-
101
-
102
-
103
A review on equipment protection and system protection relay in power system
Published 2017Get full text
Article -
104
Use, exposure and omics characterisation of potential hazard in nanomaterials
Published 2023Get full text
Article -
105
Use, exposure and omics characterisation of potential hazard in nanomaterials
Published 2023Get full text
Article -
106
-
107
-
108
-
109
-
110
Overview of Jute Fibre as Thermoplastic Matrix Polymer Reinforcement
Published 2024Get full text
Article -
111
-
112
Experimental investigation assessment of railway ground vibration: a case study in Kluang-Gemas, Kluang District, Johor, Malaysia
Published 2023“…A series of field measurements were accomplished in a straight line in Kluang City, southern Malaysia, using accelerometers and DEWESoft X2. …”
Get full text
Conference or Workshop Item -
113
-
114
Ketekunan, kreativiti dan inovasidi kalangan pelajar UTHM
Published 2009“…Ujian korelasi di jalankan untuk mengetahui hubungan antara pencapaian prestasi pelajar dengan tahap tabiat minda (ketekunan, kreativiti dan inovasi) mereka dan hubungan antara lokasi tempat tinggal dengan tahap tabiat minda (ketekunan, kreativiti dan inovasi) mereka. …”
Get full text
Thesis -
115
Novel opto-electronic and plastic fibre sensors
Published 1998“…The middle POF is coupled to a red LED and emits light onto a flat target with the two outer fibres receiving the reflected light from the target and guiding it to two silicon PIN photodiodes. Theoretical investigations on the behaviour of the sensor are presented for ranges between 0 mm and 100 mm, and for targets with different reflectivities. …”
Get full text
Thesis -
116
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
117
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
118
Antivirals for broader coverage against human coronaviruses
Published 2024“…Spike is also not applicable for targeting other HCoVs as these are not well-conserved sequences among human CoVs. …”
Get full text
Article -
119
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
120
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis