Showing 301 - 320 results of 1,624 for search '(((spinae OR spingae) OR (line OR spine)) OR (pina OR pin))', query time: 0.19s Refine Results
  1. 301
  2. 302

    Living with fibrodysplasia ossificans progressiva: radiological images of a patient with extensive heterotopic ossification by Mohammed Mostafa Kotb, Omar, Usama Farghaly, Kaliya-Perumal, Arun-Kumar

    Published 2023
    “…Radiographic evaluation with X-rays and CT scans revealed scoliosis and total fusion of almost all levels of the spine, with only a few disc spaces spared. A large mass of heterotopic bone was observed, corresponding to the location of the paraspinal muscles in the lumbar region, branching upwards and fusing with the scapulae on both sides. …”
    Get full text
    Get full text
    Journal Article
  3. 303

    Finite element analysis on post-buckling of thin-walled structures using ANSYS by Theint, Yi Mon

    Published 2015
    “…The results obtained were checked against experimental data and led to the development and the revision of design procedures for the pin-ended lipped column and hollow box section.…”
    Get full text
    Final Year Project (FYP)
  4. 304

    Recovery of 3D shapes from 2D sketches by Liu, Yang

    Published 2013
    “…The objective of this research is to recover 3D freeform surfaces depicted in a single line drawing, with the aim of taking conceptual design sketches and converting them into 3D models. …”
    Get full text
    Thesis
  5. 305

    Exploring the B2C E-Commerce environment in Singapore. by Lee, Kian Chih., Phua, Mark Chin Chuen., Chang, Roy Ming Hon.

    Published 2008
    “…This research addresses: the profile of cyber-shoppers, the factors that encourage or discourage on-line shopping, the types of products and services that are popular on-line, the attitudes of consumers towards B2C E-Commerce and on-line shopping, and the current E-Commerce climate in Singapore.…”
    Get full text
    Final Year Project (FYP)
  6. 306

    Design and Implementation of Active Antennas for IoT-Based Healthcare Monitoring System by MUSA, UMAR, MOHD SHAH, SHAHARIL, A. MAJID, HUDA, AHMAD MAHADI, ISMAIL, A. RAHIM, MOHAMAD KAMAL, YAHYA, MUHAMMAD SANI, ZAINAL ABIDIN, ZUHAIRIAH

    Published 2024
    “…Two dual-band (2.4 GHz and 5.8 GHz) microstrip patch antennas, one with a PIN diode and one without, are fabricated using Rogers Duroid RO3003™ substrate. …”
    Get full text
    Article
  7. 307

    Design and Implementation of Active Antennas for IoT-Based Healthcare Monitoring System by MUSA, UMAR, MOHD SHAH, SHAHARIL, A. MAJID, HUDA, MAHADI, ISMAIL AHMAD, A. RAHIM, MOHAMAD KAMAL, YAHYA, MUHAMMAD SANI, ZAINAL ABIDIN, ZUHAIRIAH

    Published 2024
    “…Two dual-band (2.4 GHz and 5.8 GHz) microstrip patch antennas, one with a PIN diode and one without, are fabricated using Rogers Duroid RO3003™ substrate. …”
    Get full text
    Article
  8. 308

    Parametric study of gravure printing process for R2R printed electronics by Pua, Suan Tai

    Published 2017
    “…In this study, however, various printing parameters were investigated to establish their effects on printed line width and film thickness, in an attempt to achieve fine line printing resolution over a large printing area. …”
    Get full text
    Final Year Project (FYP)
  9. 309

    Advancements in Management Science: Applications to Online Retail, Healthcare, and Non-Profit Fundraising by Zhai, Chen Wen (Sabrina)

    Published 2024
    “…Studies on the efficacy of first-line versus second-line and alternative antibiotics for UTI are limited and dated. …”
    Get full text
    Thesis
  10. 310

    Identification and application of self-binding zipper-like sequences in SARS-CoV spike protein by Zhang, Si Min, Liao, Ying, Neo, Tuan Ling, Lu, Yanning, Liu, Ding Xiang, Vahlne, Anders, Tam, James Pingkwan

    Published 2020
    “…Self-binding peptides containing zipper-like sequences, such as the Leu/Ile zipper sequence within the coiled coil regions of proteins and the cross-β spine steric zippers within the amyloid-like fibrils, could bind to the protein-of-origin through homophilic sequence-specific zipper motifs. …”
    Get full text
    Journal Article
  11. 311

    Hearing loss and risk of major osteoporotic fracture: a population-based cohort study in the United Kingdom by Khalid, S, Alhambra, DP, Hasheminasab, SA, Vinogradova, Y, Qureshi, N, Ratzinger, M, Brunetti, V, Salas, A, Canals, L

    Published 2025
    “…Purpose: Assess association between hearing loss (HL) and major osteoporotic fracture (MOF; spine, wrist/forearm, shoulder/proximal humerus, hip) in individuals aged ≥ 60 years, and risk factors for MOF in individuals with HL. …”
    Journal article
  12. 312

    Design of a >500MHz current starving VCO/DLL with low phase noise for digital PWM control by Chua, Dillon Yu Ze

    Published 2023
    “…It typically consist of a voltage controlled delay line, a phase detector. A delay line consists of a chain of delay cells that can be varied to adjust the amount of delay between the output and input signal through the delay line. …”
    Get full text
    Final Year Project (FYP)
  13. 313

    Automated teller machines in Singapore by Soh, Yong Chee, Phua, Alice Loo Huay, Tan,Yang Leng

    Published 2015
    “…Activation of ATMs can also be enhanced by substituting the present A TM card and PIN system with either voice recognition, retina recognition or thumbprints. …”
    Get full text
    Final Year Project (FYP)
  14. 314

    Real time analysis of social behavior from video and kinect recordings by Ramasamy, Pandi Ramesh

    Published 2016
    “…Finally,analysis will be performed using pattern recognition algorithms and machine learning classifiers to detect the emotion of the subject.In this project,machine learning classifiers such as K-nearest neighbors,Naive Bayes and C4.5 Decision tree learning has been used. The prime aim is to pin point the most seemly machine learning classifier for obtaining highest accuracy for classification.…”
    Get full text
    Thesis
  15. 315

    Rapid process modeling of the aerosol jet printing based on gaussian process regression with latin hypercube sampling by Zhang, Haining, Moon, Seung Ki, Ngo, T. H., Tou, J., Bin Mohamed Yusoff, M. A.

    Published 2021
    “…Hence, it is necessary to develop a small data set based machine learning approach to model relationship between the process parameters and the line morphology. In this paper, we propose a rapid process modeling method for AJP process and consider sheath gas flow rate, carrier gas flow rate, stage speed as AJP process parameters, and line width and line roughness as the line morphology. …”
    Get full text
    Journal Article
  16. 316

    Recovery of three-dimensional objects from single two-dimensional sketches using cubic corners by Vishnuprasad Venugopalapanicker

    Published 2011
    “…This report describes the work done to recover 3D objects from a single 2D line drawing using theconcept of cubic corner. …”
    Get full text
    Final Year Project (FYP)
  17. 317

    The inference-boundary model reinterpreting theme and rheme by Leong, Ping Alvin

    Published 2013
    “…The Hallidayan notions of theme and rheme pose an interesting challenge to linguists in their attempts to pin them down more specifically. This paper argues that since the thematic structure of the clause organises it as a message, a useful starting point in theme–rheme research is an understanding of how clausal messages are typically processed by language users. …”
    Get full text
    Get full text
    Journal Article
  18. 318

    The effects of processing conditions on the morphology of single conjugated polymers. by Yeo, Hui Lin.

    Published 2010
    “…Drop-cast single chains were proposed to either retain its extended conformation in CHCl3 solution, or adopt an ordered structure with hair-pin loops, giving rise to two corresponding distinct types of intensity traces. …”
    Get full text
    Final Year Project (FYP)
  19. 319

    Experimental and numerical study of self-locking adaptable inter connection for modular steel structures by Nadeem, Gohar, Safiee, Nor Azizi, Bakar, Nabilah Abu, Karim, Izian Abd, Mohd Nasir, Noor Azline

    Published 2023
    “…The findings indicated that the gap produced between connection and column under higher displacement was sensitive to the outer bolt and spring pin. This gap could be further reduced by increasing the number of outer bolts and by reducing tolerance between adapter and column walls.…”
    Article
  20. 320

    Smart home control system design using internet of things based energy harvesting technology by Silalahi, Lukman Medriavin, Indrawan, Muhammad Rafi, Budiyanto, Setiyo, Hanafi, Dirman, Abdul Hamid, Abdul Hamid, Ronaldo, Davit

    Published 2024
    “…The objective of this research is to provide security for homeowners by facilitating fingerprints and PIN (Personal Identification Numbers) in entering the house, then in the event of a power outage, it activates the function of energy harvesting technology. …”
    Get full text
    Conference or Workshop Item