulping conditions characterized, a pulping condition of 18% active alkali for 90 min cooking time was chosen. …”
Get full text
Article -
135
Optimization of double boiling condition for kelulut honey processing using response surface methodology
Published 2018“…Three-level factorial design employed nine runs with duplicates under different combination of temperature (30 – 60 °C) and time (10 – 60 min) was developed. …”
Get full text
Article -
136
Office space
Published 2015“…As offices become mobile, and the nine-to-five becomes a nonstop 24-hour cycle, this exhibition reflects on what the Italian theorist Maurizio Lazzarato has identified as the rise of “immaterial labor” in developed, post-industrial countries. …”
Get full text
Show/Exhibition -
137
Sustainability-oriented application of value stream mapping: a review and classification
Published 2021“…Hence, this paper has been aimed at presenting the �ndings of a systematic literature review on value stream mapping from the triple bottom line point of view. It classi�es and codes the main studies in the context as well as provides a research agenda with nine recommendations that may advance this under-studied �eld. …”
Get full text
Article -
138
Sustainability-oriented application of value stream mapping: a review and classification
Published 2021“…Hence, this paper has been aimed at presenting the findings of a systematic literature review on value stream mapping from the triple bottom line point of view. It classifies and codes the main studies in the context as well as provides a research agenda with nine recommendations that may advance this under-studied field. …”
Get full text
Article -
139
Physical model design of rainwater harvesting system at Uthm Pagoh, Johor
Published 2018“…Malaysia is a country located on the equator line which is a humid and hot climate throughout the year. …”
Get full text
Book Section -
140
Measurement and modelling of operational amplifier power supply rejection
Published 1995“…Measured results for 741 and pin-compatible operational amplifiers are tabulated. …”
Get full text
Article