-
61
-
62
-
63
-
64
-
65
-
66
-
67
-
68
-
69
-
70
A review on equipment protection and system protection relay in power system
Published 2017Get full text
Article -
71
Reliable power system operation plan: steady state contingency analysis
Published 2017Get full text
Article -
72
-
73
Fine recycled concrete aggregate as a material replacement in concrete production
Published 2020“…Construction and demolition waste is becoming a vital issue especially to the environmental aspect in many large cities in the world (Chen et al., 2002). Shen [1] describe C&D waste as the waste which generated from renovation, site clearing, demolition, construction, roadwork, land excavation and civil and building construction. …”
Get full text
Book Section -
74
-
75
High-gain metasurface in polyimide on-chip antenna based on CRLH-TL for sub-terahertz integrated circuits
Published 2020“…Concentric dielectric-rings are etched in the ground-plane under the radiation patches implemented on the top-layer. …”
Get full text
Get full text
Article -
76
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
77
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
78
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
79
EFRAG-European Commission Sustainability Standards & ISSB Standard-Setting Process (2022–2024)
Published 2025“…This dataset comprises meeting agendas, detailed discussion papers, summaries, and audio recordings of public webcasts related to the EFRAG-European Commission Sustainability Standards and the International Sustainability Standards Board (ISSB). It spans from the initial standard-setting efforts (March 2022 for EFRAG SRB, July 2022 for ISSB) to November 2024. …”
Get full text
Dataset -
80
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis