Smart energy management system for microgrid planning and operation by Chen, Shuaixun

“…The Unit Commitment problem with the required spinning reserve capacity for the MG is considered in this method. …”
Get full text

Maghemite filled poly-vinyl alcohol nanofibres for tissue engineering scaffold. by Ngadiman, Nor Hasrul Akhmal

Get full text

GWTC-2.1: Deep extended catalog of compact binary coalescences observed by LIGO and Virgo during the first half of the third observing run

“…We also expand the population of binaries with significantly asymmetric mass ratios reported in GWTC-2 by an additional two events (the mass ratio is less than 0.65 and 0.44 at 90% probability for GW190403_051519 and GW190917_114630 respectively), and find that two of the eight new events have effective inspiral spins χ eff > 0 (at 90% credibility), while no binary is consistent with χ eff < 0 at the same significance. …”
Get full text

Laser-based 3D printing using bessel beams for tissue engineering applications by Liew, Andy Wen Loong

“…High resolution fibers down to 25 μm were printable using the BB technique, a significant improvement compared to conventional microfluidics and wet spinning techniques, and the capability to tune the fabricated fiber diameter based on mathematical models was also demonstrated. …”
Get full text

Energy management of microgrids by Ju, Chengquan

“…Large-scale energy storage systems have provided promising potentials for multiple applications in microgrids by providing additional spinning reserve, regulating voltage, frequency and power factors, as well as offering economic benefits by participating into demand response and facilitating the integration of renewable energy sources (RESs). …”
Get full text

Effects of heat treatment parameters on the microstructure and mechanical properties of laser power bed fusion (LPBF) 316L stainless steel by Sun, Yuheng

“…No obvious recrystallization was observed when the annealing temperature is below 1300 °C; annealing at 1200 °C for 30 minutes to 2 hours only led to partially recrystallization; full recrystallization was obtained at 1300 °C for more than 30 mins, where similar microstructure and mechanical properties were obtained to CM 316L. …”
Get full text

Process-structure-property optimisation of basalt fibre reinforced thermoplastic composites by Hoo, Ming Shun

“…The results showed that the optimal MFI at 11.60 g/10mins at 260oC. The mechanical properties recorded showed ultimate tensile strength (UTS) of 708 ± 26 MPa, flexural strength of 1012 ± 43 MPa and elastic modulus of 33.1 ± 1.8GPa. …”
Get full text