-
101
-
102
A review on equipment protection and system protection relay in power system
Published 2017Get full text
Article -
103
Use, exposure and omics characterisation of potential hazard in nanomaterials
Published 2023Get full text
Article -
104
Use, exposure and omics characterisation of potential hazard in nanomaterials
Published 2023Get full text
Article -
105
-
106
-
107
-
108
-
109
Overview of Jute Fibre as Thermoplastic Matrix Polymer Reinforcement
Published 2024Get full text
Article -
110
-
111
Experimental investigation assessment of railway ground vibration: a case study in Kluang-Gemas, Kluang District, Johor, Malaysia
Published 2023“…A series of field measurements were accomplished in a straight line in Kluang City, southern Malaysia, using accelerometers and DEWESoft X2. …”
Get full text
Conference or Workshop Item -
112
Minutes of meeting. 2 February 1981
Published 1981“…Typewritten on a sheet of pink paper.…”
Get full text
Minutes -
113
-
114
Effect of adding global postural re-education to Kendall exercises for treating asymptomatic forward head posture: a single-blinded randomized controlled trial
Published 2025“…Conclusions: The added effect GPR technique to Kendall exercises significantly improved CVA, CROM, NDI, chest expansion, and spinal mobility in subjects with FHP.…”
Get full text
Article -
115
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
116
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
117
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
118
Biomedical Analysis of Lateral Lumbar Interbody Fusion (LLIF) Cage for Lumbar Vertebrae
Published 2023“…Objective: To develop the interbody cages implanted between the lumbar vertebrae by evaluating the strength of the bone model and the spinal cage. Materials and methods: In this study, finite element analysis (FEA) was applied using Mechanical Finder software (MF) to develop a 3D spine model lumbar vertebrae of the fourth and fifth lumbar vertebrae (L4 - L5) with various interbody cage designs, including honeycomb and rectilinear patterns with 50%, 70%, and 100% infill densities. …”
Get full text
Article -
119
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis -
120
Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing
Published 2023“…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
Get full text
Article