Development and validation of analytical method by RP-HPLC for quantification of Alpha-Mangostin Encapsulated in PLGA microspheres by Elsaid Ali, Aimen Abdo, Muhammad, Taher, Helal Uddin, A.B.M., Mohamed, Farahidah

“…Method was developed using a silica-based deactivated C-18 column (4.6×100 mm, 3 μm) with a mobile phase of 70-80 % v/v acetonitrile (A) and 0.1% v/v orthophosphoric acid (B), with the following pre-determined timed-gradient program: 70% (A) isocratic for 6 min, 70-75% (A) in 1.2 min, 75-80% (A) in 0.4 min, 80% (A) isocratic for 2.4 min, 80-70% (A) in 0.4 min, finally 70% (A)isocratic for 5 min, with a flow rate of 1 mL/min, detected at 320 nm by a UV detector. …”
Get full text

Sonochemistry approach for a new process of biodiesel production from Jatropha Curcas Oil by Praptijanto, Achmad

“…Meanwhile the optimum condition of the purification process was at water concentration of 10 % (v/v), power output of 240 W, time of reaction of 5 minutes. …”
Get full text
Get full text
Get full text

Synthesis and characterization of natural sensitizers for dye sensitized solar cells by Kimpa, Mohammed Isah, Uthman Isah, Kasim, Yabagi, Jibrin Alhaji, Taufiq, Sulaiman, Agam, Mohd Arif

“…The photo electrochemical performances of DSSCs obtained from I.V characteristics showed conversion efficiency, (ɳ) of 0.80 % for the dye extracts from flame tree flower (anthocyanine), with open-circuit voltage (VOC) of 0.5249 mV, short-circuit current density (Isc) of 44.6191 mA/m2 and Fill factor (FF) of 0.5837. …”
Get full text

Use of porous alumina bioceramic to increase implant osseointegration to surrounding bone by Al-Khateeb, Khalid A. Saeed, Mustafa, Ammar A., Ismail, Ahmad Faris, Sutjipto, Agus Geter Edy

“…The results showed a promising material to use as coating for implants as X-ray diffraction exhibited an amorphous phase diagram for the material structure whereas SEM results revealed that the pores in the specimens prepared by anodization method were highly ordered and the mean average pore size was 6.5-8.5 nm. The compressive strength test showed that the test-porous glass ceramic coating has a mean numerical value of up to 7.5 MPa which indicates an ambitious result for the new material.…”
Get full text

Development of kenaf-glass reinforced unsaturated polyester hybrid composite for structural applications by Afdzaluddin, Atiqah, Maleque, Md. Abdul, Jawaid, Mohammad, Iqbal, Mohammad

“…The highest flexural, tensile and impact strength were obtained from treated kenaf with 15/15 v/v KG fibres reinforced UPE hybrid composite in this investigation. …”
Get full text
Get full text

Investigation of a new porous glass ceramic for potential bone implant by Al-Khateeb, Khalid A. Saeed, Mustafa, Ammar A., Ismail, Ahmad Faris, Sutjipto, Agus Geter Edy

“…The results showed a promising material to use as coating for implants as X-ray diffraction exhibited an amorphous phase diagram for the material structure whereas SEM results revealed that the pores in the specimens prepared by anodization method were highly ordered and the mean average pore size was 6.5-8.5 nm. The compressive strength test showed that the test-porous glass ceramic coating has a mean numerical value of up to 7.5 MPa which indicates an ambitious result for the new material.…”
Get full text

Dynamic modelling of flexible link aerator with embedded holes to generate dissolved oxygen in tiger prawn pond by Zulkipli, Nazatul Erma

“…The simulation is done using Matlab SIMULINK and three voltages are chosen to be the input voltage which are 6V, 9V and 12V while the percentage of immerse level were set at 100%, 75%, 50% and 25%. …”
Get full text
Get full text

Application of fuzzy logic approach for an aircraft model with and without winglet by Hossain, Altab, Rahman, Mohammed Ataur, Hossen, Jakir, Iqbal, A.K.M. Asif

“…Secondly, Tests are conducted on the aircraft model with and without winglet of two configurations at Reynolds numbers 1.7×10 5 , 2.1×10 5 , and 2.5×10 5 for different angle of attacks. …”
Get full text

Streptomyces sp. UKMCC_PT15: Potential anticancer agent producer by Zainal Abidin, Zaima Azira, Usup, Gires, Ahmad, Asmat, Lu, Chung-Kuang

“…Fraction 2 (ZAI1-23-2) was selected for further separation using HPLC using a photodiode array detector in the wavelength range 200-800nm on a C18, 5um column. A mobile phase comprising methanol:0.1% acetic acid (95:5) with a flowrate of 1ml/min was the best condition to separate ZAI1-23-2 to 5 fractions (ZAI1-29-1 – ZAI1-29-5). …”
Get full text

The impact of intrapartum pethidine on the neonatal outcome. a prospective review by Husin, Roziah, Abdulwahab, Dalia F, Busu Rerah, Ruqaiah, Ismail, Rozihan, Awang, Mokhtar

“…All neonates delivered with good Apgar Score, 8 at 1 min and 9 at 5 min. A total of nine (22.5%) cases were admitted to the Neonatal Intensive Care Unit (NICU). …”
Get full text

The impact of intrapartum pethidine on the neonatal outcome: a perspective review by Husin, Roziah, Abdulwahab, Dalia F, BR, Rukaiah, Ismail, Rozihan

“…All neonates delivered with good Apgar Score, 8 at 1 minute and 9 at 5 minute. A total of 9 (22.5%) cases were admitted to the Neonatal Intensive Care Unit (NICU). …”
Get full text
Get full text

Studies on flow from converging nozzle and the effect of nozzle pressure ratio for area ratio of 6.25 by Ashfaq, Syed, Khan, Sher Afghan

“…The flow parameter, nozzle pressure ratio (NPR) used were from 1.5 to 3, in steps of 0.5 and experiments were conducted for NPR 1.5, 2.0, 2.5 and 3.0. …”
Get full text

A model binary system for the evaluation of novel ion pair formulations of diclofenac by Cristofoli, Mignon, Hadgraft, Jonathan, Lane, Majella E., Sil dos Santos, Bruno

“…However, increasing the DNa concentration to 10 mg/mL, without adding LHSS, resulted in a significant reduction in the amount of DF that partitioned and permeated, relative to formulations that contained either 5 mg/mL DNa in combination with LHSS (at 12.5 or 25 mg/mL), or 7.5 mg/mL DNa together with 12.5 mg/mL LHSS. …”
Get full text
Get full text

Comparison fine spray nozzle for two phase flow within experimental and simulation by Ali, Hafiz Aizat

“…Six pressure inlet different are used during the experiment. They are 0.5, 1.0, 1.5, 2.0, 2.5 and 3.0 bar. They are three type of nozzles been tested Nozzle A, Nozzle B and Nozzle C. …”
Get full text
Get full text

TiO2/solid state polymer junction for photovoltaic application by Alaei, Iraj, Mohamad, Souad A.

“…The open circuit voltage Voc, short circuit current density Jsc, and fill factor FF% obtained from the photovoltaic system under white light illumination of 100W Tungsten lamp are 320-350 mV, 0.59-2.5μAcm-2 and 42%- 59% respectively.…”
Get full text

TiO2 /solid state polymer junction for photovoltaic application by Al-Bat’hi, Souad A. M., Alaei, Iraj

“…The open circuit voltage Voc, short circuit current density Jsc, and fill factor FF% obtained from the photovoltaic system under white light illumination of 100W Tungsten lamp are 320-350 mV, 0.59-2.5μAcm-2 and 42%-59% respectively.…”
Get full text
Get full text
Get full text

Work, family and women's well-being : the influence of culture by Noor, Noraini M., Mohd Mahudin, Nor Diana

“…This chapter examines work and family roles in relation to women 5 wellbeing. However, the emphasis is on the influence ofculture on how work and family roles are perceived and practiced, and the resulting implications for women 5 well-being. …”
Get full text

Parametric analysis for designing low voltage and low frequency energy harvester booster by Che Mustapha, Nurul Arfah, Alam, A. H. M. Zahirul, Khan, Sheroz, Azman, Amelia Wong

“…A switching gate controlled concept is used which is well suited for low vibration-based frequency and voltage applications. The 0.1 – 0.5 V input voltage range is linearly increased with the increase of output voltage range, 4 – 22 V. …”
Get full text

Optimum process conditions for effective bioconversion of sewage treatment plant sludge by pure bacterial culture by Alam, Md. Zahangir, Muyibi, Suleyman Aremu, Jamal, Parveen, Khan Chowdhury, Ahmed Jalal

“…The results with the surface response analysis indicated the optimum values of parameters: temperature, 400C; agitation, 50 rpm; pH, 6; inoculum, 5% (v/v).…”
Get full text

Effect of adsorbate initial concentration on the removal of Pb from aqueous solutions by carbon nanofibers by Ahmed, Yehya M., Al-Mamun, Abdullah, Muyibi, Suleyman Aremu, Al-Khatib, Ma'an Fahmi Rashid, Jameel, Ahmed Tariq, Al-Saadi, Mohammed A.

“…The effects of initial lead ions concentration were examined and the results showed that the residual concentration of the heavy metal after adsorption by the carbon nanofibers was increased from 0.5 to about 37 with increasing the initial lead concentration from 5 to 70 mg/L. …”
Get full text