-
501
Kesediaan tenaga pengajar UTHM dalam melaksanakan Program 2u2i (2 tahun universiti, 2 tahun industri)
Published 2019“…Secara keseluruhannya, hasil analisis data menunjukkan bahawa tahap kesediaan tenaga pengajar dalam aspek pengetahuan (min=2.83), kemahiran (min=3.43), sikap (min=3.53) dan sumber (min=3.13) adalah pada tahap yang sederhana. …”
Get full text
Get full text
Get full text
Thesis -
502
Pain intervention for failed conservative chronic pain treatment: The light at the end of the tunnel
Published 2011“…Oral analgesics are considered as first-line therapy where stronger analgesics are used when pain control is not optimised. …”
Get full text
Proceeding Paper -
503
Open data and right to information in Malaysia: a comparative analysis
Published 2019“…These jurisdictions and some others have long recognised freedom of information as basic constitutional right. …”
Get full text
Get full text
Proceeding Paper -
504
UWB pulse generation,shaping and analysis
Published 2011“…In TDR systemS the shon pulse generators are used 10 characterize long distant:e transmission lines and 10 detect open (or short) circuit faults cxisting over thc lines. …”
Get full text
Book Chapter -
505
The effect of weather on free space optics communication (FSO) under tropical weather conditions and a proposed setup for measurement
Published 2010“…The result of the evaluation can provide more knowledge on the feasibility of FSO deployment under tropical weather condition especially for a long range link.…”
Get full text
Proceeding Paper -
506
Financial development and economic growth: the experiences of selected OIC countries
Published 2013“…If financial development causes economic growth, this is in line with the “supply-leading” views, whereas if economic growth causes financial development, then it is suitable with the “demand-following” views. …”
Get full text
Proceeding Paper -
507
The role of prostate cancer microvesicles in epithelial mesenchymal transition
Published 2019“…Most carcinomas are derived from epithelial cell lines, which normally adhere together tightly to form the structural foundations of many organs. …”
Get full text
Thesis -
508
Substrate integrated waveguide cavity backed frequency reconfigurable antenna for cognitive radio applies to internet of things applications
Published 2019“…Reconfiguration of frequency bands is achieved using PIN diodes. The antenna resonated at 2.624, 2.664, 2.720, 2.752, 4.304, 4.532, 4.556, 5.236, 5.304, 5.368, 5.332, and 5.392 GHz. …”
Get full text
Article -
509
Optimization of the extraction process parameter to obtain highest anti-cancer activity from kenaf seeds
Published 2011“…Among these two parameters, temperature shows the highest impact on the percentage viability ofMCF-7 breast cancer cell line. All the oils were cytotoxic towards MCF-7 breast cancer cell line in dose dependent manner as detected using the SRB assay. …”
Get full text
Book Chapter -
510
The crystal structure and cytotoxicity of Centrosymmetric Copper(II) complex derived from S-methyldithiocarbazate with isatin
Published 2011“…Copper(II) complex of S-methyldithiocarbazate with isatin has been prepared and screened for their cytotoxic activities against MCF-7 (Human non-metastatic mammary gland adenocarcinoma cell line) and MDA-MB- 231 (Human metastatic mammary gland adenocarcinoma cell line). …”
Get full text
Article -
511
A study on removal characteristics of (Mn2+) from aqueous solution by CNT
Published 2009“…Different pHs are pH 6.0, pH 6.5, pH 7.0, pH 7.5 and pH 8.0, CNT dosages are 5mg, 6.25mg, 7.5mg, 8.75mg or 10mg, contact time are 10 min, 32.5 min, 55 min, 87.5 min and 120 min while the agitation speeds are 100rpm, 150rpm, 200rpm, 250rpm and 300rpm. …”
Get full text
Article -
512
The impact of intrapartum pethidine on the neonatal outcome. a prospective review
Published 2012“…All neonates delivered with good Apgar Score, 8 at 1 min and 9 at 5 min. A total of nine (22.5%) cases were admitted to the Neonatal Intensive Care Unit (NICU). …”
Get full text
Article -
513
Fabrication and characterisation of Cobalt Chromium Molybdenum (CoCrMo) foams using slurry method
Published 2018“…This was followed by the appropriate sintering temperature results which were 1000°C, 1100°C and 1200°C with heating rate of 1.5°C/min, 1.0°C/min and 0.5°C/min. Moreover, for the soaking time factor, the relevant durations were 60, 90 and 120 minutes. …”
Get full text
Get full text
Get full text
Thesis -
514
Physical, mechanical and environmental properties of fired clay bricks incorporated with palm oil mill waste
Published 2019“…However, lower heating rate (1°C/min) should be considered to attain excellent properties of brick. …”
Get full text
Get full text
Get full text
Thesis -
515
The effect of palm oil diesel fuel contaminated lubricant on sliding wear of cast irons against mild steel
Published 1996“…This was done on three types of cast iron, namely spheroidal graphite, flake graphite and chilled cast iron against a mild steel disc configuration using a pin-on-disc type of friction and wear apparatus. …”
Get full text
Article -
516
Virtual simulation and remote desktop interface for CNC milling operation
Published 2011“…Capability of remote operation is supported by an auto setup attachment with a reconfigurable pin type setup free technology installed on the table of CNC milling machine to perform unattended machining process. …”
Get full text
Article -
517
-
518
Enchancing RFID data quality and reliability using approximate filtering techniques
Published 2018“…Radio Frequency Identification (RFID) is an emerging auto-identification technology that uses radio waves to identify and track physical objects without the line of sight. While delivering significant improvements in various aspects, such as, stock management and inventory accuracy, there are serious data management issues that affect RFID data quality in preparing reliable solutions. …”
Get full text
Get full text
Get full text
Thesis -
519
Supercritical carbon dioxide extraction of bioactive flavonoid from strobilanthes crispus (Pecah kaca)
Published 2010“…The studied parameters were pressure (100, 150 and 200 bar), temperature (40, 50 and 60 ◦C) and dynamic extraction time (40, 60 and 80 min). The optimum extraction condition occurred at 200 bar, 50 ◦C and 60 min. …”
Get full text
Article -
520
Treatment of acidic palm oil for fatty acid methyl esters production
Published 2012“…The laboratory-scale experiments involved an MSA to ACPO dosage of 0.25–3.5 %, a molar ratio (methanol to ACPO) from 4: 1 to 20: 1, reaction temperature of 40–80°C, reaction time of 3–150 min, and stirrer speed of 100–500 min−1. The optimum esterification reaction conditions were 1 % of catalyst to ACPO, with a molar ratio of methanol to ACPO of 8: 1, a stirring speed of 300 min−1, for 30 min and at 60°C. …”
Get full text
Article