-
1261
An investigation on the performance of a single cylinder diesel engine using biodiesel
Published 2016“…The combustion parameters analysed are cylinder pressure, net heat release, rate of pressure rise, mass fraction burnt, mean gas temperature, cylinder pressure-volume (PV) plot, cumulative heat release rate and injection pressure. …”
Get full text
Proceeding Paper -
1262
Body composition, lung function, blood pressure, and muscular strength: a comparative study
Published 2019“…Background: The loss of balance between components of body composition is significantly linked to a wide range of adverse clinical outcomes. Whilst the sharp rise in the rate of adiposity-based chronic diseases has caused substantial health concerns across the globe, sarcopenia has emerged as an important risk factor for increased morbidity and mortality among the aging population. …”
Get full text
Thesis -
1263
Tool wear and surface roughness aspects in heat assisted end milling of AISI D2 hardened steel
Published 2011“…He added that preheated machining has been able to reduce the amplitude of the lower frequency mode of chatter by almost 4.5 times at the cutting speed of 50 m/min. The primary causes of this stable cutting need to be studied in the perspective of material properties and damping capability of the material in the preheated condition. …”
Get full text
Book Chapter -
1264
Modeling in preheated machining of AISI D2 hardened steel
Published 2011“…They added that preheated machining was able to reduce the amplitude of the lower frequency mode of chatter by almost 4.5 times at the cutting speed of 50 m/min. It was also established by several earlier studies [4-7] that preheating had great potential in lowering chatter. …”
Get full text
Book Chapter -
1265
-
1266
-
1267
-
1268
-
1269
-
1270
-
1271
-
1272
The effect of temperature on permittivity measurements of aqueous solutions of glucose for the development of non-invasive glucose sensors based on electromagnetic waves
Published 2023“…Empirical results however show that for aqueous solution of glucose the permittivity increases with rise in temperature from 16◦C to 37◦C. This is attributed to the polar nature of the water and glucose molecules that becomes more pronounced with increased thermal energy. …”
Get full text
Article -
1273
Critical control points and critical limits for industrial scale Halal poultry meat production
Published 2014“…In CCP4 also, the recommended minimum time between neck cutting and scalding is 9 min. For CCP5 (scalding), counter-current water flow system must be used for scalding and the CL for the temperature is 50 to 60C. …”
Get full text
Proceeding Paper -
1274
-
1275
-
1276
-
1277
-
1278
-
1279
Experimental and theoretical DFT study of hydrothermally synthesized MoS2-doped-TiO2 nanocomposites for photocatalytic application
Published 2024“…The breakdown of methylene blue within 15 min confirmed that the prepared MoS2(1-x)TiO2x nanocomposite was a stable, and cost-effective material for photocatalytic application.…”
Get full text
Article -
1280
Kajian keperluan kecerdasan emosi guru pelatih program ijazah sarjana muda perguruan di Institut Pendidikan Guru Malaysia
Published 2019“…Penyelidik menggunakan perisian SPSS version 19 untuk analisis statistik deskriptif iaitu min dan sisihan piawai. Statistik inferensi regresi pelbagai digunakan untuk mendapatkan hubungan di antara pemboleh ubah-pemboleh ubah. …”
Get full text
Get full text
Get full text
Thesis