-
161
Development of remote operability CNC milling
Published 2010“…Attachment consists of three main equipments; material indexing device, Sub clamp with pin and vise index…”
Get full text
Proceeding Paper -
162
Evaluation of classifiers in a pressure and latency-based typing biometric system
Published 2011“…System authentication in present time relies on validation by some sort of a password or Personal Identification Number (PIN). However, if an intruder discovers this password or PIN, the user’s account can be easily compromised. …”
Get full text
Proceeding Paper -
163
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis -
164
Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing
Published 2023“…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
Get full text
Article -
165
The tribological behaviour of Fe-C-Al cast iron – effect of temperature
Published 2013“…Purpose - The aim of this paper is to study the tribological behaviour of Fe-C-Al cast iron at different temperatures using universal pin-on-disk machine. Design/methodology/approach - The cold set resin bonded sand mould casting process was employed to develop Fe-C-Al cast iron and Fe-C-Si cast iron. …”
Get full text
Article -
166
Wear characteristics of Fe-C-Si and Fe-C-Al cast irons
Published 2011“…In the present study, wear behavior of the Fe-C-Si and Fe-C-Al cast irons were investigated using a pin-on-disk type apparatus at room temperature. …”
Get full text
Article -
167
Low-loss paper-substrate triple-band-frequency reconfigurable microstrip antenna for sub-7 GHz applications
Published 2023“…In this paper, a low-cost resin-coated commercial-photo-paper substrate is used to design a printed reconfigurable multiband antenna. The two PIN diodes are used mainly to redistribute the surface current that provides reconfigurable properties to the proposed antenna. …”
Get full text
Get full text
Article -
168
Innovative UWB phase shifters using groove gap-waveguide technology inspired by metasurfaces for beamforming networks operating at 100 GHz
Published 2025“…The metasurface features a "bed-of-nails" structure, where metal pins are connected to a bottom layer and spaced <λ/4 from a top plate. …”
Get full text
Conference or Workshop Item -
169
A study of touching behavior for authentication in touch screen smart devices
Published 2016“…Due to increasing demand for safer access in touch screen mobile phones, old strategies like pins, tokens, or passwords have failed to stay abreast of the challenges. …”
Get full text
Get full text
Proceeding Paper -
170
Metamaterial based ultra-wideband antennas for portable wireless applications
Published 2017“…Various approaches have been reported to reduce the physical size of RF antennas including using high permittivity substrates, shorting pins, reactive components, and more recently, metamaterials (MTM) based on composite right-/left-handed transmission-lines (CRLH-TLs). …”
Get full text
Book Section -
171
Histopathological effects of Eurycoma Longifolia jack extract (tongkat ali) on the prostate of rats
Published 2013“…These dysplastic changes were equivalent to low grade prostatic intraepithelial neoplasia PIN. Conclusion: E.L. root extract can cause abnormal proliferation in the prostatic epithelium and these changes are dose dependant. …”
Get full text
Article -
172
Ballistic impact fracture behaviour of continuous fibre reinforced al-matrix composites
Published 2010“…The materials response under high energy impact loads was studied using a gas gun. The projectiles were pins 1.2-1.5 mm in diameter and weighing 0.347-0.435 g. …”
Get full text
Article -
173
Modeling of a turning tool holder with finite elements and simulation of its free vibration frequencies
Published 2012“…This latter difference is unavoidable, due to the experimental test setup whereby the tool holder is clamped within the fixture with only 2 pins as opposed to the more rigid boundary condition applied to the finite element model, whereby the whole holder length within the carriage is rigidly supported at the element nodes. …”
Get full text
Article -
174
On phase separation points for one-dimensional models
Published 2009“…In the paper, the one-dimensional model with nearest-neighbor interactions In, n ∈ Z, and the s pin values ±1 is considered. It is known that, under some conditions on parameters of In, a phase transition occurs for this model. …”
Get full text
Article -
175
Measurement and modelling of operational amplifier power supply rejection
Published 1995“…Measured results for 741 and pin-compatible operational amplifiers are tabulated. …”
Get full text
Article -
176
Distraction osteogenesis over intramedullary nail : a report of two cases
Published 2006“…The healing index was 19.5 days/cm and 14.8 days/cm respectively, compared favorably to 30 days/cm with traditional method of distraction osteogenesis. There were mild pin tract infections and joint stiffness which responded to non-operative treatment.…”
Get full text
Article -
177
Photonic controlled metasurface for intelligent antenna beam steering applications including 6G mobile communication systems
Published 2023“…This paper presents a novel metasurface antenna whose radiation characteristics can be remotely controlled by optical means using PIN photodiodes. The proposed reconfigurable antenna is implemented using a single radiating element to minimize the size and complexity. …”
Get full text
Get full text
Article -
178
Characterisation of surface texture using AFM with trimmed probe tip
Published 2006“…A comparison of the scanning results with analytical calculation showed that the trimmed tips were superior in imaging the profile for both the hole shaped and pin shaped microfeatures. But when using the trimmed high aspect ratio tip, the scanning speed was significantly low. …”
Get full text
Article -
179
Sensory-based colour sorting automated robotic cell
Published 2005“…The aim of this research work is to recognize colour by pin point detection and sorting of object specimens with respect to their colour attributes, which includes hue, saturation and luminance level. …”
Get full text
Article -
180
Design and Implementation of Active Antennas for IoT-Based Healthcare Monitoring System
Published 2024“…Two dual-band (2.4 GHz and 5.8 GHz) microstrip patch antennas, one with a PIN diode and one without, are fabricated using Rogers Duroid RO3003™ substrate. …”
Get full text
Article