Showing 81 - 100 results of 301 for search '(((pinn OR spingna) OR ((sping OR ssspingg) OR ching)) OR (((span OR shingo) OR sshenga) OR pin))', query time: 0.07s Refine Results
  1. 81

    Bio-fuel-contaminated lubricant and hardening effects on the friction and wear of AISI 1045 steel by Maleque, Md. Abdul, Masjuki, H.H., Ishak, M.

    Published 1998
    “…A study has been made on the wear and fiction of hardened AISI 1045 steel using a pi-pin-ondisc type of fiction and wear apparatus. During the investigation the linear pin wear, coe@cient of friction and rise in pin specimen temperature were monitored and wear and fiction curues 'plotted. …”
    Get full text
    Article
  2. 82

    Shear strength analysis of concrete beams reinforced with GFRP bars using strut and tie model by Mokhtar, Norfaniza

    Published 2011
    “…The experimental approved that the spacing between shear cracks for the specimens with larger shear span to depth ratio is greater than the smaller shear span to depth ratio and while the shear span to depth ratio (a/d) decreases, the shear strength increase. …”
    Get full text
    Get full text
    Get full text
    Thesis
  3. 83

    Development of switchable planar reflectors for beam shaping realization by Abbasi, Muhammad Inam

    Published 2016
    “…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
    Get full text
    Get full text
    Get full text
    Thesis
  4. 84

    Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test by Mohd Harun, Dalila

    Published 2020
    “…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
    Get full text
    Get full text
    Get full text
    Thesis
  5. 85

    Enrichment of fruit wastes with white rot fungi under submerged state bioconversion by Jamal, Parveen, Saheed, Olorunnisola Kola, Alam, Md. Zahangir, Muyibi, Suleyman Aremu, Abdul Karim, Mohamed Ismail

    Published 2013
    “…On Banana and Pineapple (BPin) the protein content were recorded as18.05 and 15.75 mg/g, which was higher than Papaya and Pineapple (PinPw) and Banana and Papaya (BPw)composite. M6 has 15.4 and 9.78 mg/g on BPinPw, 13.84 and 13.59 mg/g on BPw, 20.82, and 22.97 mg/g on BPin and 18.29 and 11.59 mg/g on PinPw. …”
    Get full text
    Proceeding Paper
  6. 86

    Electrical breakdown and structural characterization in synthetic resins using optical techniques by Dodd, Stephen John

    Published 1992
    “…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
    Get full text
    Thesis
  7. 87

    Development of remote operability CNC milling by ., Afzeri, Muhida, Riza, ., Darmawan

    Published 2010
    “…Attachment consists of three main equipments; material indexing device, Sub clamp with pin and vise index…”
    Get full text
    Proceeding Paper
  8. 88

    The system architecture of E-braille by using the microcontroller and external controller unit by Burhan, Muhammad Mansor, Toha, Siti Fauziah

    Published 2016
    “…This refreshable braille cell can refresh the character. The pin for each braille cell is controlled by using piezoelectric bimorph. …”
    Get full text
    Get full text
    Article
  9. 89

    Impact of a reverse delta type add-on device on the flap-tip vortex of a wing by Altaf, Afaq, Tan, Boon Thong, Omar, Ashraf Ali, Asrar, Waqar

    Published 2016
    “…The effect of interactions of vortices produced by an outboard flap-tip of a half-span wing (NACA 23012 in landing configuration) and a slender reverse delta type add-on device, placed in the proximity of the outboard flap-tip, on the upper surface of the half-span wing is investigated using Particle Image Velocimetry in a closed loop low speed wind tunnel. …”
    Get full text
    Get full text
    Article
  10. 90

    Influential factors and structural reliability by Eusuf, Muhammad Abu, Al Hasan, Abdullah

    Published 2013
    “…This study focuses on the influential factors that enhance the reliability and versatility of structure throughout the life span. The factors are considered on the basis of the need for assessment of state of –art- structural analysis and design. …”
    Get full text
    Article
  11. 91

    Evaluation of classifiers in a pressure and latency-based typing biometric system by Moez Khan, Imran, ., Imama, Ushama, K. M., Aibinu, Abiodun Musa, Lai, Weng Kin

    Published 2011
    “…System authentication in present time relies on validation by some sort of a password or Personal Identification Number (PIN). However, if an intruder discovers this password or PIN, the user’s account can be easily compromised. …”
    Get full text
    Proceeding Paper
  12. 92

    An investigation of defect formation and growth in epoxy resin using light scattering methods by Perkins, Elaine Ann

    Published 1989
    “…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
    Get full text
    Thesis
  13. 93

    Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing by ISA, SITI RAHENA, JUSOH, MUZAMMIL, THENNARASAN SABAPATHY, THENNARASAN SABAPATHY, KAMARUDIN, MUHAMMAD RAMLEE, OSMAN, MOHAMED NASRUN, AKRAM ALOMAINY, AKRAM ALOMAINY

    Published 2023
    “…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
    Get full text
    Article
  14. 94

    Analytical Finite Element Formulation of Non-uniform Euler-Bernoulli Beam by Sulaeman, Erwin, Kapania, Rakesh

    Published 2011
    “…To satisfy some requirements, it is not uncommon that the beam has to posses a non-uniform distribution of its cross section along the span. A common approach to analyze such a structure is by using a variational principle to develop the element stiffness matrix. …”
    Get full text
    Proceeding Paper
  15. 95

    Methodology to develop bottleneck-based heuristic for permutation flow shop scheduling by Isa, Noor Amira, Ahmad Bareduan, Salleh

    Published 2020
    “…To date, the Nawaz-Enscore-Ham (NEH) algorithm is still recognized as the best heuristic in solving make span problem in scheduling environment. A very detail step by step methodology to develop the BNB heuristic was thoroughly discussed and elaborated in this paper. …”
    Get full text
    Book Section
  16. 96

    Wear characteristics of Fe-C-Si and Fe-C-Al cast irons by Shaha, Sugrib Kumar, Haque, Md. Mohafizul, Khan, Ahsan Ali

    Published 2011
    “…In the present study, wear behavior of the Fe-C-Si and Fe-C-Al cast irons were investigated using a pin-on-disk type apparatus at room temperature. …”
    Get full text
    Article
  17. 97
  18. 98
  19. 99
  20. 100

    The tribological behaviour of Fe-C-Al cast iron – effect of temperature by Maleque, Md. Abdul, Sugrib , S.

    Published 2013
    “…The wear and friction tests were conducted using universal pin-on-disk machine at 25 0C, 100 0C, 200 0C and 300 0C temperature. …”
    Get full text
    Article