-
321
Integrating lessons from the Qur’an and Hadith in teaching Molecular biology
Published 2011“…However, it is necessary to caution that taking teachings from Islamic guidelines and integrating them to the context of scientific evidence or vice versa poses inherent threats of inconsistency and inaccuracy. …”
Get full text
Article -
322
Flood and riverbank erosion displaces of two different flood areas of Bangladesh: a situational study on their indigenous survival strategies
Published 2011“…But due to some mishappenings, the whole lots of data were lost from the Vice Chancellor’s Office of Comilla University; and these were never found again. …”
Get full text
Monograph -
323
Influence of work material, cutting conditions and rigidity of tool holders on machine tool chatter
Published 1992“…It has been also found that the amplitude of chatter and the range of cutting speed corresponding to the horizontal segments of the frequency characteristic curve decrease and these segments are shifted towards higher cutting speeds with an increase in the stiffness of the tool holder and vice versa. The lengths of the horizontal segments of the frequency characteristic curve decrease but their number increase with an increase in the "stiffness" of the instability of the chip formation process and brittleness of job materials. …”
Get full text
Proceeding Paper -
324
Investigating organizational communication between top management and academic staff in Malaysian Technical University Network (MTUN)
Published 2020“…Organizations are there because of their employees and vice versa employees are there because of their organizations. …”
Get full text
Get full text
Get full text
Thesis -
325
A New Design and Simulation of Smart Sensing for Emergency Vehicle
Published 2024“…The sensor can detect the sound of emergency vehicles and respond immediately to them by signalling smaller parallel visitors to change the screen from pink to green or vice versa. Therefore, this flow reduces the travel time required for emergencies.…”
Get full text
Article -
326
Flood occurrence, smart tunnel operating system and traffic flow: A case of Kuala Lumpur smart tunnel Malaysia
Published 2016“…When there is enough maintenance works, flood occurrence will be very low and vice versa. The research shows that SMART Tunnel plays an important role in decongestion of traffic to and from the Kuala Lumpur City Centre. …”
Get full text
Get full text
Get full text
Thesis -
327
Biosorption of Pb and Cu from aqueous solution using banana peel powder
Published 2016“…The effects of concentration and contact time on peel extract, the maximum adsorption for Pb has shown at 4 mg/L at 120 min for BPPU and was 6 mg/L at 150 min for BPPT. …”
Get full text
Get full text
Article -
328
-
329
Kualiti pengalaman pembelajaran pelajar-pelajar kejuruteraan di KUiTTHO dari aspek kognitif dan afektif
Published 2004“…Dapatan kajian menunjukkan kualiti keseluruhan pengalaman pembelajaran pelajar-pelajar kejuruteraan di KUiTTHO adalah pada tahap sederhana (skor min = 3.55). Bagi kualiti pengalaman pembelajaran dari aspek kognitif dan afektif adalah pada tahap sederhana (skor min = 3.48 dan 3.61 masing-masing). …”
Get full text
Get full text
Get full text
Thesis -
330
Silicon carbide powder mixed micro electro discharge milling of titanium alloy
Published 2011“…A multi criteria optimization on low Ra, high MRR and low EWR has been achieved which showed 2.68 µm Ra., 6.908 µg/min MRR and 1.518 µg/min EWRfor the input parameters of 15.42 g/l SiC powder concentration and 54.28 µJ discharge energy. …”
Get full text
Article -
331
Optimization of the conditions for extraction of serine protease from Kesinai plant (Streblus asper) leaves using Response Surface Methodology
Published 2011“…The most desirable conditions of 2.5 °C temperature, 4 min mixing time, 40 mL buffer at pH 7.5 was established for serine protease extraction from kesinai leaves.…”
Get full text
Article -
332
Investigation of vibration and surface roughness in micro milling of PMMA
Published 2012“…The optimum solution for minimum average vibration is 64.3 Hz with spindle speed 3000 rpm, feed rate 2 mm/min, and depth of cut 1.5 μm. However, the optimum solution for minimum average surface roughness, Ra is 0.352 μm with spindle speed 2000 rpm, feed rate 2 mm/min, and depth of cut 1.5 μm. …”
Get full text
Article -
333
Acid blue 25 adsorption on base treated Shorea dasyphylla sawdust: kinetic, isotherm, thermodynamic and spectroscopic analysis
Published 2012“…The optimum conditions for AB 25 adsorption were pH 2, stirring rate 500 r/min, adsorbent dosage 0.10 g and contact time 60 min. …”
Get full text
Article -
334
Treatment of biotreated palm oil mill effluent using powdered activated carbon produced from palm empty fruit bunch
Published 2013“…Powdered Activated Carbon (PAC) was produced from empty fruit bunch (EFB) precursors by CO2 activation at 800¬0C, N2 (2.5 L/min) for 30 mins and CO2 (0.1L/min) for 15 mins. …”
Get full text
Proceeding Paper -
335
Capabilities of cermets tools for high speed machining of austenitic stainless steel
Published 2006“…In the present work cermet tools coated with titanium nitride were used to turn austenitic stainless steel at speeds between 300 and 700 m min-1. Feed rates were varied between 0.05 to 0.4 mm rev-1. …”
Get full text
Article -
336
Pembangunan video dokumentari pendidikan bagi mata pelajaran teknologi konkrit
Published 2004“…The data was analyzed using statistic method from Statistical Packages for Social Sciences (SPSS) version 11.0 which include percentages, min score and standard devition. Research result are positif that is the min score for each item from section B exceeding 3.8. …”
Get full text
Get full text
Get full text
Thesis -
337
Rare presentation of burholderia psedomallei infection
Published 2007Get full text
Proceeding Paper -
338
The production of carbon nanotubes using two-stage chemical vapor deposition and their potential use in protein purification
Published 2011“…The statistical analysis reveals that the optimum conditions for the CNT production were reaction temperature of 850 ◦C, reaction time of 60 min and gases flow rates of 40 and 150 ml/min for C2H2 and H2, respectively. …”
Get full text
Article -
339
Extraction of Algae Oil from Nannocloropsis sp.: A study of Soxhlet and Ultrasonic-Assisted Extractions
Published 2011“…While in the DE study, 51.6 min, 98% of ethanol concentration and 69.62°C were the best circwnstance in which the quantity of the oil yield got its maximwn. …”
Get full text
Article -
340
Inhalable and respirable dust from coal-fired power plant
Published 2015“…Coal-fired power plant emission had been recognized as one of the manmade sources of particulate matter. 8-hours personal particulate matter sampling had been done at a coal-fired power plant with 7-hole sampler at 2 L/min air flow and cyclone sampler at 2.2 L/min air flow. …”
Get full text
Article