-
2281
Comparison studies among the methods used in isolating the GSH from baker yeast
Published 2005“…Among the three methods, Autolysis method produced the highest GSH concentration of 49.263 μmol mLG1 (15.14 g LG1) followed by Homogenizer method (18.33 μmol mLG1 or 5.63 g LG1) which is slightly higher than that of the Ultrasonic method (18.13 μmol m L G 1 or 5.57 g L G 1). …”
Get full text
Article -
2282
Wideband Planar Array Antenna Based on SCRLH-TL for Airborne Synthetic Aperture Radar Application
Published 2018“…Maximum gain and radiation efficiency measured are 4.8 dBi and 79.5%, respectively, at 2.40 GHz. The antenna has a 3-dB axial-ratio bandwidth of 3.94 GHz from 144 MHz to 4.66 GHz. …”
Get full text
Article -
2283
Study on isolation improvement between closely packed patch antenna arrays based on fractal MTM-electromagnetic bandgap structures
Published 2018“…The proposed array covers the frequency range of 8-9.25 GHz for X-band applications, which corresponds to a fractional bandwidth of 14.5%. With the proposed method the edge-to-edge gap between adjacent antenna elements can be reduced to 0.5λ0 with no degradation in the antenna array’s radiation gain pattern. …”
Get full text
Article -
2284
Super-Wide Impedance Bandwidth Planar Antenna Based on Metamaterial Concept for Microwave and Millimetre-Wave Applications
Published 2019“…The results show that the proposed MPA is useful for various communications existing and emerging systems such as ultra-wideband (UWB) communications, RFID systems, massive multiple-output multiple-input (MIMO) for 5G, and radar systems.…”
Get full text
Article -
2285
High-Isolation Leaky-Wave Array Antenna Based on CRLH-Metamaterial Implemented on SIW with ±30o Frequency Beam-Scanning Capability at Millimetre-Waves
Published 2019“…Radiation gain in the backward (−30°), broadside (0°), and forward (+30°) directions are 8.5 dBi, 10.1 dBi, and 9.5 dBi, respectively. The decoupling slab is shown to have minimal effect on the array’s performance in terms of impedance bandwidth and radiation specifications. …”
Get full text
Article -
2286
Overcome the limitations of performance parameters of on-chip antennas based on metasurface and coupled feeding approaches for applications in system-on-chip for THz integrated-cir...
Published 2019“…The antenna exhibits a large impedance bandwidth of 60GHz from 0.5THz to 0.56THz with an average radiation gain and efficiency of 4.58dBi and 25.37%, respectively. …”
Get full text
Conference or Workshop Item -
2287
High‑isolation antenna array using SIW and realized with a graphene layer for sub‑terahertz wireless applications
Published 2021“…The dimensions of the array were 20 × 13.5 × 0.125 mm3. Metallization of the antenna was coated with 500 nm layer of Graphene. …”
Get full text
Article -
2288
Effect of small quantities of oxygen in a neon glow discharge
Published 2014“…A clear trend of cascading for neon ionic lines with excitation energies about ∼56 eV and ∼53 eV could be observed in neon–oxygen mixtures. …”
Article -
2289
Stryhnos potatorum and Pisum sativum as natural coagulant for meat food processing wastewater treatment: isotherm studies
Published 2023“…Sativum, the optimum condition was observed at pH 8 with the dosage of 150 mg/L and 150 rpm mixing rate with the removal of turbidity, TSS, COD, O&G, and color 87.8%, 97.3%, 65.5%, 77.9% and 76.5% respectively. The Langmuir model was found to be the best fit (R2 > 0.95) for TSS, O&G and color removal from MFPW in both coagulants, compared to the Freundlich model for both natural coagulants. …”
Get full text
Article -
2290
Dorsal Hand Vein Pattern Recognition: A Comparison between Manual and Automatic Segmentation Methods
Published 2023“…Results: We obtained a good test accuracy (91.5%) using the model trained with manually segmented images. …”
Get full text
Article -
2291
Stryhnos potatorum and Pisum sativum as natural coagulant for meat food processing wastewater treatment: isotherm studies
Published 2023“…Sativum, the optimum condition was observed at pH 8 with the dosage of 150 mg/L and 150 rpm mixing rate with the removal of turbidity, TSS, COD, O&G, and color 87.8%, 97.3%, 65.5%, 77.9% and 76.5% respectively. The Langmuir model was found to be the best fit (R2 > 0.95) for TSS, O&G and color removal from MFPW in both coagulants, compared to the Freundlich model for both natural coagulants. …”
Get full text
Article -
2292
Mechanical Properties of Bricks Containing Sago Fine Waste as Cement Replacement Material
Published 2024“…For this study, the brick specimens were prepared using 0%, 1%, 3%, 5%, 7% and 9% of SFW with a water-cement ratio of 0.6 fixed at 1:3 sand cement ratio. …”
Get full text
Article -
2293
Stryhnos potatorum and Pisum sativum as natural coagulant for meat food processing wastewater treatment: isotherm studies
Published 2022“…Sativum, the optimum condition was observed at pH 8 with the dosage of 150 mg/L and 150 rpm mixing rate with the removal of turbidity, TSS, COD, O&G, and color 87.8%, 97.3%, 65.5%, 77.9% and 76.5% respectively. The Langmuir model was found to be the best fit (R2 > 0.95) for TSS, O&G and color removal from MFPW in both coagulants, compared to the Freundlich model for both natural coagulants. …”
Get full text
Article -
2294
Dorsal Hand Vein Pattern Recognition: A Comparison between Manual and Automatic Segmentation Methods
Published 2023“…Results: We obtained a good test accuracy (91.5%) using the model trained with manually segmented images. …”
Get full text
Article -
2295
All-optical 2r regenerator based on self-phase modulation
Published 2020“…For NRZ-OOK, the maximum Q-factor before and after the regeneration stage are 3.751 and 5.859, respectively. The minimum bit error rate (BER) after the degradation stage is 10-5 and is further improved to 10-9 after the regeneration stage. …”
Get full text
Get full text
Get full text
Thesis -
2296
Enhanced tribological and mechanical properties of polybutylene terephthalate nanocomposites reinforced with synthetic wollastonite nanofibers/graphene oxide hybrid nanofillers
Published 2023“…The incorporation of 1 phr SWN and 1.5 phr GO exhibited the highest enhancement in Young’s modulus (16 %), crystallization temperature (5.7 ◦C), thermal stability (17.1 ◦C), wear resistance (43 %) and anti-friction properties (34 %) among the hybrid nanocomposites. …”
Get full text
Article -
2297
Life Cycle Cost and Evaluation of Performance between Steel Formwork and Plastic Formwork in Concrete Structure Building
Published 2024“…This research study aims to ease the process of selecting the suitable type of formwork by surveying 5 respondents in the related field of matter located in Malaysia on the two types of formworks and by evaluating their Life Cycle Cost (LCC). …”
Get full text
Article -
2298
Biomedical Analysis of Lateral Lumbar Interbody Fusion (LLIF) Cage for Lumbar Vertebrae
Published 2023“…The interbody cage was inserted between L4-L5, identified from CT scans utilizing MF. The model was analyzed in MF to assess the strength of the interbody cage, with the results compared to mechanical properties values obtained by applying compression load to simulate spinal movements. …”
Get full text
Article -
2299
An Ultra-Wideband Antenna with Triple Band-Notched Characteristics for Wearable Application
Published 2024“…This work presents a compact UWB antenna with triple band-notched at WiMAX (3.2 GHz to 3.7 GHz), C-band (3.7 GHz to 4.2 GHz) and WLAN (5.15 GHz to 5.35 GHz) for wearable applications. …”
Get full text
Article -
2300
The properties of sputtered copper oxide thin film for sensing application
Published 2015“…As for the substrate bias voltage, the ideal value was -40V base on the ion flux value obtained through Langmuir probe analysis. …”
Get full text
Get full text
Get full text
Thesis