-
4781
Stryhnos potatorum and Pisum sativum as natural coagulant for meat food processing wastewater treatment: isotherm studies
Published 2023“…Sativum, the optimum condition was observed at pH 8 with the dosage of 150 mg/L and 150 rpm mixing rate with the removal of turbidity, TSS, COD, O&G, and color 87.8%, 97.3%, 65.5%, 77.9% and 76.5% respectively. The Langmuir model was found to be the best fit (R2 > 0.95) for TSS, O&G and color removal from MFPW in both coagulants, compared to the Freundlich model for both natural coagulants. …”
Get full text
Article -
4782
Mechanical Properties of Bricks Containing Sago Fine Waste as Cement Replacement Material
Published 2024“…For this study, the brick specimens were prepared using 0%, 1%, 3%, 5%, 7% and 9% of SFW with a water-cement ratio of 0.6 fixed at 1:3 sand cement ratio. …”
Get full text
Article -
4783
Stryhnos potatorum and Pisum sativum as natural coagulant for meat food processing wastewater treatment: isotherm studies
Published 2022“…Sativum, the optimum condition was observed at pH 8 with the dosage of 150 mg/L and 150 rpm mixing rate with the removal of turbidity, TSS, COD, O&G, and color 87.8%, 97.3%, 65.5%, 77.9% and 76.5% respectively. The Langmuir model was found to be the best fit (R2 > 0.95) for TSS, O&G and color removal from MFPW in both coagulants, compared to the Freundlich model for both natural coagulants. …”
Get full text
Article -
4784
Dorsal Hand Vein Pattern Recognition: A Comparison between Manual and Automatic Segmentation Methods
Published 2023“…Results: We obtained a good test accuracy (91.5%) using the model trained with manually segmented images. …”
Get full text
Article -
4785
All-optical 2r regenerator based on self-phase modulation
Published 2020“…For NRZ-OOK, the maximum Q-factor before and after the regeneration stage are 3.751 and 5.859, respectively. The minimum bit error rate (BER) after the degradation stage is 10-5 and is further improved to 10-9 after the regeneration stage. …”
Get full text
Get full text
Get full text
Thesis -
4786
Life Cycle Cost and Evaluation of Performance between Steel Formwork and Plastic Formwork in Concrete Structure Building
Published 2024“…This research study aims to ease the process of selecting the suitable type of formwork by surveying 5 respondents in the related field of matter located in Malaysia on the two types of formworks and by evaluating their Life Cycle Cost (LCC). …”
Get full text
Article -
4787
Biomedical Analysis of Lateral Lumbar Interbody Fusion (LLIF) Cage for Lumbar Vertebrae
Published 2023“…The interbody cage was inserted between L4-L5, identified from CT scans utilizing MF. The model was analyzed in MF to assess the strength of the interbody cage, with the results compared to mechanical properties values obtained by applying compression load to simulate spinal movements. …”
Get full text
Article -
4788
An Ultra-Wideband Antenna with Triple Band-Notched Characteristics for Wearable Application
Published 2024“…This work presents a compact UWB antenna with triple band-notched at WiMAX (3.2 GHz to 3.7 GHz), C-band (3.7 GHz to 4.2 GHz) and WLAN (5.15 GHz to 5.35 GHz) for wearable applications. …”
Get full text
Article -
4789
The properties of sputtered copper oxide thin film for sensing application
Published 2015“…As for the substrate bias voltage, the ideal value was -40V base on the ion flux value obtained through Langmuir probe analysis. …”
Get full text
Get full text
Get full text
Thesis -
4790
Design of microstrip ultra wide band antenna with two notch filters for wireless communication
Published 2015“…On the other hand, it rejects one or both WiMAX (3.13 – 3.7 GHz) and WLAN (5.15-5.85 GHz) frequency bands in the other three switching configurations. …”
Get full text
Get full text
Get full text
Thesis -
4791
Adaptive beamforming of steerable array monopole antenna for WLAN application
Published 2018“…Furthermore, the antenna gain is improved by 1.3 dBi that achieved a value of 5.3 dBi.The envelope-cross-correlation (ECC) shows magnitudes less than 0.5 among the elements. …”
Get full text
Get full text
Get full text
Thesis -
4792
Benefits of spark-ignition engine fuel-saving technologies under transient part load operations
Published 2017“…The results revealed stop-start system to be the most promising technology for the driving cycle at hand with 27.5% fuel consumption improvement over the baseline engine. …”
Get full text
Article -
4793
Experimental study on strength performance of soil reinforced with coconut fibre for PANCHOR–MUAR road
Published 2021“…The CBR value of the reinforced soil recorded a significant increase to 17.42% and 26.14% after being mixed with 0.5% and 1.0% CF proportions, compared with unreinforced soil (7.58%). …”
Get full text
Article -
4794
Engineering properties of asphalt binders containing nanoclay and chemical warm-mix asphalt additives
Published 2016“….% octadecylamine, and 0.5–5.0 wt.% aminopropyl-triethoxysilane), and chemical WMA additive (fatty polyamines polymer non-ionic component). …”
Get full text
Article -
4795
Engineering properties of asphalt binders containing nanoclay and chemical warm-mix asphalt additives
Published 2016“….% octadecylamine, and 0.5–5.0 wt.% aminopropyl-triethoxysilane), and chemical WMA additive (fatty polyamines polymer non-ionic component). …”
Get full text
Article -
4796
The effect of shielding, grounding and bonding to the electromagnetic compatibility of high emission printed circuit board
Published 2018“…Therefore the emission can be reduced an average 10.1 dB μV/m after grounding has been applied. The effect of two equipments without bonding can be useless because non-equipotential occurs. …”
Get full text
Get full text
Thesis -
4797
Design a photovoltaic system based on maximum power point tracking under partial shading
Published 2019“…The accurateness of this simulator is verified with PV module, the result is practiced during normal condition and under partial shading condition meanwhile, multiple curves of I-V and P-V will produce during normal condition and partial shading condition.…”
Get full text
Get full text
Get full text
Thesis -
4798
Development of a new single-phase field excitation flux switching motor topology with segmental rotor
Published 2016“…Finally, at the speed of 500 rpm and 3000 rpm, the back-EMF is 2.75 V and 16.13 V, respectively. The simulation results showed reasonable agreement with the experimental results, approximately difference range from 4.9% to 7.4%.…”
Get full text
Get full text
Get full text
Thesis -
4799
Effect of alkali treatment conditions optimization on kenaf fiber polyester composite characterization
Published 2016“…The selected treatment conditions are alkali solution concentration (2% w/v ~ 10% w/v), immersion duration (30 minute ~ 480 minute) and immersion temperature (room temperature ~ 100oC). …”
Get full text
Get full text
Get full text
Thesis -
4800
Corporate governance and voluntary disclosure in Malaysia
Published 2010“…The increase was statistically significant at the 5% level. However contrary to expectation, none of the corporate governance variables recommended in the Code was statistically significant.…”
Get full text
Article