Showing 141 - 160 results of 1,239 for search '(((pinnau OR pinna) OR (line OR xingge)) OR ((min OR (sspingn OR (espinga OR sabina))) OR pin))', query time: 0.11s Refine Results
  1. 141
  2. 142
  3. 143
  4. 144

    Wear characteristics of Fe-C-Si and Fe-C-Al cast irons by Shaha, Sugrib Kumar, Haque, Md. Mohafizul, Khan, Ahsan Ali

    Published 2011
    “…Alumina ball of 3 mm diameter was used as pin, while the cast sample served as the disk. The tests were carried out at a normal load of 5.0 N and a sliding velocity of 250 mm/s for 30 min. …”
    Get full text
    Article
  5. 145

    A study of microwave induced plasmas by Burke, P. E.

    Published 1987
    “…Two 'analytical' MIP's incorporating sample aerosol introduction have been used with the slab-line cavity. One being supported on an argon flowrate of 0.1 1 min-1 using a Babing!…”
    Get full text
    Thesis
  6. 146
  7. 147

    In vitro growth of human keratinocytes and oral cancer cells into microtissues: an aerosol-based microencapsulation technique by Leong, Wai Yean, Soon, Chin Fhong, Wong, Soon Chuan, Tee, Kian Sek, Cheong, Sok Ching, Gan, Siew Hua, Youseffi, Mansour

    Published 2017
    “…In this paper, we proposed a growth of microtissue model for the human keratinocytes (HaCaT) cell line and an oral squamous cell carcinoma (OSCC) cell line (ORL-48) based on a simple aerosol microencapsulation technique. …”
    Get full text
    Article
  8. 148

    Development of switchable planar reflectors for beam shaping realization by Abbasi, Muhammad Inam

    Published 2016
    “…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
    Get full text
    Get full text
    Get full text
    Thesis
  9. 149

    Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test by Mohd Harun, Dalila

    Published 2020
    “…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
    Get full text
    Get full text
    Get full text
    Thesis
  10. 150

    Electrical breakdown and structural characterization in synthetic resins using optical techniques by Dodd, Stephen John

    Published 1992
    “…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
    Get full text
    Thesis
  11. 151

    Evaluation of classifiers in a pressure and latency-based typing biometric system by Moez Khan, Imran, ., Imama, Ushama, K. M., Aibinu, Abiodun Musa, Lai, Weng Kin

    Published 2011
    “…System authentication in present time relies on validation by some sort of a password or Personal Identification Number (PIN). However, if an intruder discovers this password or PIN, the user’s account can be easily compromised. …”
    Get full text
    Proceeding Paper
  12. 152

    An investigation of defect formation and growth in epoxy resin using light scattering methods by Perkins, Elaine Ann

    Published 1989
    “…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
    Get full text
    Thesis
  13. 153

    Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing by ISA, SITI RAHENA, JUSOH, MUZAMMIL, THENNARASAN SABAPATHY, THENNARASAN SABAPATHY, KAMARUDIN, MUHAMMAD RAMLEE, OSMAN, MOHAMED NASRUN, AKRAM ALOMAINY, AKRAM ALOMAINY

    Published 2023
    “…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
    Get full text
    Article
  14. 154
  15. 155

    Low-loss paper-substrate triple-band-frequency reconfigurable microstrip antenna for sub-7 GHz applications by Singh, Ajit Kumar, Mahto, Santosh Kumar, Sinha, Rashmi, Alibakhshikenari, Mohammad, Al-Gburi, Ahmed Jamal Abdullah, Ahmad, Ashfaq, Kouhalvandi, Lida, Virdee, Bal Singh, Dalarsson, Mariana

    Published 2023
    “…In this paper, a low-cost resin-coated commercial-photo-paper substrate is used to design a printed reconfigurable multiband antenna. The two PIN diodes are used mainly to redistribute the surface current that provides reconfigurable properties to the proposed antenna. …”
    Get full text
    Get full text
    Article
  16. 156
  17. 157

    On phase separation points for one-dimensional models by Ganikhodjaev, Nasir, Rozikov, Utkir Abdulloevich

    Published 2009
    “…In the paper, the one-dimensional model with nearest-neighbor interactions In, n ∈ Z, and the s pin values ±1 is considered. It is known that, under some conditions on parameters of In, a phase transition occurs for this model. …”
    Get full text
    Article
  18. 158

    Measurement and modelling of operational amplifier power supply rejection by Brinson, Mike, Faulkner, D. J.

    Published 1995
    “…Measured results for 741 and pin-compatible operational amplifiers are tabulated. …”
    Get full text
    Article
  19. 159

    Effect of poly(ethylene glycol) on the injectability, setting behavior and mechanical properties of calcium phosphate bone cement by Hablee, Sufiamie, Sopyan, Iis, Mel, Maizirwan, Mohd. Salleh, Hamzah, Rahman, Mujibur

    Published 2018
    “…Simen tanpa PEG mempunyai masa pengerasan awal daripada 3 min kepada 122 min dan masa pengerasan akhir daripada 5 min kepada 277 min. …”
    Get full text
    Get full text
    Get full text
    Article
  20. 160