-
241
A New Design and Simulation of Smart Sensing for Emergency Vehicle
Published 2024“…The sensor can detect the sound of emergency vehicles and respond immediately to them by signalling smaller parallel visitors to change the screen from pink to green or vice versa. Therefore, this flow reduces the travel time required for emergencies.…”
Get full text
Article -
242
A New Design and Simulation of Smart Sensing for Emergency Vehicle
Published 2024“…The sensor can detect the sound of emergency vehicles and respond immediately to them by signalling smaller parallel visitors to change the screen from pink to green or vice versa. Therefore, this flow reduces the travel time required for emergencies.…”
Get full text
Article -
243
Wear characteristics of Fe-C-Si and Fe-C-Al cast irons
Published 2011“…Alumina ball of 3 mm diameter was used as pin, while the cast sample served as the disk. The tests were carried out at a normal load of 5.0 N and a sliding velocity of 250 mm/s for 30 min. …”
Get full text
Article -
244
Prediction of surface roughness of Ti-6Al-4V in electrical discharge machining: A regression model
Published 2011“…It can be seen that increasing pulse on time causes the fine surface until a certain value and afterward deteriorates in the surface finish. …”
Get full text
Article -
245
-
246
Wear study of Mg-SiCp reinforcement aluminium metal matrix composite
Published 2016“…The pin-on-disc test was also done at room temperature in a dry sliding wear condition. …”
Get full text
Get full text
Article -
247
Influence of single and multiple particle size variation on mechanical and wear behaviour of aluminium silicon carbide composites
Published 2015“…Standard impact and hardness test was conducted to ascertain the energy absorbed before fracture failure and resistance to plastic deformation of the composite. Pin-on-disc test was also investigated at room temperature under dry sliding wear condition. …”
Get full text
Proceeding Paper -
248
Isolation and characterisation of thermophilic bacterial isolates producing L-asparaginase
Published 2016“…Phenol red at acidic is yellow which might change colour to pink when it is at alkaline. Thus, it indicates the formation of pink zone around microbial colonies producing L-asparaginase. …”
Get full text
Book Chapter -
249
Minutes of meeting. 2 February 1981
Published 1981“…Typewritten on a sheet of pink paper.…”
Get full text
Minutes -
250
Tuning of fuzzy logic controllers by parameter estimation method
Published 1993“…Fuzzy logic controllers (FLC) require fine tuning to match the rules to the membership functions or vice-versa. …”
Get full text
Get full text
Get full text
Get full text
Book Chapter -
251
Aluminium metal matrix composite: improving wear performance through treatment
Published 2011“…The wear test was carried out using a pin-on- disc type tribo-test machine under dry sliding condition. …”
Get full text
Article -
252
Tribological behavior of dual and triple particle size SiC reinforced Al0MMCs: a comparative study
Published 2008“…The wear test was carried out using a pin-on-disc type tribo-test machine under dry sliding condition. …”
Get full text
Article -
253
Robotic arm system with computer vision for colour object Sorting
Published 2018“…This study presents the development of robotic arm with computer vision functionalities to recognise the objects with different colours, pick up the nearest target object and place it into particular location. …”
Get full text
Article -
254
Effect of heating rates on the microstructure and gas permeation properties of carbon membranes
Published 2018“…High performance tubular carbon membrane (TCM’s) for CO2 separation were prepared by controlling the carbonization heating rates in range of 1-7 oC/min carbonized at 800 oC under Argon environment. …”
Get full text
Article -
255
Design of intelligent multifinger gripper for a robotic arm using a DSP-based fuzzy controller
Published 2000“…Then, to ensure that an appropriate force is used in picking up an object a fuzzy logic controller is used. …”
Get full text
Proceeding Paper -
256
Capabilities of cermets tools for high speed machining of austenitic stainless steel
Published 2006“…In the present work cermet tools coated with titanium nitride were used to turn austenitic stainless steel at speeds between 300 and 700 m min-1. Feed rates were varied between 0.05 to 0.4 mm rev-1. …”
Get full text
Article -
257
Bio-fuel-contaminated lubricant and hardening effects on the friction and wear of AISI 1045 steel
Published 1998“…A study has been made on the wear and fiction of hardened AISI 1045 steel using a pi-pin-ondisc type of fiction and wear apparatus. During the investigation the linear pin wear, coe@cient of friction and rise in pin specimen temperature were monitored and wear and fiction curues 'plotted. …”
Get full text
Article -
258
Wear behavior of as-cast and heat treated triple particle size SiC reinforced aluminium metal matrix composites
Published 2009“…The wear test was carried out using a pin-on-disc type tribo-test machine under dry sliding condition. …”
Get full text
Article -
259
A review on safety practices at construction site
Published 2012“…Based on the review, there are ten safety practices found, i.e, safety policy, education and training, safety inspection and safety auditing, safety meeting, supervision, pink tickets, red and green zone demarcation, personal protective equipment (PPE), emergency support and safety measuring device and fall protection systems.…”
Get full text
Proceeding Paper -
260
Why Islamic legal system needs a shift
Published 2011“…Although there had been much change, public criticisms still abound, and removing negative perceptions of the Islamic legal system requires consistent and concerted effort. IF a pink elephant is in a room with us, can we pretend it does not exist or be oblivious to it? …”
Get full text
Article